Antiplane shear

Antiplane shear or antiplane strain^[1] is a special state of strain in a body. This state of strain is achieved when the displacements in the body are zero in the plane of interest but nonzero in the direction perpendicular to the plane. For small strains, the strain tensor under antiplane shear can be written as

\boldsymbol{\varepsilon} = \begin{bmatrix} 0 & 0 & \epsilon_{13} \\ 0 & 0 & \epsilon_{23}\\ \epsilon_{13} & \epsilon_{23} & 0\end{bmatrix}

where the $12\,$ plane is the plane of interest and the $3\,$ direction is perpendicular to that plane.

Displacements

The displacement field that leads to a state of antiplane shear is (in rectangular Cartesian coordinates)

u_1 = u_2 = 0 ~;~~ u_3 = \hat{u}_3(x_1, x_2)

where $u_i,~ i=1,2,3$ are the displacements in the $x_1, x_2, x_3\,$ directions.

Stresses

For an isotropic, linear elastic material, the stress tensor that results from a state of antiplane shear can be expressed as

\boldsymbol{\sigma} \equiv \begin{bmatrix} \sigma_{11} & \sigma_{12} & \sigma_{13} \\ \sigma_{12} & \sigma_{22} & \sigma_{23} \\ \sigma_{13} & \sigma_{23} & \sigma_{33} \end{bmatrix} = \begin{bmatrix} 0 & 0 & \mu~\cfrac{\partial u_3}{\partial x_1} \\ 0 & 0 & \mu~\cfrac{\partial u_3}{\partial x_2} \\ \mu~\cfrac{\partial u_3}{\partial x_1} & \mu~\cfrac{\partial u_3}{\partial x_2} & 0 \end{bmatrix}

where $\mu\,$ is the shear modulus of the material.

Equilibrium equation for antiplane shear

The conservation of linear momentum in the absence of inertial forces takes the form of the equilibrium equation. For general states of stress there are three equilibrium equations. However, for antiplane shear, with the assumption that body forces in the 1 and 2 directions are 0, these reduce to one equilibrium equation which is expressed as

\mu~\nabla^2 u_3 + b_3(x_1, x_2) = 0

where $b_3$ is the body force in the $x_3$ direction and $\nabla^2 u_3 = \cfrac{\partial^2 u_3}{\partial x_1^2} + \cfrac{\partial^2 u_3}{\partial x_2^2}$ . Note that this equation is valid only for infinitesimal strains.

Applications

The antiplane shear assumption is used to determine the stresses and displacements due to a screw dislocation.

References

↑ W. S. Slaughter, 2002, The Linearized Theory of Elasticity, Birkhauser