NYC Niagara

NYC Niagara

Niagara #6015 in Indianapolis, Indiana, June 30, 1956, soon before retirement
Type and origin
Power type Steam
Builder Alco-Schenectady
Build date 1945–1946
Total produced 27
Specifications
Configuration 4-8-4
Gauge 4 ft 8 12 in (1,435 mm)
Driver dia. 79 in (2.007 m)
Length 115 ft 5 12 in (35.19 m)
Axle load 32 long tons (32.5 t)
Total weight 405 long tons (411 t)
Fuel type Coal
Fuel capacity 92,000 lb (42 t)
Water cap 18,000 US gal (68,000 l; 15,000 imp gal)
Boiler pressure 275 psi (1.90 MPa)
Cylinders Two
Cylinder size 25.5 in × 32 in (648 mm × 813 mm)
Valve gear Baker
Performance figures
Power output 6,700 hp (5,000 kW)
Tractive effort 61,570 lbf (273.9 kN)
Career
Operators New York Central Railroad
Class S-1a, S-1b, S-2a
Number in class S-1a (1), S-1b (25); S-2a (1)
Numbers 6000 (S-1a);
6001–6025 (S-1b);
5500 (S-2a)
Disposition All scrapped

The New York Central Railroad's Niagara was a steam locomotive named after the Niagara River and Falls. It had a wheel arrangement of 4-8-4 in the Whyte notation and is considered as one of the most efficient 4-8-4 ever built.

The first New York Central Railroad Northern (or 4-8-4) was ordered in 1931: #800, an experimental locomotive that had its boiler divided into three sections of different pressure. This was another failed experiment in high pressure steam locomotives.

By the 1940s loads being hauled on the New York Central main line from New York to Chicago were as much as the famous J-class NYC Hudson 4-6-4's could handle. The Chief of Motive Power for the railroad, Paul W. Kiefer, decided to order some 4-8-4's which could sustain 6,000 horsepower (4,500 kW) on the run between the two cities, day after day without respite.

The American Locomotive Company ALCO proposed these locomotives, and although the design owes something to the Union Pacific 4-8-4's, of which Union Pacific 844 is the best-known, the design was actually quite new. Some steam experts have claimed the Niagara to be the ultimate locomotive, as it had the speed of an FEF (the Union Pacific's nickname for their 'four eight fours' was FEF) and the power of Northerns with smaller driver wheels.

Locomotive details

The first Niagara was Class S-1a #6000 in 1945; the S-1b (6001-6025) were delivered in 1945-46. The NYC's last steam locomotive was Class S-2 #5500; it had poppet valves. The Niagaras did not have steam domes, as did most steam locomotives, which resulted in a smooth contour along the top of the boiler. A perforated pipe collected steam instead. This was necessary because of the lower loading gauge of the New York Central (15 ft 2 in versus 16 ft 2 in (4.93 m) for other American railroads).

These locomotives had a small water capacity (18,000 US gallons; 68,000 litres) in the tender, because the New York Central was one of the few in North America which used track pans. This allowed a larger coal capacity—46 tons—so the New York to Chicago run could be done with one stop for coal. (The stop was said to be at Wayneport, New York, 14 miles east of Rochester, but that would leave 603 miles to Chicago via the Cleveland lakefront.)

On test these locomotives reached 6,600 hp (4,900 kW) in the cylinders, and ran 26,000 miles per month.

All bearings were either roller bearings or needle rollers.

Maintenance

The six days per week running schedule of these locomotives meant that all of the maintenance work normally done over the course of that week would have to be done on one day. This meant a specialized system was developed, where men in "hot suits" (asbestos heat-resistant coveralls) entered the firebox while the locomotive was still in steam and cleared all of the tubes, repaired the brick arch, etc. As the temperature inside the firebox itself would have been well over 100 degrees Celsius (212 F), and the working area these maintenance workers would have been standing on was the still-hot firebars of the grate, all references describe these workers as 'heroic' (reference: pages 172 ~ 173 The Great Book of Trains, Brian Hollingsworth and Arthur Cook (Bedford Editions, Salamander Books, 1987) )

This type of intensive maintenance was studied by steam locomotive designers such as Andre Chapelon, Livio Dante Porta, and David Wardale. These designers based their modern steam locomotives on the experience gained in these Niagara-class locomotives: reliability; and a close attention to details leading to a reduction in maintenance costs.

The 1946 steam-versus-diesel trials

Six of these locomotives were chosen by their designer, Paul W. Kiefer, for the famous 1946 Steam Versus Diesel road trials, where the 6,000 hp (4,500 kW) Niagaras were put up against some 4,000 hp (3,000 kW) diesels (E7's). The locomotives were run along the 928.1 miles (1,493.6 km) from New York (Harmon) to Chicago, via Albany, Syracuse, Rochester, Buffalo, Cleveland, Toledo and Elkhart, and return. The results were close:

Cost comparison Steam versus diesel, 1946 NYC road trials
Running from New York (Harmon) to Chicago (928.1 miles or 1,493.6 km) and return
Note: dollar figures quoted in 1946 US dollars.
To get 2007 US dollar figures, multiply by 10.66
Steam S-1 'Niagara'
(six locomotives)
Diesel E7 4,000 bhp two unit
(six locomotives)
Diesel E7 6,000 bhp Three Unit
(estimated by New York Central)
Approximate relative first costs
(as at December, 1946)
100% 147% 214%
Total drawbar horsepower 5,000 hp 3,320 dbhp 4,980 dbhp
Relative first cost,
in dollars per horsepower
100% 265% 258%
Total annual mileage per locomotive 288,000
(310 trips per annum)
324,000
(349 trips per annum)
324,000
(349 trips per annum)
COST PER LOCOMOTIVE Actual As
percentage
of total
Actual As
percentage
of total
Estimated
(by New
York Central)
As
percentage
of total
Repairs $102,528 31.48% $114,048 35.6% $162,000 38.4%
Fuel $118,080 36.26% $90,720 28.3% $136,080 32.3%
Water $8,928 2.74% $1,296 0.4% $1,620 0.4%
Lubrication $3,168 0.97% $9,720 3.0% $14,580 3.5%
Other Supplies $1,440 0.44% $648 0.2% $648 0.2%
Enginehouse Expense $28,800 8.84% $32,400 10.1% $32,400 7.7%
Crew Wages (Two men) $55,987 17.19% $64,120 20.0% $66,290 15.7%
Vacation Allowance (3%) $1,670 0.51% $1,912 0.6% $1,976 0.5%
Social Security & Unemployment Tax (8.75%) $5,040 1.55% $5,767 1.8% $5,962 1.4%
Total Cost Per Mile (Operating) $1.1307 $0.9896 $1.3011
Total Annual Operating Cost $325,642 $320,630 $421,556
Fixed Charges
(Interest, depreciation, insurance)
$24,453 $38,841 $56,640
Total Annual Cost Per Locomotive $350,095 $359,471 $478,196
Total Annual Cost Per Mile Per Locomotive $1.22 $1.11 $1.48
Total Annual Cost Per Locomotive Drawbar Horsepower $58.35 $108.27 $96.02

The above is based on a table in Paul W. Kiefer (1947). A Practical Evaluation of Railroad Motive Power. Steam Locomotive Research Institute Inc., New York. . Kiefer only claimed 5050 drawbar horsepower from a 79-inch 4-8-4, and the last line (dollars/power) has been added.

The results were much closer than the diesel salesmen were comfortable with, but these steam locomotives were hampered by several factors: a series of coal miners' strikes; aggressive dieselization sales efforts; and a failure of the highly-expensive firebox-wrapper metallurgy to withstand the conditions of actual operation. (reference: pages 172 ~ 173 The Great Book of Trains, Brian Hollingsworth and Arthur Cook (Bedford Editions, Salamander Books, 1987) )

Disposition

None of the NYC Niagara units survive. As the firebox wrappers failed, the locomotives were withdrawn, and eventually all were scrapped. According to the following, the retirement dates are below:

http://madisonrails.railfan.net/lewman31_niagaras_retired.html

May 1955 - Niagaras 6000-6025 (26 engines) still on roster. (5500 had been retired 1951).

August 1955: 19 Niagaras retired, leaving 6000, 6007, 6015, 6019, 6020, 6023, 6024.

November 1955: 6007 retired.

March 1956: 6000, 6019, 6020, 6023, 6024 retired, leaving only 6015.

June 30, 1956: Last run of 6015 in passenger service, Train No. 416, Indianapolis to Cincinnati on account of a diesel failure. Departed Indianapolis 34 minutes late, arrived Cincinnati 6 minutes late.

July 2, 1956, Returned to Indianapolis in freight service, train CC-3. Final run.

The dates of scrapping are unknown at this stage, but this was believed to have occurred at Granite City (near St. Louis).

Replicas

See also

References

This article is issued from Wikipedia - version of the Saturday, March 19, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.