Helitack

Helitack refers to "helicopter-delivered fire resources",[1] and is the system of managing and using helicopters and their crews to perform aerial firefighting and other firefighting duties, primarily initial attack on wildfires.[2] Helitack crews are used to attack a wildfire and gain early control of it, especially when inaccessibility would make it difficult or impossible for ground crews to respond in the same amount of time.

Terminology

Helitack

The term helitack first appeared in a 1956 Los Angeles Times article, which described the "first of a series of tests—tabbed the Helitack Program—on the use of helicopters in firefighting will start next week in the San Bernardino National Forest". The word itself is a portmanteau of "helicopter" and "attack".[3]

Helibase

The incident Helibase is the location from which incident helicopter support missions are flown, and where the helicopters assigned to that base are parked, serviced, and refueled. Usually a helibase is in a field location that is close enough to the Incident Base Camp so that supplies and personnel can be ferried by ground to the helibase from the camp in a timely manner. More remote helibases (i.e., nearer the fire) can be established to maximize efficiency and reduce flight costs. Occasionally, helibases are located at a nearby airport or backcountry airstrip. The name of the base is designated by the name of the incident, though on large fires there can be multiple helibases. Helibases are staffed with a Helibase Manager, Deck Coordinator, Landing and Takeoff Coordinator, Radio Operator, and numerous subsidiary positions operating in a Helibase Operations trailer or out on the landing pads. Crash rescue capability is usually assigned to the larger helibases. An "H" in a circle designates a helibase on an incident map.[4]

A Carson Helicopters S-61N Fire King being fueled during firefighting operations in Southern River, Western Australia

Helispot

A Helispot is a location near a fire where it is safe for helicopters to land and take off. At this designated location, a helispot manager and usually a few helitack crewmembers will be onsite to coordinate landings and take-offs as well as the manifesting, loading and unloading of equipment and personnel. Helispots are temporarily located as the incident grows and can be found on ridges, meadows, parking lots – in short, any clearing suitable and meeting rotor clearance and hazard (wires, trees, etc.) avoidance requirements. Helispots are found on the incident map by filled in circles with the letters H-# next to it, the # designating what number it is.[4]

Drop point

A Helicopter drop point, or drop point is similar to a helispot, but used for depositing, often via longline, and caching supplies. Helicopters and supply vehicles use the drop point to off-load supplies at the edge of an incident for the ground teams to come by and pick up. Drop points may be located all around the fire. Wildland firefighters will usually pick up sharpened tools, pumps and hoses, water, food, radio batteries, etc. at the drop points. On an incident map, the symbol for a drop point is a filled dot with the letters D-# next to them with the # designating which number is it.[4]

Methodology

A helitack helicopter will launch with a crew on board, drop them in the vicinity of the fire (or "incident") where they will begin clearing a firebreak with standard hand tools, while the helicopter can then support the team with water drops, either with a Bambi bucket or airframe-mounted water tanks, or ferry in additional personnel (e.g., hotshot crews). If the fire continues to grow beyond the initial attack phase, the mission of the helitack crew shifts to a support role, locating and operating at helispots and helibases, where the coordination of the support required for other firefighting helicopters.[5]

In a situation where terrain or vegetation height make it impossible for a helicopter to land, helitack methodology can also employ rappellers, rappelling from a helicopter as high as 250 feet above the ground[5] or deplaning crews from a hovering helicopter (heli-jumping).

When backfires, or "prescribed burns" are needed in remote areas, helitack helicopters can be used to start them, using a "helitorch", a driptorch suspended on a cable under the helicopter, or by dropping plastic sphere dispenser (PSD) ignition devices.[2]

In the event that a firefighter on the ground is injured, the helitack helicopter is used to evacuate the victim to a medical facility.[2]

History

Helicopters were used in combating wildfires in California as early as 1947 and their usefulness at moving personnel rapidly around a fire was quickly recognized. Initially, helicopters were just used for tactical and logistical support for ground crews.[2]

In 1957 the Los Angeles County Fire Department experimentally used a Bell 47 to lay hoses using belly mounted trays.[6]

The first water bucket was probably developed by Jim Grady of Okanagan Helicopters working with Henry Stevenson, who owned a machine shop in Nelson, British Columbia. Development began in the mid-1950s and the "Monsoon Bucket" was operational in 1962. The bucket was a converted 45- imperial-gallon (205 L) drum with a trap door in the bottom that was actuated by the pilot in flight.[7]

In the early 1960s the California Division of Forestry (now known as CALFIRE) began water bucketing trials. Testing was also done on a 105-U.S.-gallon (400 L) water tank mounted on a Bell 47. US federal agencies, such as the BLM and the USFS also began contracting commercial helicopter services to assist in fighting wildfires on lands they were responsible for in the early 1960s.[6]

The California Department of Forestry began experimenting with helitack as a doctrinal concept in 1960, when a crew of three firefighters was deployed on an Alouette III helicopter.

Crews

Crew sizes vary from base to base and agency to agency.

Helitack crews are often considered to be elite members of the firefighting community, partly because of the experience levels required to qualify as a crew member. CDF Captain Jim Barthol, in an interview with the San Diego Union-Tribune, used the analogy of runners in a race to compare helitack with other handcrews. He said that "ground-based hand crews are marathon runners, while helitack crews work more like sprinters. Other hand crews might spend three days or more fighting a fire, we might work three different incidents in one day. It doesn't necessarily make us better than those other guys. It just makes us different."

Much of the helitack crews' training centers on helicopter safety, as the crews typically load and unload with the rotors turning, and sometimes in very rough terrain, where only the skid on one side can be touched down.[5]

Equipment

State Emergency Service of Ukraine (MChS) Mil Mi-8MTV picking up water near Nezhin
A Bell 212 with a helicopter bucket
S-64 Skycrane

Helicopters used for helitack missions are usually utility helicopters, selected for both their lifting capability as well as their large cabin size to accommodate the helitack crew.

Some of the most common helicopter types are variants of the venerable UH-1 Huey, known in the civilian world as the Bell 205, especially upgraded variants such as the 205A++ and the 210. The twin-engine Bell 212 is also popular. Other helicopters such as the Sikorsky S-58 are also used, and the S-70 Firehawk, a civilian version of the military's UH-60 Blackhawk, is now being operated by two agencies in the U.S.

Smaller helicopters, such as the Bell 206 JetRanger and AS350 Astar are sometimes used for precision water drops to protect specific structures, such as cabins or homes.

Larger water dropping helicopters such as the S-64 Skycrane, which can hold as much as 3,000 gallons, rivaling fixed-wing airtankers, are increasingly being used. Only some of these larger rotorcraft have provisions for carrying ground crews, therefore may not always considered "helitack" aircraft in the true sense of the word. Some Type I rotorcraft, such as the Boeing 234, can carry up to 44 passengers in proper configuration.[8]

Water tanks are often permanently or semi-permanently mounted under the helicopter's belly, which can either be filled at a helispot via a hose from a fire engine, or with a "snorkel", a long hose with a water pump in its end that can suck water out of a lake or small tank set up by fire crews.[5]

The helitack crews use the same tools on the fire lines as other ground crews do, including chain saws, axes, shovels and a specialized, two-headed cutting tool known as a Pulaski.

US classification system

In the U.S., helitack helicopters are designated by "type", as defined by the Interagency Helicopter Operations Guide, based on their capacities:[9]

Type I II III
Allowable payload, standard conditions 5,000 lb 2,500 lb 1,200 lb
Passenger seats 15+ 9–14 4–8
Water/retardant 700 U.S. gallons 300 U.S. gallons 100 U.S. gallons
Max takeoff/landing weights 12,501+ lb 6,000–12,500 lb less than 6,000 lb

Canadian classification system

Since forest protection is a provincial responsibility in Canada each province has its own system for classifying helicopters for contract use, setting equipment standards and for employing them.

A typical system is the one that was in use by Manitoba in 1996. The then-named Manitoba Department of Natural Resources established a stand-by system for all aircraft contracted for forest fire protection missions. This consisted of five levels of readiness, depending on the fire forecast and the time of day:

At that time the Manitoba Department of Natural Resources classified contract helicopters in two classifications:

The province also sets equipment standards for these contract helicopters, which are similar to others used across Canada:

Medium-lift helicopter

Light-lift helicopter

Incidents

Images

See also

References

  1. ↑ "Fire Program Analysis – Initial Response Module: Helitack Deployment", Fire Program Analysis, National Interagency Fire Center
  2. 1 2 3 4 U.S. Forest Service glossary
  3. ↑ "Fire-Fighting Copter Tests Start in Forest", Los Angeles Times, June 10, 1956, page A23, cited at the Double-Tongued Dictionary, accessed October 15, 2007
  4. 1 2 3 NIMS 3.04
  5. 1 2 3 4 5 Gross, Gregory A. "Elite, mobile fire crew might soon be permanent here", San Diego Union-Tribune, November 16, 2004, accessed October 15, 2007
  6. 1 2 Smith, Barry D.: Fire Bombers in Action, pages 51–71. Motorbooks International Publishers, 1995. ISBN 0-7603-0043-7
  7. ↑ Corley-Smith, Peter and David N. Parker: Helicopters in the High Country – 40 Years of Mountain Flying, page 50. Sono Nis Press, Victoria BC, 1995. ISBN 1-55039-061-9
  8. ↑ Aircraft Search Results
  9. ↑ Interagency Helicopter Operations Guide, March 2006, Chapter 6
  10. ↑ Manitoba Department of Natural Resources, Operations Division, Fire Program: Pilot Briefing Handbook MG-2261 (rev 3.96), page 23. Government of Manitoba, 1996
  11. 1 2 Manitoba Department of Natural Resources, Operations Division, Fire Program: Pilot Briefing Handbook MG-2261 (rev 3.96), page 33. Government of Manitoba, 1996
  12. ↑ "Fire Behavior Associated with the 1994 South Canyon Fire on Storm King Mountain, Colorado", U.S. Department of Agriculture

External links

This article is issued from Wikipedia - version of the Monday, September 21, 2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.