Bandwidth extension

Bandwidth extension of signal is defined as the deliberate process of expanding the frequency range (bandwidth) of a signal in which it contains an appreciable and useful content, and/or the frequency range in which its effects are such. Its significant advancement in recent years has led to the technology being adopted commercially in several areas including psychacoustic bass enhancement of small loudspeakers and the high frequency enhancement of coded speech and audio.

Bandwidth extension has been used in both speech and audio compression applications. The algorithms used in G.729.1 and Spectral Band Replication (SBR) are two of many examples of bandwidth extension algorithms currently in use. In these methods, the low band of the spectrum is encoded using an existing codec, whereas the high band is coarsely parameterized using fewer parameters. Many of these bandwidth extension algorithms make use of the correlation between the low band and the high band in order to predict the wider band signal from extracted lower-band features. Others encode the high band using very few bits. This is often sufficient since the ear is less sensitive to distortions in the high band compared to the low band.

Bass enhancement of small loudspeakers

Most often small loudspeakers are physically incapable of reproducing low frequency material. Using a psycho-acoustical phenomenon like the missing fundamental, perception of low frequencies can be greatly increased. By generating harmonics of lower frequencies and removing the lower frequencies themselves the suggestion is created that these frequencies are still remaining in the signal. This process is usually applied through external equipment or embedded in the speaker system using a digital signal processor.

High frequency response can also be enhanced through generation of harmonics. Instead of mapping frequencies inside the reproducible region of the speaker, the speaker itself is used to generate frequencies outside the normal reproducible region. By boosting high frequencies and overdriving the speaker or amplifier slightly, higher harmonics can be generated.

Bandwidth extension of speech in telephone systems

Telephone speech signals are usually very degraded in quality. Part of this degradation is due to the limited bandwidth used in the telephone systems. In most systems frequencies lower than 250 Hz are cut and bandwidth only extends to frequencies of 4 or 8 kHz. Using filtering and waveshaping low and high frequency response can be extended.

By low pass filtering the lowest octave and half-wave rectifying a waveform is created with a fundamental half of the original frequency. Due to the discontinuity in the waveform low pass filtering is needed to filter all harmonics. Using such a subharmonic synthesizer the essential frequency band between 125 - 250 Hz is recreated, adding weight to the signal.

To extend the high frequency bandwidth, we can isolate the top octave using high pass filtering and then generating harmonics of this. The generation of harmonics can be done through a simple full wave rectification, which is computationally cheap and not amplitude-dependent. As an alternative single-sideband modulation can be used, giving precise control over the number and amplitude of the harmonics. In theory envelope estimation can be used to extract the original high frequency envelope and regenerating high frequencies using a noise source. The sparse information available in the small bandwidth will probably be too limited to extract a proper envelope.

Bandwidth extension of audio

Spectral band replication (SBR) is a new technique that has gained popularity as an “add-on” to popular perceptual audio codecs such as MP-3 and the Advanced Audio Coding (AAC). New audio coders consisting of a marriage between SBR and the conventional audio coders have been formed, namely the MP3Pro and AAC+. In these algorithms, the lower spectrum is encoded using either MP-3 or AAC, whereas the high band is encoded using SBR. The key to the SBR algorithm is the information used to describe the high frequency portion of the signal. The primary design goal of this algorithm is to reconstruct the high band spectrum without introducing any aliasing artifacts and to provide good spectral and time resolution. A 64-band complex-valued polyphase filterbank is used at the analysis portion. At the encoder, the filterbank is used to obtain energy samples of the original input signal's high band. These energy samples are then used as reference values for the envelope adjustment scheme used at the decoder.

References

This article is issued from Wikipedia - version of the Wednesday, July 17, 2013. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.