Bridge-tied load

A bridge-tied load (BTL), also known as bridged transformerless and bridged mono, is an output configuration for audio amplifiers, a form of impedance bridging used mainly in professional audio & car applications.[1] The two channels of a stereo amplifier are fed the same monaural audio signal, with one channel's electrical polarity reversed. A loudspeaker is connected between the two amplifier outputs, bridging the output terminals. This doubles the available voltage swing at the load compared with the same amplifier used without bridging. The configuration is most often used for subwoofers.[2]

Power output

The available voltage swing across the load is doubled for the same power supply voltage, but the maximum current output ability of the amplifier remains the same. Consequently operating a pair of existing amplifier channels in bridge mode doubles available power output to the load.[3] The BTL load needs to be twice the impedance since it sees twice the voltage at the same current.

Impedance

Driving the load between two signals of opposite electrical polarity (often incorrectly called antiphase, or 180° out of phase - one signal is inverted, there is no phase change) makes each amplifier see only half the load's electrical impedance.[4]

Benefits and drawbacks

Since two amplifiers are being used in opposite polarity, using the same power supply, there is no need for the use of a DC blocking capacitor between the amplifier and the load. This saves cost & space, and there is no power reduction at low frequency due to the capacitor.[5]

Bridging an amplifier increases the power that can be supplied to one loudspeaker, but it does not increase the amplifier's total available power. Because a bridge amplifier operates in mono mode, a second identical amplifier is required for stereo operation. For bridged amplifiers, damping factor is cut in half. Because the amplifier's bridged output is floating, it should never be grounded or it may damage the amplifier.[3]

Uses

This output configuration is useful in applications where battery size dictates a lower supply voltage, e.g., automotive or handheld applications.

See also

References

  1. ↑ Eiche, Jon F. (1990). Guide to Sound Systems for Worship. Recording and Audio Technology. Hal Leonard Corporation. p. 87. ISBN 0-7935-0029-X.
  2. ↑ "Stereo, Parallel, and Bridge Mono". Amp Guide. DirectProAudio. Retrieved September 28, 2011.
  3. 1 2 Bartlett, Bruce (May 1, 2010). "Amplifier Power Master Class: Not All Ratings Are Similar". ProSoundWeb. Retrieved September 28, 2011.
  4. ↑ Roberts, Joe (2007). "Audio Power Amplifier Fundamentals". Joe's Tech Notes. Retrieved September 28, 2011.
  5. ↑ Self, Douglas (2009). Audio Power Amplifier Design Handbook (5 ed.). Focal Press. p. 367. ISBN 0-240-52162-5.
This article is issued from Wikipedia - version of the Tuesday, February 23, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.