LOM port

The LOM port (Lights Out Management port) is a remote access facility on a Sun server. When the main processor is switched off, or when it is impossible to telnet to the server, an operator would use a link to the LOM port to access the server. As long as the server has power, the LOM facility will work, regardless of whether or not the main processor is switched on.

To use the LOM port, a rollover cable is connected to the LOM port, which is located at the back of the Sun server. The other end of the cable is connected to a terminal or to a PC running a terminal emulator. The terminal or emulator must be set to a transmission rate of 9600 bits per second, and hardware flow control enabled.

Useful commands

#.       - Switch to the LOM prompt.
help     - View complete command listing.
console  - Switch to the Solaris prompt.
poweroff - Switch off the main processor.
poweron  - Switch on the main processor.
reset    - Issue poweroff and poweron in succession.
boot     - Boot the operating system
break    - Interrupt the current (boot) process

Specific implementations

• Advanced Lights Out Management (ALOM), Sun Microsystems-specific and comes standard on newer Sun servers (SunFire V125/V210/V215/V240/V245/V250/V440/T1000, Sun Netra 210/240/440).
• Integrated Lights Out Management (ILOM), Sun Microsystems's ALOM replacement on Sun x64 server SunFire X4100(M2)/X4200(M2)/X4600(M2)/X4140/X4240/X4440/X4150/X4250/X4450/X4170/X4270/X2250/X2270, Sun Blade 6000 Chassis Management Module/Blade Module(X6220/X6420/X6240/X6440/X6250/X6450/X6270/X6275), Sun CMT servers/blades (Sun T5120, T5220, T5240, T6340, T6320).
• Lomlite and Lomlite2 Single-chip implementations on the Netra T1 and possibly others. In the cases of the T1-200 and X1, the OpenBoot firmware implements lom@ and lom! commands allowing access to the registers representing temperature, voltage etc.

See also

• Out-of-band management
• Network Console on Acid
• Power distribution unit

External links

• Netra-T1 AC200 LOM Usage