Port multiplier

A SATA 2.0 (3 Gbit/s) PCI Express ×1 expansion card, having two built-in SATA port multipliers (square chips to the left and right of the middle of PCB) that "splice" card chipset's two SATA ports into a total of eight ports.

A Serial ATA port multiplier (SATA PM) is a device that allows multiple SATA devices to be connected to a single SATA host port. Many common controllers do not support this feature,^[1] as it is not a requirement for a SATA controller.^[2]

Benefits

Port multipliers have the following potential benefits:

• Reduced cable count (e.g., when using backplanes with integrated port multipliers, or external multi-drive enclosures etc.).
• Additional drives can be supported without additional SATA controllers.

Port multiplication

A Serial ATA port multiplier is a unilateral splitting device. While it allows one equipped port to connect up to 15 disks, the bandwidth available is limited to the bandwidth of the link to the controller, as of 2012 1.5, 3, or 6 Gbit/s.^[3] While the controller is aware that there are multiple drives connected, the service is transparent to the disks attached. Because they believe they are communicating directly with the controller, any drive that holds to the SATA standard can be connected to a port multiplier. There are two ways port multipliers can be driven:

Command-based switching

This system can be thought of as an automated mechanical A/B switch. The controller can issue commands to only one disk at a time and cannot issue commands to another disk until the command queue has been completed for the current transactions. This also hampers the use of Native Command Queuing (NCQ). This means that the full bandwidth of the link will most likely not be used. This kind of switching is therefore used when capacity is the major concern, and not performance.

FIS-based (frame information structure) switching

FIS-based switching is similar to a USB hub. In this method of switching the host controller can issue commands to send and receive data from any drive at any time. A balancing algorithm ensures a fair allocation of available bandwidth to each drive. FIS-based switching allows the aggregated saturation of the host link and does not interfere with NCQ.

Performance

It is possible to connect up to 15 devices to a single SATA host port using a port multiplier. The total bandwidth is still limited to that of a single SATA port.

References

1. List of SATA controller hardware features, a comparison in Linux ATA wiki
2. Serial ATA II: Port Multiplier specification by Serial ATA II Workgroup
3. Port Multipliers, an article by Serial ATA International Organization

External links

• Understanding SATA FIS-Based Switching