Von Neumann universal constructor

The first implementation of von Neumann's self-reproducing universal constructor.[1] Three generations of machine are shown: the second has nearly finished constructing the third. The lines running to the right are the tapes of genetic instructions, which are copied along with the body of the machines. The machine shown runs in a 32-state version of von Neumann's cellular automata environment, not his original 29-state specification.

John von Neumann's Universal Constructor is a self-replicating machine in a cellular automata (CA) environment. It was designed in the 1940s, without the use of a computer. The fundamental details of the machine were published in von Neumann's book Theory of Self-Reproducing Automata, completed in 1966 by Arthur W. Burks after von Neumann's death.[2]

Von Neumann's specification defined the machine as using 29 states, these states constituting means of signal carriage and logical operation, and acting upon signals represented as bit streams. A 'tape' of cells encodes the sequence of actions to be performed by the machine. Using a writing head (termed a construction arm) the machine can print out (construct) a new pattern of cells, allowing it to make a complete copy of itself, and the tape.

Purpose

Von Neumann's design has traditionally been understood to be a demonstration of the logical requirements for machine self-replication.[3] However it is clear that far simpler machines can achieve self-replication. Examples include trivial crystal-like growth, template replication and Langton's loops. But von Neumann was interested in something more profound: construction universality and evolution.[4]

This universal constructor can be seen as an abstract simulation of a physical universal assembler.

Note that the simpler self-replicating CA structures (especially, Byl's loop and the Chou–Reggia loop) cannot exist in a wide variety of forms and thus have very limited evolvability. Other CA structures such as the Evoloop are somewhat evolvable but still don't support open-ended evolution. Commonly, simple replicators do not fully contain the machinery of construction, there being a degree to which the replicator is information copied by its surrounding environment. Although the Von Neumann design is a logical construction, it is in principle a design that could be instantiated as a physical machine. The issue of the environmental contribution to replication is somewhat open, since there are different conceptions of raw material and its availability.

The concept of a universal constructor is non-trivial because of the existence of garden of eden patterns. But a simple definition is that a universal constructor is able to construct any finite pattern of non-excited (quiescent) cells.

Von Neumann's crucial insight is that part of the replicator has a double use; being both an active component of the construction mechanism, and being the target of a passive copying process. This part is played by the tape of instructions in Von Neumann's combination of universal constructor plus instruction tape.

The combination of a universal constructor and a tape of instructions would i) allow self-replication, and also ii) guarantee that the open-ended complexity growth observed in biological organisms was possible.[3] The image below illustrates this possibility.

This insight is all the more remarkable because it preceded the discovery of the structure of the DNA molecule by Watson and Crick, though it followed the Avery–MacLeod–McCarty experiment which identified DNA as the molecular carrier of genetic information in living organisms.[5] The DNA molecule is processed by separate mechanisms that carry out its instructions and copy the DNA for insertion for the newly constructed cell. The ability to achieve open-ended evolution lies in the fact that, just as in nature, errors (mutations) in the copying of the genetic tape can lead to viable variants of the automaton, which can then evolve via natural selection.

A demonstration of the ability of von Neumann's machine to support inheritable mutations. (1) At an earlier timestep, a mutation was manually added to the second generation machine's tape. (2) Later generations both display the phenotype of the mutation (a drawing of a flower) and pass the mutation on to their children, since the tape is copied each time. This example illustrates how von Neumann's design allows for complexity growth (in theory) since the tape could specify a machine that is more complex than the one making it.

Implementation

Arthur Burks and others extended the work of von Neumann, giving a much clearer and complete set of details regarding the design and operation of von Neumann's self-replicator. The work of J. W. Thatcher is particularly noteworthy, for he greatly simplified the design. Still, their work did not yield a complete design, cell by cell, of a configuration capable of demonstrating self-replication.

Renato Nobili and Umberto Pesavento published the first fully implemented self-reproducing cellular automaton in 1995, nearly fifty years after von Neumann's work.[1][6] They used a 32-state cellular automaton instead of von Neumann's original 29-state specification, extending it to allow for easier signal-crossing, explicit memory function and a more compact design. They also published an implementation of a general constructor within the original 29-state CA but not one capable of complete replication - the configuration cannot duplicate its tape, nor can it trigger its offspring; the configuration can only construct.[6][7]

In 2004, D. Mange et al. reported an implementation of a self-replicator that is consistent with the designs of von Neumann.[8]

In 2007, Nobili published a 32-state implementation that uses run-length encoding to greatly reduce the size of the tape.[9]

In 2008, William R. Buckley published two configurations which are self-replicators within the original 29-state CA of von Neumann.[7] Buckley claims that the crossing of signal within von Neumann 29-state cellular automata is not necessary to the construction of self-replicators.[7] Buckley also points out that for the purposes of evolution, each replicator should return to its original configuration after replicating, in order to be capable (in theory) of making more than one copy. As published, the 1995 design of Nobili-Pesavento does not fulfill this requirement but the 2007 design of Nobili does; the same is true of Buckley's configurations.

In 2009, Buckley published with Golly a third configuration for von Neumann 29-state cellular automata, which can perform either holistic self-replication, or self-replication by partial construction. This configuration also demonstrates that signal crossing is not necessary to the construction of self-replicators within von Neumann 29-state cellular automata.

C. L. Nehaniv in 2002, and also Y. Takada et al. in 2004, proposed a universal constructor directly implemented upon an asynchronous cellular automaton, rather than upon a synchronous cellular automaton. [10] [11]

Comparison of implementations

implementation source ruleset rectangular area number of cells length of tape ratio timesteps for replication tape code compression tape code length tape code type replication mechanism replication type growth rate
Nobili-Pesavento, 1995 [1] [12] Nobili 32-state 97 × 170 6,329 145,315 22.96 6.34 × 1010 none 5 bits binary holistic constructor non-repeatable linear
Nobili, 2007 SR_CCN_AP.EVN [13] Nobili 32-state 97 × 100 5,313 56,325 10.60 9.59 × 109 run-length limited encoding 5 bits binary holistic constructor repeatable super-linear
Buckley, 2008 codon5.rle [14] Nobili 32-state 112 × 50 3,343 44,155 13.21 5.87 x 109 auto-retraction 5 bits binary holistic constructor repeatable linear
Buckley, 2008[7] replicator.mc [15] von Neumann 29-state 312 × 132 18,589 294,844 15.86 2.61 × 1011 auto-retraction 5 bits binary holistic constructor repeatable linear
Buckley, 2008 codon4.rle [14] Nobili 32-state 109 × 59 3,574 37,780 10.57 4.31 x 109 auto-retraction/bit generation 4 bits binary holistic constructor repeatable linear
Buckley, 2009 codon3.rle Nobili 32-state 116 × 95 4,855 23,577 4.86 1.63 x 109 auto-retraction/bit generation/code overlay 3 bits binary holistic constructor repeatable super-linear
Buckley, 2009 PartialReplicator.mc [14] von Neumann 29-state 2063 × 377 264,321 NA - ~1.12 x 1014 none 4 bits binary partial constructor repeatable linear
Goucher & Buckley, 2012 phi9.rle [16] Nobili 32-state 122 × 60 3957 8920 2.25 - auto-retraction/bit generation/code overlay/run length limited 3+ bits ternary holistic constructor repeatable super-linear

As defined by von Neumann, universal construction entails the construction of passive configurations, only. As such, the concept of universal construction constituted nothing more than a literary (or, in this case, mathematical) device. It facilitated other proof, such as that a machine well constructed may engage in self-replication, while universal construction itself was simply assumed over a most minimal case. Universal construction under this standard is trivial. Hence, while all the configurations given here can construct any passive configuration, none can construct the real-time crossing organ devised by Gorman.[7]

Practicality

Computational cost

All the implementations of von Neumann's self-reproducing machine require considerable resources to run on computer. For example, in the Nobili-Pesavento 32-state implementation shown above, while the body of the machine is just 6,329 non-empty cells (within a rectangle of size 97x170), it requires a tape that is 145,315 cells long, and takes 63 billion timesteps to replicate. A simulator running at 1,000 timesteps per second would take over 2 years to make the first copy. In 1995, when the first implementation was published, the authors had not seen their own machine replicate. However, in 2008, the hashlife algorithm was extended to support the 29-state and 32-state rulesets in Golly. On a modern desktop PC, replication now takes only a few minutes, although a significant amount of memory is required.

Evolvability

Von Neumann's stated problem was evolution:[4] how is the complexity growth and evolvability of biological organisms possible? His machine shows how it is logically possible, by using a universal constructor, but does not show how it is possible in practice. In his unfinished work he briefly considers conflict and interactions between replicators [17] but in practice his model is not likely to become a useful unit of evolution because it is too fragile.[3]

Animation gallery

See also

References

  1. 1 2 3 Pesavento, Umberto (1995), "An implementation of von Neumann's self-reproducing machine" (PDF), Artificial Life (MIT Press) 2 (4): 337–354, doi:10.1162/artl.1995.2.337, PMID 8942052, archived from the original (PDF) on 2007-04-18
  2. ↑ von Neumann, John; Burks, Arthur W. (1966), Theory of Self-Reproducing Automata., www.walenz.org, archived from the original (Scanned book online) on 2008-01-05, retrieved 2008-02-29
  3. 1 2 3 McMullin, B. (2000), "John von Neumann and the Evolutionary Growth of Complexity: Looking Backwards, Looking Forwards...", Artificial Life 6 (4): 347–361, doi:10.1162/106454600300103674, PMID 11348586
  4. 1 2 Archived June 13, 2008, at the Wayback Machine.
  5. ↑ Rocha, Luis M., "Von Neumann and Natural Selection.", Lecture Notes of I-585-Biologically Inspired Computing Course, Indiana University (PDF)
  6. 1 2 Nobili, Renato; Pesavento, Umberto (1996), "Generalised von Neumann's Automata", in Besussi, E.; Cecchini, A., Proc. Artificial Worlds and Urban Studies, Conference 1 (PDF), Venice: DAEST
  7. 1 2 3 4 5 Buckley, William R. (2008), "Signal Crossing Solutions in von Neumann Self-replicating Cellular Automata", in Andrew Adamatzky, Ramon Alonso-Sanz, Anna Lawniczak, Genaro Juarez Martinez, Kenichi Morita, Thomas Worsch, Proc. Automata 2008 (PDF), Luniver Press, pp. 453–503
  8. ↑ Mange, Daniel; Stauffer, A.; Peparaolo, L.; Tempesti, G. (2004), "A Macroscopic View of Self-replication", Proceedings of the IEEE 92 (12): 1929–1945, doi:10.1109/JPROC.2004.837631
  9. ↑
  10. ↑ Nehaniv, Chrystopher L. (2002), "Self-Reproduction in Asynchronous Cellular Automata", 2002 NASA/DoD Conference on Evolvable Hardware (15-18 July 2002, Alexandria, Virginia, USA), IEEE Computer Society Press, pp. 201–209
  11. ↑ Takada, Yousuke; Isokawa, Teijiro; Peper, Ferdinand; Matsui, Nobuyuki (2004), "Universal Construction on Self-Timed Cellular Automata", in Sloot, P.M.A., ACRI 2004, LNCS 3305, pp. 21–30
  12. ↑ "Von Neumann's Self-Reproducing Universal Constructor".
  13. ↑ The Cellular Automata of John von Neumann
  14. 1 2 3 andykt. "Golly, a Game of Life simulator". SourceForge.
  15. ↑
  16. ↑ "Self-replication". Complex Projective 4-Space.
  17. ↑ Archived June 22, 2008, at the Wayback Machine.

External links

This article is issued from Wikipedia - version of the Wednesday, April 06, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.