Pratt & Whitney TF30

TF30
A TF30 in the Valiant Air Command Warbird Museum, Titusville, Florida
Type Turbofan
National origin United States
Manufacturer Pratt & Whitney
First run 1960s
Major applications General Dynamics F-111 Aardvark
Grumman F-14 Tomcat
LTV A-7 Corsair II



The Pratt & Whitney TF30 (company designation JTF10A[1]) was a military low-bypass turbofan engine originally designed by Pratt & Whitney for the subsonic F6D Missileer fleet defense fighter, but this project was cancelled. It was later adapted with an afterburner for supersonic designs, and in this form it was the world's first production afterburning turbofan, going on to power the F-111 and the F-14A Tomcat, as well seeing use in early versions of the A-7 Corsair II without an afterburner. First flight of the TF30 was in 1964 and production continued until 1986.

Design and development

In 1958, the Douglas Aircraft Company proposed a short-range, four-engined jet airliner to fill the gap below its new DC-8 intercontinental, known internally as the Model 2067. Intended to be marketed the DC-9, it was not directly related to the later twin-engined Douglas DC-9.[1] Pratt & Whitney (P&W) had offered its JT8A turbojet for the airliner, but Douglas preferred to go with a turbofan engine, which would have a greater fuel efficiency than a turbojet. P&W then proposed the JT10A, a half-scale version of its newly developed JT8D turbofan. Development of the new design began in April 1959,[1] using the core of the JT8.[2] Douglas shelved the model 2067 design in 1960, as the targeted US airlines preferred the newly offered Boeing 727.[3]

In 1960, the United States Navy selected the JT10A, designated TF30-P-1, to power the proposed Douglas F6D Missileer, but the project was canceled in April 1961.[4] Meanwhile, the TF30 had been chosen by General Dynamics for its entrant in the TFX competition for the United States Air Force and USN, which was selected for production as the F-111.[5] The version of the TF30 for the F-111 included an afterburner.

Operational history

F-111

A TF30-P-109 from an RAAF F-111 at Defence Force Air Show RAAF Amberley, October 2008

The F-111A, EF-111A and F-111E used the TF30-P-103 (aka P-3) turbofan.[6] The F-111 had problems with inlet compatibility, and many faulted the placement of the intakes behind the disturbed air of the wing. Newer F-111 variants incorporated improved intake designs and most variants featured more powerful versions of the TF30 engine. The F-111E used TF30-P-3 engines, the F-111D included TF30-P-9, and the F-111F had the TF30-P-100.

A-7

In 1964, the subsonic LTV A-7A Corsair II won the US Navy's VAL competition for a light attack aircraft to replace the Douglas A-4 Skyhawk.[7] The A-7A used a non-afterburning variant of the TF30, which would also power the improved A-7B and A-7C. In 1965, the USAF selected the A-7D as a replacement for its fast-jet F-100 and F-105 supersonic fighter-bombers in the close air support role. Though the USAF had wanted the TF30, Pratt & Whitney was unable to meet the production timetable because its facilities were already committed to producing other engines. Instead of producing the TF30 under license for P&W, the Allison Engine Company offered its own TF41 turbofan, a license-built version of the RB.168-25R Spey, to the Air Force.[8] The more powerful TF41 was selected by the USAF for the A-7D, and by the USN for its similar A-7E.[7]

F-14

A TF30-P-412A being prepared for installation in an F-14A Tomcat on board a carrier

The Grumman F-14 Tomcat with the TF30-P-414A was underpowered, because it was the Navy's intent to procure a jet fighter with a thrust-to-weight ratio (in clean configuration) of unity or better (the US Air Force had the same goals for the F-15 Eagle and F-16 Fighting Falcon). However, due to the intent to incorporate as many of the systems of the failed Navy version of the F-111, the F-111B, into the project, it was deemed that the initial production run of F-14s utilize the F-111B's powerplant. The F-14A's thrust-to-weight ratio was similar to the F-4 Phantom II; however the new fuselage and wing design provided greater lift and a better climb profile than the F-4. The TF30 was found to be ill-adapted to the demands of air combat and was prone to compressor stalls at high angle of attack (AOA) if the throttles were moved aggressively. Because of the Tomcat's widely spaced engine nacelles, compressor stalls at high AOA were especially dangerous because they tended to produce asymmetric thrust that could send the Tomcat into an upright or inverted spin, from which recovery was very difficult.

The F-14's problems did not afflict TF30 engines in the USAF and RAAF F-111s to nearly the same extent. The F-111, while technically designated as a "fighter," was actually used as a ground attack aircraft. A typical ground strike mission is characterized by less abrupt changes in throttle, angle of attack and altitude than an air-to-air combat mission. Though the F-14A entered service with the Navy powered by Pratt & Whitney TF30, by the end of the decade, following numerous problems with the original engine, the Department of Defense began procuring F110-GE-400 engines and installed them in the F-14A Plus (later redesignated to F-14B in 1991), which entered service with the fleet in 1988. These engines solved the reliability problems and provided nearly 30% more thrust, achieving a 1:1 dry thrust to weight ratio. The subsequent F-14D, a combination of both remanufactured/upgraded F-14As and new manufacture F-14Ds, also used F110-GE-400 engines.

Variants

Pratt & Whitney/SNECMA TF106
Pratt & Whitney/SNECMA TF306

Source:[9]

JTF10
Company designation for the TF30 family of engines
XTF30-P-1
YTF30-P-1
TF30-P-1
TF30-P-1A
TF30-P-2
TF30-P-3 (F-111C)
TF30-P-5
TF30-P-6
TF30-P-6A
TF30-P-6C
TF30-P-7
TF30-P-8
TF30-P-9
TF30-P-12
TF30-P-14
TF30-P-16
TF30-P-18
YTF30-P-100
TF30-P-100
TF30-P-103 (F-111C)
TF30-P-107 (F-111G)
TF30-P-108 (F-111G)
TF30-P-109 (F-111C,EF-111A)
TF30-P-109 RA (F-111C)
TF30-P-408
TF30-P-414
JTF10A-7
(TF30-P-2)
JTF10A-10
Pratt & Whitney/SNECMA TF106
A derivative of the TF30 to power the Dassault Mirage IIIV VTOL fighter.
Pratt & Whitney/SNECMA TF306
A derivative of the TF30 tested in the Dassault Mirage F2.

Applications

Source:[9]

TF30
TF104/TF106
TF306

Specifications (TF30-P-100)

Data from The Engines of Pratt & Whitney: A Technical History.[9]

General characteristics

Components

Performance

References

  1. 1 2 3 Connors 2010, p. 341
  2. ↑ http://www.flightglobal.com/pdfarchive/view/1968/1968%20-%200018.html TURBOFANS: A Survey of Current Airline Powerplants
  3. ↑ Donald 1999, p.609
  4. ↑ AERO ENGINES 1962
  5. ↑ Connors 2010, p.346
  6. ↑ F-111. Federation of American Scientists.
  7. 1 2 Connors 2010, p.347
  8. ↑ http://www.flightglobal.com/pdfarchive/view/1975/1975%20-%200025.html
  9. 1 2 3 Connors 2010, p. 344-345
  10. ↑ "F−14 TF30−P−414 TO F110−GE−400 ENGINE UPGRADE TECHNICAL COMPARISON" (PDF).

External links

Wikimedia Commons has media related to Pratt & Whitney TF30.
This article is issued from Wikipedia - version of the Tuesday, April 19, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.