Multicast lightpaths

Fig 1: Multicast connections affected by fiber cut

A multicast session requires a “point-to-multipoint” connection from a source node to multiple destination nodes.[1] The source node is known as the root. The destination nodes are known as leaves. In the modern era, it is important to protect multicast connections in an optical mesh network. Recently, multicast applications have gained popularity as they are important to protecting critical sessions against failures such as fiber cuts, hardware faults, and natural disasters.

Multicast applications

Multicast applications include multimedia, medical imaging, digital audio, HDTV, video conferencing, interactive distance learning, and distributed games.

Multi-casting switch architecture

In order to support multi-casting, the WDM network requires multicast-capable wavelength-routing switches at the network node. These switches are capable of replicating data streams from one input port to multiple output ports. There are two types of switch architectures that are usually used:[2]

Multicast lightpaths protection

Multicast lightpaths protection refers to an immediate response of the network after a failure to switch the traffic on another path.

Dedicated: resources along the backup paths are dedicated for only one connection and are not shared with the backup paths for other connections.

Shared: resources along a backup path may be shared with other backup paths for other connections.

Protecting multicast sessions

Fig 2: Link disjoint backup tree.

Several protection schemes have been proposed in the literature to protect the multicast connections. The simplest idea to protect the multicast tree from single fiber failure is to compute a link disjoint backup tree. In Fig 2 a multicast session from source node F to destination nodes A,B,C,D and E forms a light tree. F is the root and the remaining nodes are the leaves. The primary light tree is shown in solid lines and (directed-link-disjoint) the back up light tree is shown in dotted lines carrying traffic from source node to destinations.[3]

The ring based approach is also proposed to protect multicast session.[4]

The segment protection scheme is another way to protect multicast connections.[5] A segment in a multicast tree is defined as the sequence of edges from the source or any splitting node (on a tree) to a leaf node or to a downstream splitting node. A destination node is always considered as a segment end node because it is either a leaf node in a tree or a splitting node.

A multicast protection scheme through spanning paths is also one of the key approaches to protecting multicast sessions.[6][7][8][9] A spanning path in a multicast tree is defined as a path from a leaf node to any other leaf node in the light tree. The scheme derives backup paths for every spanning path in the multicast tree.

Concept of DBPP and SBPP on multicast connections

Dedicated backup path protection (DBPP) for multicast connections: Depending on the network topology, a dedicated backup path concept can be applied for multicast traffic. Fig 3 shows a multicast session from source node F to destination nodes A, B, C, D, and E which form the light tree. A dedicated backup path protection scheme can be applied to protect multicast traffic from link failure. This is easy to achieve with one-to-one protection where the dedicated backup path is already provisioned and traffic is simply switched to it on failure.

Fig 3:dedicated backup path protection
Fig 4:shared backup path protection before failure
Fig 5:shared backup path protection after failure

Shared backup path protection (SBPP) for multicast connections: The SBPP technique can be used for multicast connections at the optical layer because of its resource efficiency, due to the fact that the backup paths can share wavelength channels on links while their corresponding primary paths are link disjoint. Paths can share links with working paths and protection paths of other leaves. In Fig 4 FE and FA are primary paths. The optical line is reserved for shared protection of both FE and FA.

Path protection technique for multicast connections (multiple unicast connections):

Key features Dedicated backup path protection Shared backup path protection
Reliability Highly reliable Less reliable
Cross connect Cross connect established before failure Cross connect established after failure
Cost Cost is higher than SBPP Less than DBPP

Importance

Protection schemes for multicast connections are important for the following reasons:

1. Loss of connectivity: network failures such as fiber cuts in a communication network occur often enough to cause service disruption, and lead to significant information loss in the absence of adequate backup mechanisms.

2. SLA: it is important for providers to follow SLAs and guaranteed service. It is important to protect multicast connections to maintain the SLA.

3. Business reputation: network availability is one of the key aspects of multicasting connections. A company loses money and reputation when its network fails.

See also

Notes

  1. L. H. Sahasrabuddhe and B. Mukherjee, “Light-trees: Optical multi-casting for improved performance in wavelength-routed networks,” IEEE Commun. Mag., vol. 37, pp. 67–73, Feb. 1999.
  2. N. Singhal and B. Mukherjee, “Protecting multicast sessions in WDM optical mesh networks,” J. Lightwave Technol., vol. 21, Apr. 2003
  3. N. Singhal and B. Mukherjee, “Protecting multicast sessions in WDM optical mesh networks,” J. Lightwave Technol., vol. 21, Apr. 2003
  4. C. Boworntummarat, L. Wuttisittikulkij, and S. Segkhoonthod, “Lighttree based Protection Strategies for Multicast Traffic in Transport WDM Mesh Networks with Multi-fiber Systems”, in Proc. IEEE ICC’04, June 2004, vol. 3, pp.1791–1795
  5. N. Singhal, L. sahasrabuddhe, and B. Mukherjee, “Provisioning of Survivable Multicast Sessions Against Single Link Failures in Optical WDM Mesh Networks”, IEEE/OSA J. of Lightwave Technology, vol. 21, no. 11, pp. 2587–2594, Nov. 2003.
  6. N. Singhal, C. Ou, and B. Mukherjee, “Shared Protection for Multicast Sessions in Mesh Networks”, in Proc. IEEE OFC’05, pp. 823-825, 2005
  7. N. Singhal, C. Ou, B. Mukherjee, “Cross-sharing vs. Self-sharing Trees for Protecting Multicast Sessions in Mesh Networks”, J of Computer Networks, vol 50, no. 2, pp. 200-106, Feb. 2006.
  8. H. Luo, H. Yu, L. Li, and S. Wang, “On Protecting Dynamic Multicast Sessions in Survivable Mesh WDM Networks”, in Proc. OFC’2006
  9. H. Luo, L. Li, and H. Yu, “Algorithm for Protecting Light-trees in Survivable Mesh Wavelength-division-multiplexing Networks”, J. of Optical Networking, vol. 5, no. 12, pp. 1071–1083, 2006.
This article is issued from Wikipedia - version of the Saturday, March 01, 2014. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.