Laser Doppler vibrometer

Basic components of a laser Doppler vibrometer

A laser Doppler vibrometer (LDV) is a scientific instrument that is used to make non-contact vibration measurements of a surface. The laser beam from the LDV is directed at the surface of interest, and the vibration amplitude and frequency are extracted from the Doppler shift of the reflected laser beam frequency due to the motion of the surface. The output of an LDV is generally a continuous analog voltage that is directly proportional to the target velocity component along the direction of the laser beam.

Some advantages of an LDV over similar measurement devices such as an accelerometer are that the LDV can be directed at targets that are difficult to access, or that may be too small or too hot to attach a physical transducer. Also, the LDV makes the vibration measurement without mass-loading the target, which is especially important for MEMS devices.

Principles of operation

A vibrometer is generally a two beam laser interferometer that measures the frequency (or phase) difference between an internal reference beam and a test beam. The most common type of laser in an LDV is the helium–neon laser, although laser diodes, fiber lasers, and Nd:YAG lasers are also used. The test beam is directed to the target, and scattered light from the target is collected and interfered with the reference beam on a photodetector, typically a photodiode. Most commercial vibrometers work in a heterodyne regime by adding a known frequency shift (typically 30–40 MHz) to one of the beams. This frequency shift is usually generated by a Bragg cell, or acousto-optic modulator.

A schematic of a typical laser vibrometer is shown above. The beam from the laser, which has a frequency fo, is divided into a reference beam and a test beam with a beamsplitter. The test beam then passes through the Bragg cell, which adds a frequency shift fb. This frequency shifted beam then is directed to the target. The motion of the target adds a Doppler shift to the beam given by fd = 2*v(t)*cos(α)/λ, where v(t) is the velocity of the target as a function of time, α is the angle between the laser beam and the velocity vector, and λ is the wavelength of the light.

Light scatters from the target in all directions, but some portion of the light is collected by the LDV and reflected by the beamsplitter to the photodetector. This light has a frequency equal to fo + fb + fd. This scattered light is combined with the reference beam at the photo-detector. The initial frequency of the laser is very high (> 1014 Hz), which is higher than the response of the detector. The detector does respond, however, to the beat frequency between the two beams, which is at fb + fd (typically in the tens of MHz range).

The output of the photodetector is a standard frequency modulated (FM) signal, with the Bragg cell frequency as the carrier frequency, and the Doppler shift as the modulation frequency. This signal can be demodulated to derive the velocity vs. time of the vibrating target.

Applications

LDVs are used in a wide variety of scientific, industrial, and medical applications. Some examples are provided below:

Types of laser Doppler vibrometers

See also

References

  1. Kilpatrick, James M.; Markov, Vladimir (2008). Tomasini, Enrico P, ed. "Eighth International Conference on Vibration Measurements by Laser Techniques: Advances and Applications". Eighth International Conference on Vibration Measurements by Laser Techniques: Advances and Applications 7098: 709809. doi:10.1117/12.802929. |chapter= ignored (help)
  2. Bissinger, George. and Oliver, David (July 2007). "3-D Laser Vibrometry on Legendary Old Italian Violins" (PDF). Sound and Vibration. Retrieved 2013-01-24.
  3. Applications for Civil Engineering
  4. Baldini, Francesco; Moir, Christopher I.; Homola, Jiri; Lieberman, Robert A. (2009). Baldini, Francesco; Homola, Jiri; Lieberman, Robert A, eds. "Miniature laser doppler velocimetry systems". Optical Sensors 2009 7356: 73560I–73560I–12. doi:10.1117/12.819324. |chapter= ignored (help)
  5. Huber, Alexander M; Schwab, C; Linder, T; Stoeckli, SJ; Ferrazzini, M; Dillier, N; Fisch, U (2001). "Evaluation of eardrum laser doppler interferometry as a diagnostic tool" (PDF). The Laryngoscope 111 (3): 501–7. doi:10.1097/00005537-200103000-00022. PMID 11224783.
  6. Fonseca, P.J. and Popov, A.V. (1994). "Sound radiation in a cicada: the role of different structures". Journal of Comparative Physiology A 175 (3). doi:10.1007/BF00192994.
  7. Sutton, C. M. (1990). "Accelerometer Calibration by Dynamic Position Measurement Using Heterodyne Laser Interferometry". Metrologia 27 (3): 133. doi:10.1088/0026-1394/27/3/004.
  8. Abdullah Al Mamun; GuoXiao Guo; Chao Bi (2007). Hard Disk Drive: Mechatronics And Control. CRC Press. ISBN 978-0-8493-7253-7. Retrieved 24 January 2013.
  9. Xiang, Ning; Sabatier, James M. (2000). Dubey, Abinash C; Harvey, James F; Broach, J. Thomas; et al., eds. "Detection and Remediation Technologies for Mines and Minelike Targets V". Detection and Remediation Technologies for Mines and Minelike Targets V 4038: 645. doi:10.1117/12.396292. |chapter= ignored (help)
  10. Burgett, Richard D.; Bradley, Marshall R.; Duncan, Michael; Melton, Jason; Lal, Amit K.; Aranchuk, Vyacheslav; Hess, Cecil F.; Sabatier, James M.; Xiang, Ning (2003). Harmon, Russell S; Holloway, Jr, John H; Broach, J. T, eds. "Detection and Remediation Technologies for Mines and Minelike Targets VIII". Detection and Remediation Technologies for Mines and Minelike Targets VIII 5089: 665. doi:10.1117/12.487186. |chapter= ignored (help)
  11. Lal, Amit; Aranchuk, Slava; Doushkina, Valentina; Hurtado, Ernesto; Hess, Cecil; Kilpatrick, Jim; l'Esperance, Drew; Luo, Nan; Markov, Vladimir (2006). Broach, J. Thomas; Harmon, Russell S; Holloway, Jr, John H, eds. "Detection and Remediation Technologies for Mines and Minelike Targets XI". Detection and Remediation Technologies for Mines and Minelike Targets XI 6217: 621715. doi:10.1117/12.668927. |chapter= ignored (help)
  12. Rui Li; Tao Wang; Zhigang Zhu; Wen Xiao (2011). "Vibration Characteristics of Various Surfaces Using an LDV for Long-Range Voice Acquisition". IEEE Sensors Journal 11 (6): 1415. doi:10.1109/JSEN.2010.2093125.
  13. Laura Rodríguez, High temperature surface measurement with Aries Laser Vibrometer, VELA. Original paper presented at AIVELA Conferences 2012.June 2012.
  14. "Single-Point Vibrometers".
  15. Jorge Fernández Heredero, 3D Vibration Measurement using LSV. Original paper presented at AdMet 2012.February 2012.
  16. Scalise, Lorenzo; Paone, Nicola (2000). Tomasini, Enrico P, ed. "Fourth International Conference on Vibration Measurements by Laser Techniques: Advances and Applications". Fourth International Conference on Vibration Measurements by Laser Techniques: Advances and Applications 4072: 25. doi:10.1117/12.386763. |chapter= ignored (help)
  17. Heterodyned self-mixing laser diode vibrometer – US Patent 5838439. Issued on November 17, 1998. Patentstorm.us. Retrieved on 2013-06-17.
This article is issued from Wikipedia - version of the Wednesday, December 23, 2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.