Autoignition temperature

The autoignition temperature or kindling point of a substance is the lowest temperature at which it will spontaneously ignite in normal atmosphere without an external source of ignition, such as a flame or spark. This temperature is required to supply the activation energy needed for combustion. The temperature at which a chemical will ignite decreases as the pressure or oxygen concentration increases. It is usually applied to a combustible fuel mixture.

Autoignition temperatures of liquid chemicals are typically measured using a 500 mL flask placed in a temperature controlled oven in accordance with the procedure described in ASTM E659.[1]

When measured for plastics, autoignition temperature can also be measured under elevated pressure and at 100% oxygen concentration. The resulting value is used as a predictor of viability for high-oxygen service. The main testing standard for this is ASTM G72.[2]

Autoignition equation

The time t_{ig}\, it takes for a material to reach its autoignition temperature T_{ig}\, when exposed to a heat flux q''\, is given by the following equation

t_{ig} = \left ( \frac{\pi}{4} \right ) \left (k \rho c \right )\left [ \frac{T_{ig}-T_{o}}{q''} \right]^2 [3]

where k = thermal conductivity (W/(m·K)), ρ = density (kg/m³), and c = specific heat capacity (J/(kg·K)) of the material of interest. T_{o}\, is the temperature, in Kelvin, the material starts at (or the temperature of the bulk material), and q''\, is the heat flux (W/m²) incident to the material.

Autoignition point of selected substances

Temperatures vary widely in the literature and should only be used as estimates. Factors which may cause variation include partial pressure of oxygen, altitude, humidity, and amount of time required for ignition. Generally the autoignition temperature for hydrocarbon/air mixtures increases with increasing molecular weight and increasing chain length. The autoignition temperature is also higher for branched-chain hydrocarbons than for straight-chain hydrocarbons.[4]

Substance Autoignition[5] Note
Triethylborane −20 °C (−4 °F) [6]
Silane 21 °C (70 °F) [6] or below
White phosphorus 34 °C (93 °F) [6] on contact with an organic substance, melts otherwise
Carbon disulfide 90 °C (194 °F) [6]
Diethyl ether 160 °C (320 °F) [7]
Gasoline (Petrol) 247–280 °C (477–536 °F) [6]
Ethanol 363 °C (685 °F) [6]
Diesel or Jet A-1 210 °C (410 °F) [8] or below
Butane 405 °C (761 °F) [9]
Paper 218–246 °C (424–475 °F) [8][10]
Leather / Parchment 200–212 °C (392–414 °F) [8][11]
Magnesium 473 °C (883 °F) [6]
Hydrogen 536 °C (997 °F) [12]

For paper, there is considerable variation between sources, mainly because there are many physical variables over different kinds of paper, like thickness, density and composition; in addition, it takes longer for the combustion of paper to start at lower temperatures.[13] Ray Bradbury named his novel Fahrenheit 451 for the autoignition temperature of paper;[14][15] the value chosen lies in the mid-range of reported values.

See also

References

  1. ↑ E659 – 78 (Reapproved 2000), "Standard Test Method for Autoignition Temperature of Liquid Chemicals", ASTM, 100 Barr Harbor Drive, West Conshohocken, PA 19428-2959
  2. ↑ S. Grynko, "Material Properties Explained" (2012), ISBN 1-4700-7991-7, p. 46.
  3. ↑ Principles of Fire Behavior. ISBN 0-8273-7732-0. 1998.
  4. ↑ Zabetakis, M.G. (1965), Flammability characteristics of combustible gases and vapours, U.S. Department of Mines, Bulletin 627.
  5. ↑ Under standard conditions for pressure.
  6. 1 2 3 4 5 6 7 Fuels and Chemicals - Autoignition Temperatures, engineeringtoolbox.com
  7. ↑ "Diethyl Ether - Safety Properties". Wolfram|Alpha.
  8. 1 2 3 Cafe, Tony. "PHYSICAL CONSTANTS FOR INVESTIGATORS". tcforensic.com.au. TC Forensic P/L. Retrieved 11 February 2015.
  9. ↑ "Butane - Safety Properties". Wolfram|Alpha.
  10. ↑ Tony Cafe. "Physical Constants for Investigators". Journal of Australian Fire Investigators. (Reproduced from "Firepoint" magazine)
  11. ↑ "Flammability and flame retardancy of leather". leathermag.com. Leather International / Global Trade Media. Retrieved 11 February 2015.
  12. ↑ "Hydrogen - Safety Properties". Wolfram|Alpha.
  13. ↑ Forest Products Laboratory (1964). "Ignition and charring temperatures of wood" (PDF). Forest Service U. S. Department of Agriculture.
  14. ↑ Brian Palmer (June 8, 2012). "Does Paper Really Burn at 451 Degrees Fahrenheit?". Slate. Retrieved March 3, 2016.
  15. ↑ Jakub Dutka (May 19, 2014). "Book as a reflexive medium: the materiality in post-digital print". MA Media Studies, University of Amsterdam. Retrieved March 3, 2016.

External links

This article is issued from Wikipedia - version of the Thursday, May 05, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.