Staged combustion cycle

Fuel-rich staged combustion cycle. Here, all of the fuel and a portion of the oxidizer are fed through the preburner, generating fuel-rich gas. After being run through a turbine to power the pumps, the gas is injected into the combustion chamber and burned with the remaining oxidizer.

The staged combustion cycle, also called topping cycle or preburner cycle,[1] is a thermodynamic cycle used in some bipropellant rocket engines. In staged combustion, one propellant is sent through a preburner and partially burned using a small portion of the second propellant. The resulting hot gas is used to power the engine's turbines and pumps, then injected into the main combustion chamber along with the remainder of the second propellant to complete combustion. There are two main variants of the cycle depending on which propellant is sent through the preburner: oxidizer-rich staged combustion (ORSC) and fuel-rich staged combustion (FRSC).

The advantage of staged, or "closed", combustion is that all of the cycle's gases and heat go through the combustion chamber. (An alternative design, called the gas-generator cycle, is an "open" cycle where the gas used to drive the turbopumps is exhausted overboard without passing through the main combustion chamber, reducing efficiency.) Since no propellant is dumped overboard, staged combustion allows for high power turbopumps which permit very high chamber pressures, allowing the use of high expansion ratio nozzles at low altitude for better performance. Disadvantages of staged combustion include harsh turbine conditions, exotic plumbing to carry the hot gases, and complicated feedback and control. In particular, ORSC requires advanced metallurgy due to extremely corrosive oxidizer-rich gas, while FRSC requires use of a fuel that will not coke, such as liquid hydrogen.

History

Staged combustion (Замкнутая схема) was first proposed by Alexey Isaev in 1949. The first staged combustion engine was the S1.5400 (11D33) used in the Soviet planetary rocket, designed by Melnikov, a former assistant to Isaev.[2] About the same time (1959), Nikolai Kuznetsov began work on the closed cycle engine NK-9 for Korolev's orbital ICBM, GR-1. Kuznetsov later evolved that design into the NK-15 and NK-33 engines for the unsuccessful Lunar N1 rocket. The non-cryogenic N2O4/UDMH engine RD-253 using staged combustion was developed by Valentin Glushko around 1963 for the Proton rocket.

After the failure of the N-1, Kuznetsov had been ordered to destroy the NK-33 technology, but instead he warehoused dozens of the engines. In the 1990s, Aerojet was contacted and eventually visited Kuznetsov's plant. Upon meeting initial skepticism about the high specific impulse and other specifications, Kuznetsov shipped an engine to the US for testing. Oxidizer-rich staged combustion had been considered by American engineers, but deemed impossible.[3] The Russian RD-180 engine, purchased by Lockheed Martin (subsequently by United Launch Alliance) for the Atlas III and V rockets, also employs this technique.

The first laboratory staged-combustion test engine in the West was built in Germany in 1963, by Ludwig Boelkow.

Hydrogen peroxide/kerosene fueled engines such as the British Gamma of the 1950s may use a closed-cycle process by catalytically decomposing the peroxide to drive turbines before combustion with the kerosene in the combustion chamber proper. This gives the efficiency advantages of staged combustion, while avoiding major engineering problems.

The Space Shuttle Main Engine is another example of a staged combustion engine, and the first to use liquid oxygen and liquid hydrogen. Its counterpart in the Soviet shuttle was the RD-0120, similar in specific impulse, thrust, and chamber pressure specification to the SSME, but with some differences that reduced complexity and cost at the expense of increased engine weight.

Full-flow staged combustion cycle

Full-flow staged combustion rocket cycle

Full-flow staged combustion (FFSC) is a variation on the staged combustion cycle which uses both an oxidizer-rich and fuel-rich preburner, allowing use of the full flow of both propellants to power the turbines.[4] The fuel turbopump is driven by the fuel-rich preburner, while the oxidizer-rich preburner drives the oxidizer turbopump.[4] This eliminates the need for an interpropellant turbine seal normally required to separate oxidizer-rich gas from the fuel turbopump or fuel-rich gas from the oxidizer turbopump.[5] The increased mass flow from FFSC allows both turbines to run cooler and at lower pressure, leading to a longer engine life and higher reliability. Up to 25 flights were anticipated for one particular engine design studied by the DLR in the frame of the SpaceLiner project.[4]

Since the use of both fuel and oxidizer preburners results in full gasification of each propellant before entering the combustion chamber, FFSC engines are sometimes called gas-gas engines.[5] Full gasification of components leads to faster chemical reactions in the combustion chamber.

Early demonstration tests

Prior to 2014, only two full-flow staged combustion rocket engines have ever progressed sufficiently to be tested on test stands: the Soviet Energomash RD-270 project in the 1960s and the US government-funded Aerojet Rocketdyne Integrated powerhead demonstration project in the mid-2000s.[5]

Raptor

The Raptor engine currently under development by SpaceX is a full-flow staged combustion engine that will be powered by liquid methane and liquid oxygen,[5][6] a departure from the 'open cycle' gas generator system and LOX/kerosene propellants used by SpaceX's current Merlin engines.[6]

Raptor is being designed to produce about 230 tf (510,000 lbf) of thrust[7] with a vacuum Isp of 363 seconds and a sea-level Isp of 321 seconds.[5][8] The use of FFSC may allow the ability to increase the combustion chamber pressure, thereby either increasing overall performance, or "by using cooler gases, providing the same performance as a [standard] staged combustion engine but with much less stress on materials, thus significantly reducing material fatigue or [engine] weight."[5]

Beginning in 2016, SpaceX is also developing a prototype upper-stage Raptor engine engine of a size appropriate to Falcon 9 and Falcon Heavy launch vehicles, specifically for a US Air Force development contract, with testing to be completed in 2018.[9]

Applications

Oxidizer-rich staged combustion engines include the following:

Fuel-rich staged combustion engines include the following:

Full-flow staged combustion engines include the following:

Staged combustion engines have been used in:

Staged combustion engines are planned for:

See also

References

  1. ↑ United States General Accounting Office (1994). Aerospace Plane Technologies: R&D in Japan & Australia. DIANE Publishing. p. 145. ISBN 1-56806-059-9.
  2. 1 2 George Sutton, "History of Liquid Propellant Rocket Engines", 2006
  3. ↑ Cosmodrome History Channel, interviews with Aerojet and Kuznetsov engineers about the history of staged combustion
  4. 1 2 3 Sippel, Martin; Yamashiro, Ryoma; Cremaschi, Francesco (2012-05-10). "Staged Combustion Cycle Rocket Engine Design Trade-offs for Future Advanced Passenger Transport" (PDF). Space Propulsion 2012. ST28-5 (DLR-SART). Retrieved 2014-03-19.
  5. 1 2 3 4 5 6 7 8 9 10 Belluscio, Alejandro G. (2014-03-07). "SpaceX advances drive for Mars rocket via Raptor power". NASAspaceflight.com. Retrieved 2014-03-09.
  6. 1 2 3 Todd, David (2012-11-22). "SpaceX’s Mars rocket to be methane-fuelled". Flightglobal. Retrieved 2012-12-05. Musk said Lox and methane would be SpaceX’s propellants of choice on a mission to Mars, which has long been his stated goal. SpaceX’s initial work will be to build a Lox/methane rocket for a future upper stage, codenamed Raptor. The design of this engine would be a departure from the “open cycle” gas generator system that the current Merlin 1 engine series uses. Instead, the new rocket engine would use a much more efficient “staged combustion” cycle that many Russian rocket engines use.
  7. ↑ https://www.reddit.com/r/IAmA/comments/2rgsan/i_am_elon_musk_ceocto_of_a_rocket_company_ama/cnfpuwi
  8. ↑ "SpaceX propulsion chief elevates crowd in Santa Barbara". Pacific Business Times. 19 February 2014. Retrieved 22 February 2014.
  9. ↑ "Orbital ATK, SpaceX Win Air Force Propulsion Contracts". SpaceNews. 13 January 2016. Retrieved 2016-01-15.
  10. ↑ Clark, Stephen (2014-09-17). "ULA taps Blue Origin for powerful new rocket engine". Spaceflight Now. Retrieved 2015-04-13. Blue Origin's BE-4 engine uses an oxygen-rich staged combustion cycle, employs a single nozzle, and burns liquid oxygen and liquefied natural gas, a fuel that makes the engine cheaper, less complex, and easier to reuse, according to a fact sheet released by Blue Origin.
  11. ↑ Blue Origin. "BE-4 Rocket Engine" (PDF). ULA website 2014. Retrieved 2014-03-19.
  12. ↑ Berger, Eric (2016-03-09). "Behind the curtain: Ars goes inside Blue Origin’s secretive rocket factory". Ars Technica. Retrieved 2016-03-12.
  13. ↑ "GSLV MkIII, the next milestone". Frontline. 2014-02-07.
  14. ↑ "United Launch Alliance Unveils America’s New Rocket – Vulcan". Retrieved 2015-04-13.

External links

This article is issued from Wikipedia - version of the Saturday, March 12, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.