Littlejohn adaptor

Light tank Mk VII Tetrarch Mk I with Littlejohn adaptor.

The Littlejohn adaptor was a device that could be added to the British QF 2 pounder (40 mm) anti-tank gun. It was used to extend the service life of the 2-pounder during the Second World War by converting it to squeeze bore operation. "Littlejohn" came from the literal anglicization of the name of František Janeček, the Czech designer and factory owner who had been working on the squeeze-bore principle in the 1930s and his son František Karel Janeček had brought his know-how to Britain after he fled from the German-occupied Czechoslovakia.[1]

Design

At Bovington Tank Museum

The adaptor took the form of a reducing bore that was screwed on to the end of the gun. This was coupled with a round formed from a hard core (tungsten) inside a softer metal casing - the armour-piercing, composite non-rigid (APCNR) design.

The round upon firing travelled the first part of the bore as normal, but on entering the tapering portion the softer and malleable metal of the outer shell of the round was compressed - from 40 mm to approximately 30 mm.

The round when it emerged from the adaptor now had a smaller cross-section compared with its weight. Together with the higher driving pressure developed in the barrel of diminishing internal volume compared to standard cylindrical bore, the APCNR round, called APSV (from armour-piercing super velocity), travelled faster, over a flatter trajectory. The Littlejohn adaptor/APCNR combination gave the 2 pounder a similar effect as the APDS round used with the much and heavier larger QF 6 pounder gun.

The muzzle velocity of the APSV Mark II shell was 1,143 m/s compared with the 792 m/s of the normal 1.2 kg APCBC shell. The lighter Mark I APSV shell was capable of penetrating 88 mm of armour at 450 m at a 30-degree angle of impact.[2]

In 1942 US Ordnance tested the Littlejohn adaptor in an attempt to develop a taper bore adaptor for the 37 mm Gun M3. The adaptor distorted after a few shots.[3]

Use

The adaptor was chiefly used on British armoured cars e.g. the Daimler which had been designed and built earlier in the war and could not be readily fitted with a larger gun. As an adaptor to the existing gun could be removed so that normal rounds could be fired, this offered increased anti-armour effect but with obvious drawbacks in combat conditions. When crews discovered the special 'squeeze bore' ammunition was more effective than the standard 2pdr AT round even when not 'squeezed' in practice the adaptors tended to be stored rather than fitted.

It was also experimentally fitted to the Vickers 40mm S Gun fitted to the Hawker Hurricane IID anti-armour variant (see photo). As Anthony G Williams concludes in The Cartridge Researcher, the official bulletin of the European Cartridge Research Association (February 1999): the gun/ammunition combination did not function with sufficient reliability.

As stated in the above-mentioned article on the Vickers S Gun states: Tests in the Far East showed a high level of accuracy, with an average of 25% of shots fired at tanks striking the target [but] attacks with HE were twice as accurate as with AP, possibly because the ballistics were a closer match to the .303 in (7.7 mm) Browning machine guns used for sighting

See also

Notes

  1. ↑ Williams, Anthony G. "The Littlejohn Adaptor". Retrieved 5 December 2010.
  2. ↑ http://www.quarryhs.co.uk/sgun.htm Littlejohn adaptor
  3. ↑ Zaloga, Delf - US Anti-tank Artillery 1941-45, p 6-7.

References

This article is issued from Wikipedia - version of the Monday, April 18, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.