Mechanical probe station

An automated probe station by Cascade Microtech

A mechanical probe station is used to physically acquire signals from the internal nodes of a semiconductor device. The probe station utilizes manipulators which allow the precise positioning of thin needles on the surface of a semiconductor device. If the device is being electrically stimulated, the signal is acquired by the mechanical probe and is displayed on an oscilloscope. The mechanical probe station is often used in the failure analysis of semiconductor devices.

Close-up of passive probes on the same probe station

There are two types of mechanical probes: active and passive. Passive probes usually consist of a thin tungsten needle. Active probes utilize a FET device on the probe tip in order to significantly reduce loading on the circuit.

Research

Mechanical probe stations are often used in academic research on electronics and materials science. It is often faster and more flexible to test a new electronic device or sample with a probe station than to wire bond and package the device before testing.

This Desert Cryogenics probe station encloses the sample and probes in a vacuum chamber and permits the introduction of cryogens to cool the sample to low temperatures.

External links

This article is issued from Wikipedia - version of the Wednesday, December 04, 2013. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.