Linkwitz–Riley filter

Comparison of the magitude response of the summed Butterworth and Linkwitz–Riley crossover filters. The Butterworth crossovers have a +3dB peak at the crossover frequency, whereas the L-R filters have a flat summed output.

A Linkwitz–Riley (L-R) filter is an infinite impulse response filter used in Linkwitz–Riley audio crossovers, named after its inventors Siegfried Linkwitz and Russ Riley, which was originally described in Active Crossover Networks for Noncoincident Drivers in JAES Volume 24 Issue 1 pp. 2-8; February 1976. It is also known as a Butterworth squared filter. An L-R crossover consists of a parallel combination of a low-pass and a high-pass L-R filter. The filters are usually designed by cascading two Butterworth filters, each of which has 3 dB gain at the cut-off frequency. The resulting Linkwitz–Riley filter has a 6 dB gain at the cutoff frequency. This means that summing the low-pass and high-pass outputs, the gain at the crossover frequency will be 0 dB, so the crossover behaves like an all-pass filter, having a flat amplitude response with a smoothly changing phase response. This is the biggest advantage of L-R crossovers compared to Butterworth crossovers, whose summed output has a +3 dB peak around the crossover frequency. Since cascading two nth order Butterworth filters will give a 2nd order Linkwitz–Riley filter, theoretically any 2nd order Linkwitz–Riley crossover can be designed. However, crossovers of higher order than 4th may have less usability due to their increasing peak in group delay around crossover frequency and complexity.

Common types

Second order Linkwitz–Riley crossover (LR2, LR-2)

Second-order Linkwitz–Riley crossovers (LR2) have a 12 dB/octave (40 dB/decade) slope. They can be realized by cascading two one-pole filters, or using a Sallen Key filter topology with a Q0 value of 0.5. There is a 180° phase difference between the lowpass and highpass output of the filter, which can be corrected by inverting one signal. In loudspeakers this is usually done by reversing the polarity of one driver if the crossover is passive. For active crossovers inversion is usually done using a unity gain inverting op-amp.

Fourth order Linkwitz–Riley crossover (LR4, LR-4)

Fourth-order Linkwitz–Riley crossovers (LR4) are probably today's most commonly used type of audio crossover. They are constructed by cascading two 2nd-order Butterworth filters. Their steepness is 24 dB/octave (80 dB/decade). The phase difference amounts to 360°, i.e. the two drives appear in phase, albeit with a full period time delay for the low-pass section.

Eighth order Linkwitz–Riley crossover (LR8, LR-8)

Eighth-order Linkwitz–Riley crossovers (LR8) have a very steep, 48 dB/octave (160 dB/decade) slope. They can be constructed by cascading two 4th-order Butterworth filters.

See also

Wikimedia Commons has media related to Linkwitz–Riley filters.

References

This article is issued from Wikipedia - version of the Friday, April 08, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.