Aluminium nitride

For the three-letter acronym, see ALN (disambiguation).
Aluminium nitride[1]
Names
Other names
Aluminium nitride
Identifiers
24304-00-5 YesY
ChEBI CHEBI:50884 YesY
ChemSpider 81668 YesY
EC Number 246-140-8
Jmol 3D model Interactive image
PubChem 90455
RTECS number BD1055000
Properties
AlN
Molar mass 40.9882 g/mol
Appearance white to pale-yellow solid
Density 3.260 g/cm3
Melting point 2,200 °C (3,990 °F; 2,470 K)
Boiling point 2,517 °C (4,563 °F; 2,790 K) decomposes
reacts (powder), insoluble (monocrystalline)
Solubility reacts in ethanol
Band gap 6.015 eV [2] (direct)
Electron mobility ~300 cm2/(V·s)
Thermal conductivity 285 W/(m·K)
1.9–2.2
Structure
Wurtzite
C6v4-P63mc
Tetrahedral
Thermochemistry
30.1 J/mol K
20.2 J/mol K
318 kJ/mol
287.4 kJ/mol
Hazards
NFPA 704
Flammability code 0: Will not burn. E.g., water Health code 1: Exposure would cause irritation but only minor residual injury. E.g., turpentine Reactivity code 0: Normally stable, even under fire exposure conditions, and is not reactive with water. E.g., liquid nitrogen Special hazards (white): no codeNFPA 704 four-colored diamond
0
1
0
Except where otherwise noted, data are given for materials in their standard state (at 25 °C [77 °F], 100 kPa).
YesY verify (what is YesYN ?)
Infobox references

Aluminium nitride (AlN) is a nitride of aluminium. Its wurtzite phase (w-AlN) is a wide band gap (6.01-6.05 eV at room temperature) semiconductor material, giving it potential application for deep ultraviolet optoelectronics.

History

AlN was first synthesized in 1877, but it was not until the middle of the 1980s that its potential for application in microelectronics was realized due to its relative high thermal conductivity for an electrical insulating ceramic (70–210 W·m−1·K−1 for polycrystalline material, and as high as 285 W·m−1·K−1 for single crystals).[3]

Stability and chemical properties

Aluminium nitride is stable at high temperatures in inert atmospheres and melts at 2800 °C. In a vacuum, AlN decomposes at ~1800 °C. In the air, surface oxidation occurs above 700 °C, and even at room temperature, surface oxide layers of 5-10 nm have been detected. This oxide layer protects the material up to 1370 °C. Above this temperature bulk oxidation occurs. Aluminium nitride is stable in hydrogen and carbon dioxide atmospheres up to 980 °C.[4]

The material dissolves slowly in mineral acids through grain boundary attack, and in strong alkalies through attack on the aluminium nitride grains. The material hydrolyzes slowly in water. Aluminium nitride is resistant to attack from most molten salts, including chlorides and cryolite.

Manufacture

AlN is synthesized by the carbothermal reduction of aluminium oxide or by direct nitridation of aluminium. The use of sintering aids, such as Y2O3 or CaO, and hot pressing is required to produce a dense technical grade material.

Applications

Epitaxially grown thin film crystalline aluminium nitride is used for surface acoustic wave sensors (SAWs) deposited on silicon wafers because of AlN's piezoelectric properties. One application is an RF filter which is widely used in mobile phones,[5] which is called a thin film bulk acoustic resonator (FBAR). This is a MEMS device that uses aluminium nitride sandwiched between two metal layers.[6]

Aluminium nitride is also used to build piezoelectric micromachined ultrasound transducers, which emit and receive ultrasound and which can be used for in-air rangefinding over distances of up to a meter.[7][8]

Metallization methods are available to allow AlN to be used in electronics applications similar to those of alumina and beryllium oxide. AlN nanotubes as inorganic quasi-one-dimensional nanotubes, which are isoelectronic with carbon nanotubes, have been suggested as chemical sensors for toxic gases.[9][10]

Currently there is much research into developing light-emitting diodes to operate in the ultraviolet using gallium nitride based semiconductors and, using the alloy aluminium gallium nitride, wavelengths as short as 250 nm have been achieved. In May 2006, an inefficient AlN LED emission at 210 nm was reported.[11]

There are also multiple research efforts in industry and academia to use aluminum nitride in piezoelectric MEMS applications. These include resonators, gyroscopes and microphones.[12][13]

Among the applications of AlN are

See also

References

  1. ↑ "Aluminium Nitride". Accuratus. Retrieved 2014-01-01.
  2. ↑ Feneberg, M.; Leute, R. A. R.; Neuschl, B.; Thonke, K.; Bickermann, M. (2010). Phys. Rev. B 82: 075208. doi:10.1103/physrevb.82.075208.
  3. ↑ "AlN - Aluminium Nitride". Ioffe Database. Sankt-Peterburg: FTI im. A. F. Ioffe, RAN. Retrieved 2014-01-01.
  4. ↑ L. I. Berger (1997). Semiconductor Materials. CRC Press. pp. 123–124. ISBN 0-8493-8912-7. Retrieved 2014-01-01.
  5. ↑ "Apple, Samsung Cellphone Filter Orders Lift Avago".
  6. ↑ "ACPF-7001: Agilent Technologies Announces FBAR Filter for U.S. PCS Band Mobile Phones and Data Cards". wirelessZONE. EN-Genius Network Ltd. 2002-05-27. Retrieved 2008-10-18.
  7. ↑ "A Gestural Interface for Smart Watches".
  8. ↑ Przybyla, R.; al, et (2014). "3D Ultrasonic Gesture Recognition". International Solid State Circuits Conference. San Francisco. pp. 210–211.
  9. ↑ Ahmadi, A; Hadipour, NL; Kamfiroozi, M; Bagheri, Z (2012). "Theoretical study of aluminium nitride nanotubes for chemical sensing of formaldehyde". Sensors and Actuators B: Chemical 161 (1): 1025–1029. doi:10.1016/j.snb.2011.12.001.
  10. ↑ Ahmadi Peyghan, A; Omidvar, A; Hadipour, NL; Bagheri, Z; Kamfiroozi, M (2012). "Can aluminum nitride nanotubes detect the toxic NH3 molecules?". Physica E 44: 1357–1360. doi:10.1016/j.physe.2012.02.018.
  11. ↑ Y. Taniyasu; et al. (2006). "An Aluminium Nitride Light-Emitting Diode with a Wavelength of 210 Nanometres". Nature 441 (7091): 325–328. doi:10.1038/nature04760. PMID 16710416.
  12. ↑ http://www.sand9.com
  13. ↑ http://www.vespermems.com

External links

This article is issued from Wikipedia - version of the Monday, May 02, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.