Trailer brake controller

A brake controller is usually an OEM or aftermarket installed device or module. It is mounted to the tow vehicle's driver's-side dashboard area, and engages a trailer’s electrical braking system either time delayed, or in proportion to the tow vehicle's brake engagement when slowing down or coming to a halt. A brake controller is not needed with a trailer surge braking system unless using modern electric over hydraulic devices. The trailer in this case usually has either electric friction brakes or electric-hydraulic trailer brake actuators.

Most basic brake controllers will generally have a +/- gain adjustment. The tow vehicle operator would set the gain as high as possible but without the trailer brakes locking up after making a few test stops. The heavier the trailer, the higher the gain adjustment would be set and therefore the less chances of wheel lock-up.[1]

A wide range of trailers will contain trailer brakes (for example; larger boat trailers, horse trailers, covered utility trailers, enclosed trailers, travel trailers including small 10-foot and longer tent trailers and car carriers). Smaller trailers may not contain trailer brakes (for example; basic 4'x8' utility trailers). It is highly recommended that, if the total trailer weight is over a couple thousand pounds, the trailer have some sort of braking system, and the tow vehicle be equipped with a brake controller.[2][3]

Types

There are a different types of brake controllers that are currently or previously on the market.

Air-actuated electric nrake controller

This controller uses the air pressure of the brake system on a vehicle with pneumatic brakes to provide a current to control the electric brakes of a trailer.[4]

Hydraulic over electric controller

This controller uses the hydraulic pressure of the brake system on a vehicle with hydraulic brakes to provide a current to control the electric brakes of a trailer.[5] Some truck manufacturers offers this as an OEM option, like Ford with its Ford TowCommand.

Pedal-mounted pressure pad proportional controller

A separate sensor is mounted on the brake pedal to connect to the controller.[6]

Proportional brake controller

Senses the deceleration of the vehicle through a pendulum or similar device to apply a suitable current for braking of the trailer.[7][8][9]

Surge brake

When the tow vehicle slows down the trailer pushes against it an actuator applies force to its master cylinder and the hydraulic pressure is transferred to the brakes[10]

Time-delayed brake controller

Applies brake current with a ramp-up over time to a certain level set by the driver.[8][9][11]

References

  1. ↑ "How to adjust a trailer brake controller".
  2. ↑ What You Should Know About Trailer Brakes 1951 Popular Science article that covers the basics very well.
  3. ↑ What You Should Know About Trailer Brakes, Popular Science, July 1969, pp. 111-113, an update of the 1951 article.
  4. ↑ "Hayes Air Actuated brake controller".
  5. ↑ "Maxbrake controller".
  6. ↑ "AL-KO Sensabrake controller".
  7. ↑ "Tekonsha proportional brake controllers".
  8. 1 2 "Curt brake controllers".
  9. 1 2 "Draw-Tite Proportional brake controllers".
  10. ↑ "Hydraulic Surge Trailer Brake Actuators". Retrieved 2014-11-21.
  11. ↑ "Hopkins brake controllers".
This article is issued from Wikipedia - version of the Thursday, April 28, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.