Pere Marquette 1225

Pere Marquette 1225
Type and origin
Power type Steam
Builder Lima Locomotive Works
Serial number 7839
Build date December 6, 1941
Specifications
Configuration 2-8-4
UIC class 1′D2′ h2
Gauge 4 ft 8 12 in (1,435 mm) standard gauge
Driver dia. 69 in (1,753 mm)
Length 101 ft 8 in (30.99 m)
Adhesive weight 277,600 lb (125,900 kg)
Loco weight 442,500 lb (200,700 kg)
Total weight 727,300 lb (329,900 kg)
Fuel type Coal
Fuel capacity 44,000 lb (20,000 kg)
Water cap 22,000 US gal (83,000 l; 18,000 imp gal)
Fuel consumption 1 short ton (0.89 long tons) of coal per 12 miles traveled (1 metric ton per 21 km)
Firebox:
  Firegrate area
90.3 sq ft (8.4 m2)
Boiler pressure 245 psi (1.69 MPa)
Cylinders Two
Cylinder size 26 in × 34 in (660 mm × 864 mm)
Performance figures
Power output At cylinders: 2,979 hp (2.22 MW)
Tractive effort 69,368 lbf (308.6 kN)
Factor of adh 4.00
Career
Operators
Class
  • PM: N-1
  • C&O: N-1
Number in class 10 of 12
Numbers
  • PM 1225
  • C&O 2659
Locale Michigan
Retired 1951
Restored 1985
Current owner
Disposition Operational, based on Owosso, Michigan, Steam Railroading Institute
Pere Marquette Railway Steam Locomotive No. 1225
NRHP Reference # 94000744[1]
Added to NRHP July 31, 1994

Pere Marquette 1225 is a 2-8-4 (Berkshire) steam locomotive built for Pere Marquette Railway (PM) by Lima Locomotive Works in Lima, Ohio. 1225 is one of two surviving Pere Marquette 2-8-4 locomotives, the other being 1223 which is on display at the Tri-Cities Historical Society near ex-GTW coaling tower, in Grand Haven, MI. Nickel Plate 765 (operated by the Fort Wayne Railroad Historical Society, Inc) is also a Lima built Berkshire very similar in appearance and specifications to the Pere Marquette engines.

The Pere Marquette Railroad used 1225 in regular service from the locomotive's construction in 1941 until the railroad merged into Chesapeake and Ohio Railway (C&O) in 1947; it remained in use on C&O's Michigan lines until 1951. Slated for scrapping, 1225 was acquired by Michigan State University in 1957 and placed on static display.

In 1971, work began to restore 1225 to operation, an effort that culminated in its first excursion run in 1988. The locomotive, listed on the National Register of Historic Places, is now used on excursion trains over the former Tuscola and Saginaw Bay Railway, now Great Lakes Central Railroad.

History

The locomotive was built in 1941 by Lima Locomotive Works for Pere Marquette Railway (PM). PM ordered this type of locomotive in three batches from Lima: class N in 1937 (PM road numbers 1201–1215), class N-1 in 1941 (numbers 1216–1227) and class N-2 in 1944 (numbers 1228–1239). 1225 cost $200,000 to build in 1941 ($3,217,647 in current dollars). The build was complete on the December 6, 1941 and delivered to the Pere Marquette

The locomotives remained on the roster through the PM's merger into Chesapeake and Ohio Railway (C&O) in 1947; class N locomotives were renumbered to 2685–2699, class N-1 to 2650–2661, and class N-2 to 2670–2681. Part of the merger agreement, however, included the stipulation that locomotives that were acquired and fully paid for by PM would remain painted for PM after the merger. Although all the Berkshires received new numbers, only class N engines were repainted into standard C&O livery and renumbered. The majority of the class N locomotives were scrapped between 1954 and 1957, but class N-1s 1223 and 1225 were both preserved.

For the first part of its service life, 1225 was used to shuttle steel and wartime freight between Detroit, Saginaw, Flint and northern Indiana steel mills.

Retirement and restoration

Retired from service in 1951, 1225 was sent to scrap, in New Buffalo, Michigan. In 1955, Michigan State University Trustee, Forest Akers was asked by C&O Chairman Cyrus Eaton if the University would be interested in having a steam locomotive (Eaton did not want to scrap the engines but was having a hard time finding places that would accept them) so that engineering students would have a piece of real equipment to study. Forest Akers thought it a good idea and proposed the idea to University President John Hannah. John Hannah accepted the gift of the locomotive. When he told the Dean of the College of Engineering about the gift, the Dean said that Engineering was not interested in an obsolete locomotive. John Hannah then called up Dr. Rollin Baker, director of the MSU Museum and told him that he was getting a locomotive. The C&O then instructed the yardmaster at New Buffalo to send an engine to the Wyoming Shops for a cosmetic restoration and repainting with the name Chesapeake and Ohio on the side. The 1225 was the last engine in the line, i.e. easiest to get out. It had nothing to do with the number representing Christmas Day.

Nickel Plate Road 765 and Pere Marquette 1225 during Trainfestival 2009.

Baker received the gift of the locomotive in 1957 when it was brought to campus. The locomotive remained on static display near Spartan Stadium on the Michigan State campus in East Lansing, Michigan for a decade. While on display, a child by the name of Chris Van Allsburg used to stop by the locomotive on football weekends, on his way to the game with his father. He later stated that the engine was the inspiration for the story, Polar Express.

During the time that Akers was alive, till 1966, money was allocated to paint and display the engine. In 1969, a group of MSU students formed the Michigan State University Railroad Club as a railfan group. Steve Reeves, a student and part-time employee of the Museum, whose responsibility was to display the engine on football weekends, sent out a notice in the State News that the Railroad Club would be meeting. Those early meetings did not discuss the restoration of the engine. Instead, they were slide shows of engines various members had seen on trips across the US, most of which were diesels. In 1970, at the suggestion of Randy Paquette, the club investigated the possibility of restoring the locomotive to running condition and started on that goal in 1971, with Baker's permission. Baker later stated that he thought having students be occupied with restoring a locomotive was far more in keeping with his idea of the image the university should be presenting than campus protests. Dr. Breslin, the university vice president, was not so sure. After the club started removing the sheet metal and exposing a rusty boiler, Breslin sent Baker to the engine with two messages. The first was the instruction to paint the engine. (The university needs to look good, even when it is being worked on). The second message was the day the students stop working on the engine is the day the torches come out. The locomotive was safe as long as the students kept working on it. To emphasize, he had the hopper car next to the engine cut up the next week.

The students fired up the boiler in 1975 and blew the 1225's whistle for the first time in two decades. The MSU Railroad Club had looked to engine 1223 at the State Fair grounds for parts. The Michigan Railroad Club, then custodians of that engine, objected, so needed parts were fabricated. As of 2007, 1223 is preserved in a lakeside park in Grand Haven, Michigan.

In 1977, Dr. Edgar Hardin became the University Interim President. Chuck Julian, as President of the MSU Railroad Club went to his reception and made an appointment to see him. Hardin was asked about the engine's future. The Railroad Club had fired the engine and it was nearing operability. Hardin said that the University was not interested in running a locomotive and if it was, it would be run by all university employees. He said that if the Railroad Club wanted to run the engine, it should form a 501c3 corporation and then he would give the club the engine.

In that meeting, Dr. Hardin told Chuck Julian that the University was closing the Shaw Lane Power Plant and planned to pull up the tracks. If the Club wanted to be able to get the engine off the display track and onto the mainline, it needed to move it soon. Dr. Hardin gave the MSURRC permission to connect the display track to the siding and move the engine over to a part of the track near the police station, with the provision that the club provide a bond, remove the fence, stairs and all of its belongings from the display site, then tear up the track we put down along with the display track. The Club also had to repair the sidewalk that it needed to go through after it was done and generally clean up the site.

Colin Williams, of Williams Brothers Asphalt Paving Co. of Ionia, Michigan provided the Club with a surety bond, a dump truck, a front end loader and a bulldozer plus operators to run the equipment which was used to build the grade. Club members then tore up the track next to the engine and laid it down behind the engine. The engine was then rolled down the tracks. Chuck Julian, Dave Jones, an equipment operator from Williams Brothers and a group of Hmong refugees who volunteered their time, then spent the next three days with the Williams Brothers equipment restoring the site, including casting a new concrete sidewalk. Williams Brothers sent a grader from Ionia to fine grade the site after we were done with the bulk cleanup, including loading debris into the dump truck and hauling it to Ionia.

Dr. Hardin said that if the Club could find another place on campus that was suitable, it could move the engine to it. He assigned Ted Simmons and the head of the Landscape Arts Department the task of working with Chuck Julian to find a place. They visited several places. Ted Simmons was not willing to give up a siding at Power Plant 65 for the engine. The Club would need to build one if it wanted one. The Club would not be able to build a cheap structure. If the Club or later the Trust wanted a structure, it would need to be built by contractors after the university approved the design.

This set Club members to looking for a new site. Several were looked at. At the time, the Ann Arbor Railroad had gone bankrupt and the State of Michigan became the owner of its assets. Hank Londo spoke to his state representative and arranged for the new MSTRP to lease the Owosso engine shop. The engine and all of its equipment was then moved there. This was a great place to move because the engine shop had a lot of equipment that would be useful in restoring the engine.

1978-present

Pere Marquette 1225 passing through Alma, MI

The MSU Railroad Club and supporters of "Project 1225" formed the Michigan State Trust for Railway Preservation in 1978. Chuck Julian, the then president of the MSU Railroad Club, became the Trust's first President. Soon after, the MSTRP was given ownership of the 1225 by Michigan State University. The MSTRP moved 1225 to the former Ann Arbor Railroad shops complex in Owosso in 1983.

The 1225 moved under its own power in November 1985 for the first time since its retirement in 1951. The first excursion service occurred in 1988 on a trip between Owosso and Chesaning. In August 1991, 1225 along with NKP 765 pulled a 31 car excursion train during the National Railway Historical Society's annual convention in Huntington, West Virginia.

As of 2007, 1225 operates excursion trains over the Great Lakes Central Railroad (formally Tuscola and Saginaw Bay Railway) several times per year, including operations that leave Owosso and going to locations such as Alma, Clare, Mt. Pleasant, and Cadillac, Michigan. Since 2004, 1225 has hauled winter weekend excursions between Thanksgiving and the middle of December, due to copyright issues, as the "North Pole Express."

PM 1225 attended the Train Festival 2009[2] in Owosso, Michigan from July 23–26 as part of a fundraiser to raise money for 1225's upcoming 2010-2013 FRA overhaul. The national event showcased hundreds of train related items, events, and themes from around the country and some parts of the world. The 1225 was not able to haul any excursions during the Festival due to 5 of its flues failing, which occurred on July 24. The 1225 was on display during the rest of festival for people to visit the engine, chat with the crew, take photos, and explore the cab. On October 7, 2008, it was announced that NKP 765 would once again join the 1225 at Train Festival, marking the first time the two Berk's have met each other since 1991. The famous Southern Pacific 4449 Daylight locomotive also attended the festival as one of the many attending engines along with the 1225 and 765. 1225 and 765 met up twice more that year, with a photo fright in August and an excursion in October.

The flue failing was later repeated on December 5 of that year, so in January 2010, 1225 went down for its required 15 year inspection it was found that the firebox sheets had deteriorated to the point of needing replacement. That program was currently underway largely through small and large donations of funds and labor by the organizations supporters. 1225 was back in service by late November 2013. On October 20, 2013, 1225 was fired up for its first movements under its own power in 4 years.

Influence on The Polar Express

1225's blueprints were the prototype for the locomotive image, and its sounds were used in the 2004 film The Polar Express. The film was based on the Caldecott Medal winning book of the same name. The children's book was written and illustrated by Chris Van Allsburg, who grew up in Grand Rapids, Michigan, and as a child attended every home football game at Michigan State, next to which this engine was on static display. He recalls playing on this engine many times as a child saying, "I remember that train on campus,...I can't believe it's the same train! I climbed on that train. I actually stood on it."[3] Appropriately enough, the locomotive's road number is the date of Christmas, 12/25.

References

  1. "NPS Focus". National Register of Historic Places. National Park Service. Retrieved September 6, 2011.
  2. http://www.trainfestival2009.com
  3. Detroit Free Press,November 4, 2004 "Meet Chris Van Allsberg"

External links

This article is issued from Wikipedia - version of the Saturday, April 09, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.