Loudness

For the Japanese band, see Loudness (band).

Loudness is the characteristic of a sound that is primarily a psychological correlate of physical strength (amplitude). More formally, it is defined as "that attribute of auditory sensation in terms of which sounds can be ordered on a scale extending from quiet to loud".[1]

Loudness, a subjective measure, is often confused with objective measures of sound strength such as sound pressure, sound pressure level (in decibels), sound intensity or sound power. Filters such as A-weighting attempt to adjust sound measurements to correspond to loudness as perceived by the typical human. However, loudness perception is a much more complex process than A-weighting.[2]

Loudness is also affected by parameters other than sound pressure, including frequency, bandwidth and duration.[2]

Explanation

The perception of loudness is related to sound pressure level (SPL), frequency content and duration of a sound. The human auditory system averages the effects of SPL over a 600–1000 ms interval. A sound of constant SPL will be perceived to increase in loudness as samples of duration 20, 50, 100, 200 ms are heard, up to a duration of about 1 second at which point the perception of loudness will stabilize. For sounds of duration greater than 1 second, the moment-by-moment perception of loudness will be related to the average loudness during the preceding 600–1000 ms.

For sounds having a duration longer than 1 second, the relationship between SPL and loudness can be approximated by a power function in which SPL has an exponent of 0.6, while that between SPL and intensity can be approximated by a power function with an exponent of 0.3 (Stevens' power law). More precise measurements indicate that loudness increases with a higher exponent at low and high levels and with a lower exponent at moderate levels.

Units used to measure loudness:

The horizontal axis shows frequency in Hz

The sensitivity of the human ear changes as a function of frequency, as shown in the equal-loudness graph. Each line on this graph shows the SPL required for frequencies to be perceived as equally loud, and different curves pertain to different sound pressure levels. It also shows that humans with normal hearing are most sensitive to sounds around 2–4 kHz, with sensitivity declining to either side of this region. A complete model of the perception of loudness will include the integration of SPL by frequency.[2]

Historically, loudness was measured using an "ear-balance" audiometer in which the amplitude of a sine wave was adjusted by the user to equal the perceived loudness of the sound being evaluated. Contemporary standards for measurement of loudness are based on summation of energy in critical bands as described in IEC 532, DIN 45631 and ASA/ANSI S3.4. A distinction is made between stationary loudness (sounds that remain sensibly constant) and non-stationary (sound sources that move in space or change amplitude over time.)

Hearing loss

When sensorineural hearing loss (damage to the cochlea or in the brain) is present, the perception of loudness is altered. Sounds at low levels (often perceived by those without hearing loss as relatively quiet) are no longer audible to the hearing impaired, but sounds at high levels often are perceived as having the same loudness as they would for an unimpaired listener. This phenomenon can be explained by two theories: loudness grows more rapidly for these listeners than normal listeners with changes in level. This theory is called "loudness recruitment" and has been accepted as the classical explanation. More recently, it has been proposed that some listeners with sensorineural hearing loss may in fact exhibit a normal rate of loudness growth, but instead have an elevated loudness at their threshold. That is, the softest sound that is audible to these listeners is louder than the softest sound audible to normal listeners. This theory is called "softness imperception", a term coined by Mary Florentine.[3]

Compensation

Main article: Loudness compensation

The "loudness" control on some consumer stereos alters the frequency response curve to correspond roughly with the equal loudness characteristic of the ear.[4] Loudness compensation is intended to make the recorded music sound more natural when played at a lower levels by boosting low frequencies, to which the ear is less sensitive at lower sound pressure levels.

Normalization

Loudness normalization equalizes perceived level such that, for instance, commercials do not sound louder than television programs. Loudness normalisation schemes exist for a number of audio applications.

Broadcast

Movie and home theaters

Music playback

Measurement

Relative loudness monitoring in production is measured in accordance with ITU-R BS.1770 in units of LKFS.[6]

Work began on ITU-R BS.1770 in 2001 after 0 dBFS+ level distortion in converters and lossy codecs had become evident; and the original Leq(RLB) loudness metric was proposed by Gilbert Soloudre in 2003.[7]

Based on data from subjective listening tests, Leq(RLB) was compared against numerous other algorithms where it did remarkably well. After modification of the frequency weighting, the measurement was made multi-channel (monaural to 5.1 surround sound). CBC, Dolby and TC Electronics and numerous broadcasters contributed to the listening tests.

To make the loudness metric cross-genre friendly, a relative measurement gate was added. This work was carried out in 2008 by the EBU. The improvements were brought back into BS.1770-2. ITU subsequently updated the true-peak metric (BS.1770-3) and added provision for more audio channels, for instance 22.2 surround sound (BS.1770-4).

See also

References

  1. ↑ American National Standards Institute, "American national psychoacoustical terminology" S3.20, 1973, American Standards Association.
  2. 1 2 3 Olson, Harry F. (February 1972). "The Measurement of Loudness" (PDF). Audio: 18–22.
  3. ↑ Mary Florentine (March 2003), It's not recruitment-gasp!! It's softness imperception 56 (3), Hearing Journal, pp. 10, 12, 14, 15, doi:10.1097/01.HJ.0000293012.17887.b4
  4. ↑ Lenk, John D. (1998). Circuit Troubleshooting Handbook. McGraw-Hill. p. 163. ISBN 0-07-038185-2.
  5. ↑ EBU Recommendation R 128: Loudness normalisation and permitted maximum level of audio signals (PDF), European Broadcasting Union, August 2011, retrieved 2013-04-22
  6. ↑ Recommendation BS.1770, International Telecommunication Union, August 2012, retrieved 2013-05-31
  7. ↑ "Leq Meter". Retrieved 2015-12-15.
This article is issued from Wikipedia - version of the Monday, April 25, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.