Bock 1

Bock 1
Role Glider
National origin United States
Designer John W. Bock
First flight 1960
Introduction 1960
Status Production completed
Number built One


The Bock 1 is an American high-wing, strut-braced single-seat glider that was designed by John W. Bock of Long Beach, California.[1][2]

Design and development

Bock started design of the Bock 1 in the mid-1950s, the work taking him many years to complete. His prototype first flew in 1960.[1][2]

The aircraft is constructed predominately from aluminium with some surfaces finished with doped aircraft fabric covering. The wing is a constant-chord design with a single strut and end-plates. The 34 ft (10.4 m) wing employs a NACA 63(3)-618 laminar flow airfoil. The landing gear is a monowheel arrangement.[1]

Only the prototype was ever completed.[1]

Operational history

By 1973 the prototype had flown over 300 hours, including a flight of 7:50 and another flight to 17,100 ft (5,212 m) altitude.[1]

In 1983 it was reported that the prototype had not flown in ten years, was permanently stored and required restoration. In May 2011 it was still registered with the Federal Aviation Administration to the designer.[1][2]

Specifications (Bock 1)

Data from Soaring[1]

General characteristics

Performance

See also


References

  1. 1 2 3 4 5 6 7 Said, Bob: 1983 Sailplane Directory, Soaring Magazine, page 37. Soaring Society of America November 1983. USPS 499-920
  2. 1 2 3 Federal Aviation Administration (May 2011). "Make / Model Inquiry Results". Retrieved 3 May 2011.


This article is issued from Wikipedia - version of the Tuesday, June 23, 2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.