British 21 inch torpedo

There have been several British 21-inch (533 mm) diameter torpedoes used by the Royal Navy since their first development just before the First World War.

The 21-inch was the largest size of torpedo in common use in the RN. They were used by surface ships and submarines rather than aircraft which used smaller 18 inch torpedoes.

21 inch Mark I

The first British 21 inch torpedo came in two lengths "Short" at 17 ft 10.5 in (5.45 m), and "Long" at 23 ft 1.25 in (7.04 m). The explosive charge was 200 lb of gun cotton increased later to 225 lb.

21 inch Mark II

21 inch Mark II
Type heavy torpedo
Place of origin United Kingdom
Service history
In service c. 1914- Second World War
Used by RN
Wars First World War, Second World War
Production history
Designed c. 1910
Specifications
Diameter 21 inch

Warhead TNT
Warhead weight 400-515 lb

Engine wet heater
Operational
range
8,000 yards max depending on model
Speed 29 to 35 knots

The Mark II, chiefly used by destroyers, entered service in 1914. Apart from some older British ships, it was used with the old US (destroyers for bases agreement) Town-class destroyers provided to the UK during the early part of the Second World War. The running speed was reduced from 45 knots (over 3,000 yards) for better reliability.

The Mark II*, an improved Mark II was used by battleships and battlecruisers. A wet heater design, it could run for 4.1 km (4,500 yd) at 45 knots (83 km/h)

21 inch Mark IV

21 inch Mark IV
Type torpedo
Place of origin United Kingdom
Service history
In service c. 1916-
Production history
Designed c. 1912
Specifications
Weight 3,206 lb (1,454 kg)
Length 22 ft 7.5 in (6.896 m)
Diameter 21 inch (533 mm)

Warhead TNT
Warhead weight 515 lb (234 kg)

Engine Burner cycle
Operational
range
8,000 - 13,500 yards
Speed 25 - 35 knots

From 1912, used by destroyers and other surface ships and was an important weapon in the first World War. In the Second World War they were carried on HMS Hood.

21 inch Mark V

21 inch Mark V
Type torpedo
Place of origin United Kingdom
Production history
Designed 1917
Specifications
Length 7.1 m (23 ft 4 in)
Diameter 21 inch

Engine wet heater
Operational
range
4.6 km (5,000 yd) to 12.4 km (13,600 yd)
Speed 40 knots (74 km/h) to 25 knots (46 km/h)

The Mark V was used by the A and B-class destroyers and, with modification, by the Kent-class heavy cruisers.

21 inch Mark VII

21 inch Mark VII
Type heavy torpedo
Place of origin United Kingdom
Service history
In service Second World War
Used by RN
Production history
Designed 1920s
Specifications
Length 25 ft 6 in (7.77 m)
Diameter 21 inch

Warhead TNT
Warhead weight 740 lb (336 kg)

Engine oxygen enriched air
Operational
range
5,700 yards (5,200 m)
Speed 35 knots

The Mark VII was issued for use on the British heavy cruisers; i.e. cruisers with 8-inch guns. Designed in the mid-1920s the County-class cruisers were built at the same time in the post Washington Naval Treaty period.

The power came from the use of oxygen enriched air, though torpedo stocks were converted to run on normal air at the start of the Second World War.

21 inch Mark VIII

Specifications:[1]

Mark VIIIs loading to Polish Navy submarine ORP Sokół

Mark VIII

Early Mark VIII**

Late Mark VIII**

The Mark VIII was designed around 1925 and was the first British burner-cycle design torpedo. It was used from 1927 on submarines of the O class onwards and motor torpedo boats. The principal World War II version was the improved Mark VIII**, 3,732 being fired by September 1944 (56.4% of the total number). The torpedo was still in service with the Royal Navy as late as 1983, and with the Royal Norwegian Navy (Coastal Artillery: Kaholmen torpedo battery at Oscarsborg Fortress) until 1993.

The Mark VIII** was used in two particularly notable incidents:-

On 9 February 1945 the Royal Navy submarine HMS Venturer sank the German submarine U-864 with four Mark VIII** torpedoes. This is the only intentional wartime sinking of one submarine by another while both were submerged.

On 2 May 1982 the Royal Navy submarine HMS Conqueror sank the Argentine cruiser ARA General Belgrano with three Mark VIII** torpedoes during the Falklands War.[2] This is the only sinking of a surface ship by a nuclear-powered submarine in wartime (and only the second sinking of a surface ship by any submarine since the end of WWII).

21 inch Mark IX

First appeared in 1930 and was considerably improved by 1939. Used on Leander and later cruisers, "A" and later destroyer classes. Also replaced the old Mark VII in some 8" (20.3 cm) cruisers during the war.

21 inch Mark X

From 1939, used by submarines, motor torpedo boats and destroyers.

21 inch Mark XI

Electric battery powered torpedo with a 322 kg (710 lb) TNT warhead. Entering service during the Second World War it was used by destroyers.

21 inch Mark 12

Codenamed first "Ferry" then "Fancy", the Mark 12 never reached production. From 1952, a warhead of 340 kg (750 lb) Torpex. Powered by high test peroxide, giving it a speed of 28 knots (52 km/h) for 5 km (5,500 yd).

There were accidents during testing caused by the unstable nature of HTP. One such engine explosion, after loading on the submarine HMS Sidon, caused enough damage to have the submarine taken permanently out of service.

Mark 12 torpedoes were out of service in 1959 and the programme was cancelled.[3]

21 inch Mark 20 Bidder

21 inch Mark 20
Type torpedo
Place of origin United Kingdom
Service history
In service 1955-1980s
Production history
Designed c. 1950
Specifications
Weight 1,810 lb (821 kg)
Length 6.46 m
Diameter 21 inches

Warhead weight 196 lb (89 kg)

Engine electric
Propellant battery
Operational
range
12,000 yards (11,000 m)
Speed 20 knots
Guidance
system
passive sonar

Developed under the codename "Bidder", the Mark 20 was a passive-seeker battery-powered torpedo for use by surface ships (the Mark 20E - for "Escort") and submarines (Mark 20S). The E variant was not long in service due to problems with its programming. This led to several of frigates intended to use them (Rothesay and Whitby classes) never being fitted with torpedo tubes or having them removed.

It was replaced in the submarine service in the 1980s by Tigerfish.

21 inch Mark 21 Pentane

A project for an autonomous active/passive sonar torpedo to be carried by the Short Sturgeon anti-submarine aircraft.[4] It was cancelled after protracted work but the seeker development was used in Tigerfish.

21 inch Mark 22

A wireguided version of the Mark 20 produced by Vickers Shipbuilding and Engineering (VSEL) as a private venture

21 inch Mark 23 Grog

A wireguided version of the Mark 20. Entered service in the 1971 although already obsolescent, serving only as an interim before Tigerfish entered service.

The MK23 was fitted with a 10 000 M outboard dispenser that contains a control wire to guide the weapon, During 1973, all of the RN torpedoes had to be taken out of service as the control system was failing at extreme range.

After months of investigation, it was discovered that the fault lay in the Guidance Unit made by GEC. A germanium diode in the AGC circuit had been replaced by a silicon diode, following an instruction by RN stores that all germanium diodes had to be replaced by silicon diodes. Unfortunately, the silicon diode's different characteristics caused the automatic gain control circuit to fail. Once the mistake was found replacing the diode with the original type cured the problem

Mark 24 Tigerfish

Main article: Mark 24 Tigerfish

The first Tigerfish (Mod 0) entered service in 1980. Tigerfish was removed from service in 2004.

There were several models of Tigerfish due to the modifications made to tackle deficiencies.

Spearfish

Main article: Spearfish torpedo

See also

Notes

References

This article is issued from Wikipedia - version of the Wednesday, April 13, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.