Taras Kiceniuk, Jr.

Taras Kiceniuk, Jr (born c. May 14,1954) is a hang glider pioneer from southern California.

Kiceniuk began building hang gliders in 1971 while still in high school. At first he flew his gliders near Palomar Mountain where his father was curator of the Palomar Observatory but later began flying at Torrey Pines Glider Port in La Jolla. He soon moved from the traditional Rogallo wing design to a rigid flying wing biplane design he called Icarus. Icarus I is now at the Smithsonian Institution awaiting restoration and display. Kiceniuk set several endurance records with Icarus II. Icarus III and Icarus IV were abandoned in the design phase in favor of a monoplane configuration for Icarus V. Icarus V was a precursor to the modern rigid wing hang glider. In 2005 Icarus V was one of eight ultralight aircraft displayed at the Experimental Aircraft Association's Tribute to Ultralight Pioneers exhibit at their AirVenture Museum in Oshkosh, Wisconsin.

Kiceniuk was also a contender for the first Kremer Prize for human-powered flight. His human-powered aircraft was actually a ground effect vehicle that flew only inches above the ground. He later worked with Dr. Paul MacCready on MacCready's Gossamer Albatross.

Soaring Magazine, January 1972, showing an artist's conception (Actual photograph) of Kiceniuk flying Icarus I. The pilot flew in the shown position only during takeoff and landing. While cruising he would place his feet on the leading edge tube between the wings.

Kiceniuk Icarus I

The Kiceniuk Icarus I was a revolutionary hang glider designed, built and flown by Taras Kiceniuk, Jr. in the early 1970s.

At a time when most hang gliders used a flexible Rogallo wing, Icarus I used a rigid flying wing biplane configuration. Unlike other hang gliders of the time, the Icarus was not steered by the pilot shifting his body weight. Instead, Icarus I had two large rudders mounted near the wing tips, controlled by hand levers. These rudders made Icarus I much more maneuverable than other hang gliders. Pitch was controlled by the pilot shifting his body weight fore and aft. The pilot flew in a reclining position, rather than the prone position used by other hang gliders.

Icarus I is now at the Smithsonian Institution awaiting restoration and display.

Specifications

Kiceniuk Icarus II

The Kiceniuk Icarus II was the second in a series of hang gliders designed by Taras Kiceniuk, Jr.

Like Kiceniuk Icarus I, Icarus II was a rigid biplane flying wing. Its most notable improvement over Icarus I was that the wings were swept back more steeply. It was steered by hand controlled rudders, unlike Rogallo wing hang gliders of the time that were steered by the pilot shifting his body weight. Also unlike other hang gliders, the pilot flew in a sitting position rather than a prone position. The Federal Aviation Administration recognized Icarus II as an aircraft and issued a registration number for it; the Rogallo wing hang glider for NASA received FAA registration of N9765C.

Kiceniuk set several endurance records with Icarus II and many copies were built from plans he sold.

Specifications

PERFORMANCE


DIMENSIONS

Kiceniuk Icarus V

The Kiceniuk Icarus V was the fifth designed and third built in a series of hang gliders designed by Taras Kiceniuk, Jr.

Kiceniuk's Icarus I and Icarus II were revolutionary hang gliders. These were rigid biplane flying wings, with hand-controlled rudders, in which the pilot flew in a reclining position. This was at a time when most hang gliders were Rogallo wings that the pilot steered solely by shifting his body weight. Kiceniuk abandoned the designs for Icarus III and Icarus IV in favor of a monoplane configuration for Icarus V.

Icarus V was a swept wing, constant-chord, flying wing monoplane with a 32-foot (9.8 m) span. Construction was of cable-braced aluminum tubing covered with fabric. The leading edge had foam sheet formed over aluminum ribs. It had an efficient high-lift airfoil giving it a glide ratio of 10:1, which was remarkable for a hang glider (Rogallo wings were hardly more than steerable parachutes with glide ratios of around 3:1). Icarus V had hanging winglet rudders and was flown in a reclining position.

Many Icarus Vs were built from plans sold by Kiceniuk and it was also commercially produced by Free-Flight Systems, Inc. of Sylmar, California. The Icarus series, especially Icarus V, were instrumental in the development of the modern 'rigid wing' hang glider. Although its performance was astounding, the foldable, portable Rogallo flexible wings retained their popularity because the Rogallo wing dramatically reduced difficulty in storage, transport, assembly and repair. In addition, the flexible wing could always be redesigned to improve the performance far more easily than a rigid wing could be designed for portability. Hang gliders eventually evolved to a slender efficient wing like that of the Icarus V while retaining the portability of the Rogallo wing.

Kiceniuk's Icarus V from 1973 is one of eight ultralight aircraft displayed at the Experimental Aircraft Association's Tribute to Ultralight Pioneers exhibit at their AirVenture Museum in Oshkosh, Wisconsin.

Specifications

Patents

External links

This article is issued from Wikipedia - version of the Wednesday, April 13, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.