Reaction field method

The reaction field method is used in molecular simulations to simulate the effect of long range dipole-dipole interactions for simulations with periodic boundary conditions. Around each molecule there is a 'cavity' or sphere within which the Coulomb interactions are treated explicitly. Outside of this cavity the medium is assumed to have a uniform dielectric constant. The molecule induces polarization in this media which in turn creates a reaction field, sometimes called the Onsager reaction field. Although Onsager's name is often attached to the technique, because he considered such a geometry in his theory of the dielectric constant,^[1] the method was first introduced by Barker and Watts in 1973.^[2][3]

The effective pairwise potential becomes:

$U_{AB} = q_A q_B \left[\frac{1}{r_{AB}} + \frac{(\varepsilon_{RF} - 1) r_{AB}^2}{(2\varepsilon_{RF} + 1) r_c^3} \right]$

where $r_c$ is the cut-off radius.

The reaction field in the center of the cavity is given by :

$E_{RF} = \frac{2(\varepsilon_{RF} - 1)}{2\varepsilon_{RF} + 1} \frac{\vec{M}}{r_c^3}$

where $\vec{M} = \sum \mu_i$ is the total dipole moment of all the molecules in the cavity. The contribution to the potential energy of the molecule $i$ at the center of the cavity is $-1/2 \mu_i \cdot E_{RF}$ and the torque on molecule $i$ is simply $\mu_i \times E_{RF}$.

When a molecule enters or leaves the sphere defined by the cut-off radius, there is a discontinuous jump in energy.^[4] When all of these jumps in energy are summed, they do not exactly cancel, leading to poor energy conservation, a deficiency found whenever a spherical cut-off is used. The situation can be improved by tapering the potential energy function to zero near the cut-off radius. Beyond a certain radius $r_t$ the potential is multiplied by a tapering function $f(r)$. A simple choice is linear tapering with $r_t = .95 r_c$, although better results may be found with more sophisticated tapering functions.

Another potential difficulty of the reaction field method is that the dielectric constant must be known a priori. However, it turns out that in most cases dynamical properties are fairly insensitive to the choice of $\varepsilon_{RF}$. It can be put in by hand, or calculated approximately using any of a number of well-known relations between the dipole fluctuations inside the simulation box and the macroscopic dielectric constant.^[4]

Another possible modification is to take into account the finite time required for the reaction field to respond to changes in the cavity. This "delayed reaction field method" was investigated by van Gunsteren, Berendsen and Rullmann in 1978.^[5] It was found to give better results—this makes sense, as without taking into account the delay, the reaction field is overestimated. However, the delayed method has additional difficulties with energy conservation and thus is not suitable for simulating an NVE ensemble.

Comparison with other techniques

The reaction field method is an alternative to the popular technique of Ewald summation. Today, Ewald summation is the usual technique of choice, but for many quantities of interest both techniques yield equivalent results. For example, in Monte Carlo simulations of liquid crystals, (using both the hard spherocylinder^[6] and Gay-Berne models^[7]) the results from the reaction field method and Ewald summation are consistent. However, the reaction field presents a considerable reduction in the computer time required. The reaction field should be applied carefully, and becomes complicated or impossible to implement for non-isotropic systems, such as systems dominated by large biomolecules or systems with liquid-vapour or liquid-solid coexistence.^[8]

In section 5.5.5 of his book, Allen^[4] compares the reaction field with other methods, focusing on the simulation of the Stockmayer system (the simplest model for a dipolar fluid, such as water). The work of Adams, et al. (1979) showed that the reaction field produces results with thermodynamic quantities (volume, pressure and temperature) which are in good agreement with other methods, although pressure was slightly higher with the reaction field method compared to the Ewald-Kornfeld method (1.69 vs 1.52). The results show that macroscopic thermodynamic properties do not depend heavily on how long-range forces are treated. Similarly, single particle correlation functions do not depend heavily on the method employed. Several other results also show that the dielectric constant $\epsilon$ can be well estimated with either the reaction field or a lattice summation technique.^[4]

References

1. Onsager, Lars (1 August 1936). "Electric Moments of Molecules in Liquids". Journal of the American Chemical Society 58 (8): 1486–1493. doi:10.1021/ja01299a050.
2. Barker, J.A.; Watts, R.O. (1 September 1973). "Monte Carlo studies of the dielectric properties of water-like models". Molecular Physics 26 (3): 789–792. Bibcode:1973MolPh..26..789B. doi:10.1080/00268977300102101.
3. Watts, R.O. (1 October 1974). "Monte Carlo studies of liquid water". Molecular Physics 28 (4): 1069–1083. Bibcode:1974MolPh..28.1069W. doi:10.1080/00268977400102381.
4. Tildesley, M. P. Allen ; D. J. (1997). Computer simulation of liquids (Repr. ed.). Oxford [u.a.]: Clarendon Press [u.a.] p. 162. ISBN 0198556454.
5. van Gunsteren, Wilfred F.; Berendsen, Herman J. C.; Rullmann, Johan A. C. (1 January 1978). "Inclusion of reaction fields in molecular dynamics. Application to liquid water". Faraday Discussions of the Chemical Society 66: 58. doi:10.1039/DC9786600058.
6. Gil-Villegas, By Alejandro; McGrother and George Jackson, Simon C. (1 November 1997). "Reaction-field and Ewald summation methods in Monte Carlo simulations of dipolar liquid crystals". Molecular Physics 92 (4): 723–734. Bibcode:1997MolPh..92..723G. doi:10.1080/002689797170004. Cite uses deprecated parameter |coauthors= (help);
7. MOHAMMED HOUSSA ABDELKRIM OUALID LU (1 June 1998). "Reaction field and Ewald summation study of mesophase formation in dipolar Gay-Berne model". Molecular Physics 94 (3): 439–446. doi:10.1080/002689798167944.
8. Benito Garzón, Santiago Lago and Carlos Vega "Reaction field simulations of the vapor-liquid equilibria of dipolar fluids: Does the reaction field dielectric constant affect the coexistence properties?", Chemical Physics Letters 231 pp. 366-372 (1994)

Further reading

• Martin Neumann and Othmar Steinhauser "The influence of boundary conditions used in machine simulations on the structure of polar systems", Molecular Physics 39 pp. 437-454 (1980)
• Martin Neumann, Othmar Steinhauser and G. Stuart Pawley "Consistent calculation of the static and frequency-dependent dielectric constant in computer simulations", Molecular Physics 52 pp. 97-113 (1984)
• Andrij Baumketner "Removing systematic errors in interionic potentials of mean force computed in molecular simulations using reaction-field-based electrostatics", Journal of Chemical Physics 130 104106 (2009)
• Reaction Field method