Zig zag revolver

Zig Zag
Type Revolver
Place of origin  Japan
Production history
Designer Yoshitomo Imura
Designed 2014
Specifications
Cartridge .38 Special
Action Single-action revolver
Feed system 6-round cylinder
Sights None

The Zig Zag revolver is a 3D printed .38-caliber pepperbox type revolver made public in May 2014.[1][2][2] It was created using a $500 plastic 3D-printer, however the name of the printer was not revealed by the creator.[2] It was created by a Japanese citizen from Kawasaki named Yoshitomo Imura[2] He was arrested in May 2014 after he had posted a video online of himself firing a 3D printed Zig Zag revolver.[1] It is the first known 3D printed gun design from Japan.[2]

It holds a capacity of 6 bullets and can fire .38 caliber bullets.[3] The grip of the weapon is based on the Mauser C96 and the fact that the weapon fires from the bottom of the barrel is based on the Mateba Autorevolver.[4]

After Imura's arrest a gun called the Imura Revolver was designed and printed by FOSSCAD members and was named in honor of Yoshitomo Imura.[5]

Name

The creator decided to call it the Zig Zag, after its ratcheted barrel modeled on the Mauser Zig-Zag.[3]

Assembly

According to the Wired Magazine "Imura assembles the handgun from plastic 3-D printed pieces, a few metal pins, screws and rubber bands, then test fires it with blanks".[3]

Operating Cycle

To fire, the operator loads the rounds into the barrel, and re-attaches the barrel to the rest of the weapon. Once reattached, the operator pulls back the slide where the firing pin is attached, pulls the trigger, which releases the slide into the round, firing the weapon.[4]

See also

References

This article is issued from Wikipedia - version of the Tuesday, May 12, 2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.