Interrupted screw
An interrupted screw or interrupted thread is a mechanical device typically used in the breech of artillery guns. It is believed to have been invented in 1845.[1]
It is a screw that has a section of thread along its axis removed. The screw is mated with a partially threaded hole at the rear of the weapon's chamber: where the screw has threads the hole has none, and vice versa. The screw can thus be smoothly inserted all the way into the gun, after which as little as one-sixth of a turn can engage the two sets of threads securely, sealing the breech. Interrupted screws are occasionally seen in loose gunpowder rifles, as this mechanism was historically one of the few practical ways to achieve a gas-proof seal with a breech-loading firearm that does not employ cartridges. An earlier method was the use of a wedge to block the rear of the gun.[1]
Sealing was further improved with the de Bange obturator in 1872, and all interrupted screw breeches with this system were generally known as the De Bange type.
The major weakness of the original designs was that only half of the circumference of the breechblock could be threaded, hence a fairly long breechblock was still required to achieve a secure lock. Axel Welin solved this problem with his stepped interrupted screw design: the Welin breech block of 1890. This design has threads of the block and breech cut in steps of successively larger radius. For example, this allows a breechblock with four steps to allow four-fifths of the block circumference to be threaded, allowing for a much shorter breechblock while still requiring only one-fifth of a turn to open or close. This is the basic design still in use with bagged charge artillery.