Wheel tractor-scraper

A twin engined Terex TS-14b scraper in Hudson, Ohio

In civil engineering, a wheel tractor-scraper is a piece of heavy equipment used for earthmoving. The rear part of the scraper has a vertically moveable hopper with a sharp horizontal front edge which can be raised or lowered. The front edge cuts into the soil, like a carpenter's plane cutting wood, and fills the hopper. When the hopper is full it is raised, closed, and the scraper can transport its load to the fill area where it is dumped. With a type called an 'elevating scraper' a conveyor belt moves material from the cutting edge into the hopper.

Design

The scraper is a large piece of equipment which is used in mining, construction, agriculture and other earthmoving applications. The rear part has a vertically moveable hopper (also known as the bowl) with a sharp horizontal front edge. The hopper can be hydraulically lowered and raised. When the hopper is lowered, the front edge cuts into the soil or clay like a plane and fills the hopper. When the hopper is full (8 to 34 m³ or 10 to 44 cu yd heaped, depending on type) it is raised, and closed with a vertical blade (known as the apron). The scraper can transport its load to the fill area where the blade is raised, the back panel of the hopper, or the ejector, is hydraulically pushed forward and the load tumbles out. Then the empty scraper returns to the cut site and repeats the cycle.

Caterpillar 613C elevating scraper

On the 'elevating scraper' the bowl is filled by a type of conveyor arrangement fitted with a horizontal flights to move the material engaged by the cutting edge into the bowl as the machine moves forward. Elevating scrapers do not require assistance from push-tractors. The pioneer developer of the elevating scraper was Hancock Manufacturing Company of Lubbock, Texas USA. Self-propelled scrapers were invented by R. G. LeTourneau in the 1930s.^[1] His company called them Tournahoppers. This concept was further developed by LeTourneau Westinghouse Company.^[2] Most current scrapers have two axles, although historically tri-axle configurations were dominant.

Scrapers can be very efficient on short hauls where the cut and fill areas are close together and have sufficient length to fill the hopper. The heavier scraper types have two engines ("tandem powered"), one driving the front wheels, one driving the rear wheels, with engines up to 400 kW (536 hp). Multiple scrapers can work together in a push-pull fashion but this requires a long cut area.

Configurations

A Caterpillar towed scraper parked up

• Open bowl: usually requires a push-cat (bulldozer or similar) to assist in loading.
• Elevating scraper: self loading as it uses an elevator to load material; requires no push-cat.
• Tandem scrapers: separate tractor and scraper engines provide better traction in steep or slippery areas; a push cat is required except when loading loose materials.
• Tandem Push-Pull: concentrates the combined horsepower of two such machines onto one cutting edge. The push-pull attachment allows two individual scrapers to act as a self-loading system, typically loading both machines in less than a minute, one after the other.
• Auger: uses vertically mounted auger in the bowl to pull material upwards.
• Pull type scraper: uses agricultural tractor, articulated dump truck, or bulldozer to pull. Pull type scrapers can be utilized individually or two or three units can be pulled behind a single tractor.

See also

• Fresno scraper: a horse pulled device that is he ancestor of modern scrapers
• Grader: Resembles a scraper with out the hopper that spreads out excess material.
• Laser Machine Control

References

1. LeTourneau earthmovers, Eric C. Orlemann, MBI, ISBN 0-7603-0840-3
2. The Wabco Archive Wheel-Tractor Scrapers (Global General Publishing Pty Ltd,2011) ISBN 978-0-9871503-0-1