Wing loading

In aerodynamics, wing loading is the loaded weight of the aircraft divided by the area of the wing.[1] The faster an aircraft flies, the more lift is produced by each unit of wing area, so a smaller wing can carry the same weight in level flight, operating at a higher wing loading. Correspondingly, the landing and takeoff speeds will be higher. The high wing loading also decreases maneuverability. The same constraints apply to winged biological organisms.

A highly loaded wing on a Lockheed F-104 Starfighter
A very low wing loading on a flexible-wing hang glider

Range of wing loadings

AircraftBuzz Z3[2][3]Fun 160[4]ASK 21Nieuport 17Ikarus C42Cessna 152Vans RV-4DC-3SpitfireBf-109B-17B-36Eurofighter TyphoonF-104A380B747MD-11F
Wing loading
(kg/m2)
3.96.33338384967123158173190272311514663740844
Wing loading
(lb/ft2)
0.81.36.87.87.81014273235395664105136152173
Role paragliderhang glidergliderWWI fightermicrolighttrainersportsairlinerWWII fighterWWII fighterWWII bombertrans-Atlantic jet bombermulti-role fighter jet interceptor large airlinerlarge airlinermedium-long range airliner
Year introduced 20102007197919161997197819801936193819371938194920031958200719701990

The table, which shows wing loadings, is intended to give an idea of the range of wing loadings used by aircraft. Maximum weights have been used. There will be variations amongst variants of any particular type. The dates are approximate, indicating period of introduction.

The upper critical limit for bird flight is about 5 lb/ft2 (25 kg/m2).[5] An analysis of bird flight which looked at 138 species ranging in mass from 10 g to 10 kg, from small passerines to swans and cranes found wing loadings from about 1 to 20 kg/m2.[6] The wing loadings of some of the lightest aircraft fall comfortably within this range. One typical hang glider (see table) has a maximum wing loading of 6.3 kg/m2, and an ultralight rigid glider[7] 8.3 kg/m2.

Effect on performance

Wing loading is a useful measure of the general maneuvering performance of an aircraft. Wings generate lift owing to the motion of air over the wing surface. Larger wings move more air, so an aircraft with a large wing area relative to its mass (i.e., low wing loading) will have more lift available at any given speed. Therefore, an aircraft with lower wing loading will be able to take off and land at a lower speed (or be able to take off with a greater load). It will also be able to turn at a higher speed.

Effect on takeoff and landing speeds

Quantitatively, the lift force L on a wing of area A, traveling at speed v is given by

\textstyle\frac{L}{A}=\tfrac{1}{2}v^2\rho C_L,

Where ρ is the density of air and CL is the lift coefficient. The latter is a dimensionless number of order unity which depends on the wing cross-sectional profile and the angle of attack. At take-off or in steady flight, neither climbing or diving, the lift force and the weight are equal. With L/A = Mg/A =WSg, where M is the aircraft mass, WS = M/A the wing loading (in mass/area units, i.e. lb/ft2 or kg/m2, not force/area) and g the acceleration due to gravity, that equation gives the speed v through

\textstyle v^2=\frac {2gW_S} {\rho C_L} .

As a consequence, aircraft with the same CL at takeoff under the same atmospheric conditions will have takeoff speeds proportional to \scriptstyle\sqrt {W_S}. So if an aircraft's wing area is increased by 10% and nothing else changed, the takeoff speed will fall by about 5%. Likewise, if an aircraft designed to take off at 150 mph grows in weight during development by 40%, its takeoff speed increases to \scriptstyle150 \sqrt{1.4} = 177 mph.

Some flyers rely on their muscle power to gain speed for takeoff over land or water. Ground nesting and water birds have to be able to run or paddle at their takeoff speed and the same is so for a hang glider pilot, though he or she may get an assist from a downhill run. For all these a low WS is critical, whereas passerines and cliff dwelling birds can get airborne with higher wing loadings.

Effect on climb rate and cruise performance

Wing loading has an effect on an aircraft's climb rate. A lighter loaded wing will have a superior rate of climb compared to a heavier loaded wing as less airspeed is required to generate the additional lift to increase altitude. A lightly loaded wing has a more efficient cruising performance because less thrust is required to maintain lift for level flight. However, a heavily loaded wing is more suited for higher speed flight because smaller wings offer less drag.

The second equation given above applies again to the cruise in level flight, though \rho and particularly CL will be smaller than at take-off, CL because of a lower angle of incidence and the retraction of flaps or slats; the speed needed for level flight is lower for smaller WS.

The wing loading is important in determining how rapidly the climb is established. If the pilot increases the speed to vc the aircraft will begin to rise with vertical acceleration ac because the lift force is now greater than the weight. Newton's second law tells us this acceleration is given by

\textstyle Ma_c=\tfrac{1}{2}v_c^2\rho C_LA -Mg

or

\textstyle a_c=\frac{1}{2W_S}v_c^2\rho C_L -g,

so the initial upward acceleration is inversely proportional (reciprocal) to WS. Once the climb is established the acceleration falls to zero as the sum of the upward components of lift plus engine thrust minus drag becomes numerically equal to the weight.

Effect on turning performance

To turn, an aircraft must roll in the direction of the turn, increasing the aircraft's bank angle. Turning flight lowers the wing's lift component against gravity and hence causes a descent. To compensate, the lift force must be increased by increasing the angle of attack by use of up elevator deflection which increases drag. Turning can be described as 'climbing around a circle' (wing lift is diverted to turning the aircraft) so the increase in wing angle of attack creates even more drag. The tighter the turn radius attempted, the more drag induced, this requires that power (thrust) be added to overcome the drag. The maximum rate of turn possible for a given aircraft design is limited by its wing size and available engine power: the maximum turn the aircraft can achieve and hold is its sustained turn performance. As the bank angle increases so does the g-force applied to the aircraft, this having the effect of increasing the wing loading and also the stalling speed. This effect is also experienced during level pitching maneuvers.[8]

Aircraft with low wing loadings tend to have superior sustained turn performance because they can generate more lift for a given quantity of engine thrust. The immediate bank angle an aircraft can achieve before drag seriously bleeds off airspeed is known as its instantaneous turn performance. An aircraft with a small, highly loaded wing may have superior instantaneous turn performance, but poor sustained turn performance: it reacts quickly to control input, but its ability to sustain a tight turn is limited. A classic example is the F-104 Starfighter, which has a very small wing and high wing loading. At the opposite end of the spectrum was the gigantic Convair B-36. Its large wings resulted in a low wing loading, and there are disputed claims that this made the bomber more agile than contemporary jet fighters (the slightly later Hawker Hunter had a similar wing loading of 250 kg/m2) at high altitude. Whatever the truth in that, the delta winged Avro Vulcan bomber, with a wing loading of 260 kg/m2 could certainly be rolled at low altitudes.[9]

Like any body in circular motion, an aircraft that is fast and strong enough to maintain level flight at speed v in a circle of radius R accelerates towards the centre at \scriptstyle\frac{v^2} {R}. That acceleration is caused by the inward horizontal component of the lift, \scriptstyle L sin\theta, where \theta is the banking angle. Then from Newton's second law,

\textstyle\frac{Mv^2}{R}=L\sin\theta=\frac{1}{2}v^2\rho C_L A\sin\theta.

Solving for R gives

\textstyle R=\frac{2W_s}{\rho C_L\sin\theta}.

The smaller the wing loading, the tighter the turn.

Gliders designed to exploit thermals need a small turning circle in order to stay within the rising air column, and the same is true for soaring birds. Other birds, for example those that catch insects on the wing also need high maneuverability. All need low wing loadings.

Effect on stability

Wing loading also affects gust response, the degree to which the aircraft is affected by turbulence and variations in air density. A small wing has less area on which a gust can act, both of which serve to smooth the ride. For high-speed, low-level flight (such as a fast low-level bombing run in an attack aircraft), a small, thin, highly loaded wing is preferable: aircraft with a low wing loading are often subject to a rough, punishing ride in this flight regime. The F-15E Strike Eagle has a wing loading of 650 kg/m2 (excluding fuselage contributions to the effective area), as have most delta wing aircraft (such as the Dassault Mirage III, for which WS = 387 kg/m2) which tend to have large wings and low wing loadings.

Quantitatively, if a gust produces an upward pressure of G (in N/m2, say) on an aircraft of mass M, the upward acceleration a will, by Newton's second law be given by

\textstyle a=\frac {GA} {M}=\frac {G} {W_S} ,

decreasing with wing loading.

Effect of development

A further complication with wing loading is that it is difficult to substantially alter the wing area of an existing aircraft design (although modest improvements are possible). As aircraft are developed they are prone to "weight growth" -- the addition of equipment and features that substantially increase the operating mass of the aircraft. An aircraft whose wing loading is moderate in its original design may end up with very high wing loading as new equipment is added. Although engines can be replaced or upgraded for additional thrust, the effects on turning and takeoff performance resulting from higher wing loading are not so easily reconciled.

Water ballast use in gliders

Modern gliders often use water ballast carried in the wings to increase wing loading when soaring conditions are strong. By increasing the wing loading the average speed achieved across country can be increased to take advantage of strong thermals. With a higher wing loading, a given lift-to-drag ratio is achieved at a higher airspeed than with a lower wing loading, and this allows a faster average speed across country. The ballast can be ejected overboard when conditions weaken.[10] (See Gliding competitions)

Design considerations

Fuselage lift

The F-15E Strike Eagle has a large relatively lightly loaded wing

A blended wing-fuselage design such as that found on the F-16 Fighting Falcon or MiG-29 Fulcrum helps to reduce wing loading; in such a design the fuselage generates aerodynamic lift, thus improving wing loading while maintaining high performance.

Variable-sweep wing

Aircraft like the F-14 Tomcat and the Panavia Tornado employ variable-sweep wings. As their wing area varies in flight so does the wing loading (although this is not the only benefit). When the wing is in the forward position takeoff and landing performance is greatly improved.[11]

Fowler flaps

The use of Fowler flaps increases the wing area, decreasing the wing loading, which allows slower takeoff and landing speeds.

See also

References

Notes

Bibliography

External links

This article is issued from Wikipedia - version of the Friday, April 01, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.