Red Beard (nuclear weapon)

A Red Beard weapon on its bomb trolley, fitted with a bomb-carrier prior to loading into a Canberra bomber. The two fore and aft vertical plates shown with holes in them were baffles unique to the Canberra installation, designed to reduce airstream buffetting that could tear off the bomb doors. The baffles were made from 1 in (25.4 mm) thick marine plywood, drilled with numerous 1 in (25.4 mm) diameter holes. The tail-fins of the bomb are retracted.

Red Beard was the first British tactical nuclear weapon. It was carried by the English Electric Canberra and the V bombers of the Royal Air Force, and by the Blackburn Buccaneers, Sea Vixens and Supermarine Scimitars of the Royal Navy's Fleet Air Arm. Developed to Operational Requirement 1127 (OR.1127),[1] it entered service in 1962 and was withdrawn in 1971.

Design

Red Beard was an unboosted fission weapon that used a composite core (mixed core in British terminology of the time). The composite core used both weapons-grade plutonium and weapons-grade uranium-235, and was intended to minimise the risk of predetonation that was a feature of all-plutonium designs of that period with yields larger than 10 kilotons. An added benefit of the composite core was a more economical use of fissile material. The design was tested twice during the Operation Buffalo series of nuclear trials at Maralinga in Australia – first on 27 September (a 15 kt explosion, after which the resulting mushroom cloud rose to a height of 11,430 metres) and again on 22 October 1956. Although the design concept of Red Beard was similar to that of the Blue Danube warhead, an innovative means of implosion meant that its overall size could be significantly reduced.

Its measurements were 3.66 m (12 ft) in length, 0.71 m (28 in) in diameter and a weight of approximately 1,750 lb (794 kg). Two versions were produced: the Mk 1, with a yield of 15 kilotons, and the Mk 2, with a yield of 25 kt. The Mk.2 was available in two variants, the No.1 used by high-altitude bombers, and the No.2 variant that was intended for low-level delivery by the toss bombing method, and its "over-the-shoulder" variant referred to as the Low Altitude Bombing System (LABS).

Red Beard's RAF and Royal Navy service designations were:

Weighing in at approximately 794 kg (1,750 lb), Red Beard was considerably lighter than the official service designation, which was based on the original technical requirement.

A significant improvement on Red Beard's predecessor, Blue Danube, was in the provision of electrical power for the bomb firing mechanism and the radar altimeter fuzing. Blue Danube had used 6 volt lead-acid batteries that were unreliable and had to be installed at the last minute before take-off. There were also potential risks associated with "stray" electrical discharges to the firing mechanisms which might have led to accidental detonation. Red Beard used twin ram-air turbines located in the nose, from which there could be no stray discharges before bomb release. The air inlet can be seen in the extreme nose. They exhausted through "blow-out" patches in the nose sides. Until bomb release, the weapon drew electrical power from the aircraft for heating and pre-heating of the radar fuzes.

A Red Beard casing at RAF Cosford museum in 2007, shown without the 'drop' harness, and on the regular dolly.

Like Blue Danube, the body diameter at 0.71 m (28 in) was greater than was desirable relative to the overall length of 3.66 m (12 ft). To compensate for this stubbiness, and quickly stabilise the bomb after release, Red Beard was equipped with flip-out fins that were activated pneumatically, triggered by a lanyard attached to the aircraft.

As with Blue Danube, the fuzing arrangements were composed of twin radar fuzes that were activated by a barometric "gate" after release. The barometric gate ensured that the radar fuzes were switched on in the last few seconds of free-fall to a computed burst height, and this technique minimised the possibility of radar countermeasures disabling the radar fuzes. There were back-up contact and graze fuzes to ensure bomb destruction in the event of a misfire.

None of the variants were capable of being armed in flight – "In Flight Insertion" (IFI) of the fissile core. The core was inserted before take-off in a process referred to as Last Minute Loading (LML). For carrier-borne aircraft, landing with the armed weapon was forbidden and the aircraft would instead be diverted to a shore-base. Although the Royal Navy required its Sea Vixen aircraft to be type-approved for Red Beard carriage as "insurance" against delays in the development of the Blackburn Buccaneer, the Sea Vixen never deployed in the nuclear strike role. Early models were subject to severe environmental limitations, especially when loaded into Royal Navy Scimitars on exposed aircraft carrier decks in Northern waters. The Mk.2 variants were better engineered to withstand extreme conditions, and other than the yield difference, this was the main area of difference.

When the bomb was delivered by low-level toss bombing, the aircraft was almost always at a lower altitude than the burst height; so in effect, the bomb was not really "dropped", but was released and "flew" upwards in a ballistic trajectory, to detonate when it reached the required altitude.

Service

RAF stocks of Red Beard for the Canberra and V-bomber forces totalled 110. Of these, 48 were stockpiled in Cyprus to meet the UK's commitments to CENTO, 48 were stockpiled in Singapore (RAF Tengah)[2][3] to meet commitments to SEATO, and the remainder were located in the UK. Royal Navy stocks are believed, from archived declassified documents, to total 35 weapons to be shared between five aircraft carriers and shore-based supply and overhaul infrastructure. The carriers were thought (from similar sources) to each have an air-conditioned storage capacity for five Red Beard weapons.

Before the Red Beard codename was issued in 1952, it was frequently referred to in official documents as the "Javelin Bomb", because it was originally conceived as a weapon for the "thin-wing Javelin bomber", a projected derivative of the (thick wing) Gloster Javelin all-weather fighter. The designation "Target Marker Bomb" was a euphemism used to disguise the nature of the bomb, so that its dimensions and weights etc. could be circulated to aircraft and aircraft equipment designers without compromising security.

It was replaced by the WE.177 in the early 1970s.

John Dolphin

While he was working as Engineer-in-Chief at the Atomic Weapons Research Establishment John Dolphin worked on the Red Beard trigger mechanism and in 1959 requested a financial award for his work on the weapon, but was turned down. His claim was that although it was not his job to do so, he invented the device that eventually became the trigger for the bomb but the claim was refused on the grounds that it was within the scope of his duties[4]

See also

References

  1. ↑ Public Record Office, London. AIR 2/17322-e041-P01
  2. ↑ Tom, Rhodes (31 December 2000). "Britain Kept Secret Nuclear Weapons In Singapore & Cyprus". The Sunday Times (United Kingdom: News International). Archived from the original on 31 December 2000. Retrieved 1 March 2011.
  3. ↑ "Vulcans in camera: Vulcans in the far east". Retrieved 1 March 2011.
  4. ↑ "Claim made by J.R.V. Dolphin" (PDF). Retrieved 2009-04-25.

External links

This article is issued from Wikipedia - version of the Sunday, November 08, 2015. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.