Soft-point bullet

Left to right: .303 British, 6.5×50mmSR Arisaka and .30-06 Springfield soft point ammunition
.357 Magnum rounds. Left: Jacketed Flat/Soft Point (JFP/JSP). Right: Jacketed Hollow Point (JHP). JSP is a semi-jacketed round as the jacket does not extend to the tip. Note the notches on the tip of the JHP which assist in the expansion of the bullet on impact with soft tissue.

A soft-point bullet (SP round or JSP for short), also known as a soft-nosed bullet, is a lead expanding bullet with a copper or brass jacket that is left open at the tip, exposing some of the lead inside and is thus an example of a semi-jacketed round. Side by side comparison with a hollow-point bullet and FMJ ammunition will quickly illustrate the difference.

Specifications

After the introduction of cordite as a propellant it was noted that lead bullets fired at the higher velocities were readily stripped as they travelled along the barrel. This led to significantly faster fouling of the barrel as lead deposits built up particularly on rifled barrels. Bullets were jacketed to prevent fouling, although these inflicted less severe wounds. Partially jacketing the bullet allowed the bullet to foul the barrel less while also exposing the soft tip which is designed to expand upon impact and to spread open the harder metal jacket. The mechanism is the same as hollow-point bullets, but the lack of a hollow depression reduces the area upon which the hydraulic pressure can act on the lead, and thus the soft-point bullet expands more slowly than a hollow point.

Soft-point bullets are less common than hollow points, due to the slower expansion and greater penetration, but they fill roles that hollow points do not. In some cases the reduced expansion is desired, so that more penetration is achieved before the bullet begins the rapid deceleration caused by expansion. In other cases, the smooth, rounded profile typical of a soft-point bullet is preferred over the concave tip of a hollow point, because the latter tends to suffer failure to feed malfunctions in certain magazine-fed firearms. Many of the more modern magazine-fed firearms were expressly designed to feed hollow points reliably, but many older and military-derived designs were not.

A stripper clip of soft-point .303 British ammunition

Many military firearms, especially pistols, were designed to fire only full metal jacket bullet (FMJ) ammunition, and will suffer failures to feed with hollow-point ammunition, leaving soft-point ammunition the best choice for non-military defensive purposes in these firearms. Military firearms are designed to use FMJ rounds because the Hague Convention prohibits signatory nations from using expanding bullets in warfare. However, this convention does not apply to individuals in non-warfare situations, such as law enforcement, personal defense and hunting.

Jacketed soft point is usually abbreviated JSP in the ammunition and reloading industry. Jacketed flat point (JFP) is also used for soft-point bullets with a flat, rather than a rounded front. Until recently, flat-point bullets were required in centerfire rifles with tubular magazines, such as the Winchester rifle, where the rounds are stored front-to-back. Use of metal-pointed bullets in these rifles can be highly dangerous, as the point of the bullet will rest against the primer of the round in front of it and can cause a detonation under the force of recoil. Since late 2005,[1] newer bullet designs with polymer tips offering improved ballistics have become available for safe use in tubular magazine rifles.[2]

See also

References

  1. ↑ "Hornady LEVERevolution Ammunition". Chuckhawks.com. Retrieved 2015-09-05.
  2. ↑ "Hornady Manufacturing Company :: Ammunition :: Rifle :: Choose by Product Line :: LEVERevolution®". Hornady.com. Retrieved 2015-09-05.
This article is issued from Wikipedia - version of the Friday, April 22, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.