Mercury-Redstone Launch Vehicle

Mercury-Redstone Launch Vehicle

Mercury-Redstone 2 launch carrying Ham (chimpanzee), Jan 31, 1961
Function Human-rated sub-orbital launch vehicle
Manufacturer Chrysler Corporation
Country of origin United States
Size
Height 25.41 m (83.38 ft)
Diameter 1.78 m (5.83 ft)
Mass 30,000 kg (66,000 lb)
Stages 1
Capacity
Payload to sub-orbital trajectory 1,800 kg (4,000 lb)
Launch history
Status Retired
Launch sites Launch Complex 5, Cape Canaveral, Florida
Total launches 6
Successes 5
Failures 1
First flight November 21, 1960
Last flight July 21, 1961
Notable payloads Mercury spacecraft
Single stage
Engines 1 Rocketdyne A-7
Thrust 350 kN (78,000 lbf)
Specific impulse 215 sec
Burn time 143.5 seconds
Fuel LOX/ethyl alcohol

The Mercury-Redstone Launch Vehicle, designed for NASA's Project Mercury, was the first American manned space booster. It was used for six sub-orbital Mercury flights from 1960–61; culminating with the launch of the first, and 11 weeks later, the second American (and the second and third humans) in space.

A member of the Redstone rocket family, it was derived from the U.S. Army's Redstone ballistic missile and the first stage of the related Jupiter-C launch vehicle; but to human-rate it, the structure and systems were modified to improve safety and reliability.

The four subsequent Mercury human spaceflights used the more powerful Atlas booster to enter low Earth orbit.

Modifications from the Redstone missile

Comparison of Mercury-Redstone (right) with Redstone missile and Jupiter-C

NASA chose the U.S. Army's Redstone liquid-fueled ballistic missile for its suborbital flights as it was the oldest one in the US fleet, having been active since 1953 and had[1] many successful test flights.[2]

The standard military Redstone lacked sufficient thrust to lift a Mercury capsule into the ballistic suborbital trajectory needed for the project;[2] however, the first stage of the Jupiter-C, which was a modified Redstone with lengthened fuel tanks, could carry enough propellant to reach the desired trajectory. Therefore, this Jupiter-C first stage was used as the starting point for the Mercury-Redstone design.[3] The Jupiter-C's engine, however, was being phased out by the Army, so to avoid potential complications such as parts shortages or design revisions, the Mercury-Redstone designers chose the Rocketdyne A-7 engine used on the latest military Redstones.[4]

The standard Redstone was fueled with a 75 percent ethyl alcohol 25 percent water solution, but the Jupiter-C first stage had used hydyne fuel, a blend of 60 percent unsymmetrical dimethylhydrazine (UDMH) and 40 percent diethylenetriamine (DETA).[5] This was a more powerful fuel than ethyl alcohol, but it was also more toxic,[6] which could be dangerous for an astronaut in a launch pad emergency.[7] Furthermore, hydyne had never been used with the new A-7 engine.[8] The Mercury-Redstone designers rejected hydyne and returned to the standard ethyl alcohol fuel.[9]

Use of alcohol created a problem with the Mercury-Redstone in that the graphite thrust vector vanes could be eroded due to the significantly longer burn time, hence NASA put out a requirement that the launch vehicles needed high quality vanes.

The most important change in making the Mercury-Redstone a suitable vehicle for an astronaut was the addition of an automatic in-flight abort sensing system.[10] In an emergency where the rocket was about to suffer a catastrophic failure, an abort would activate the launch escape system attached to the Mercury capsule, which would rapidly eject it from the booster. Either the astronaut or the ground controllers could initiate an abort manually,[11] but some potential failures during flight might lead to disaster before an abort could be manually triggered.[12]

Exploded view

The Mercury-Redstone's automatic in-flight abort sensing system solved this problem by monitoring the rocket's performance during flight. If it detected an anomaly which might threaten the astronaut, such as loss of flight control, engine thrust, or electrical power, it would automatically abort, shutting down the engine and activating the capsule's escape system.[13] The abort system could not shut off the engine until at least 30 seconds after liftoff in order to prevent a malfunctioning launch vehicle from coming down on or near the pad; during the initial 30 seconds, only the Range Safety Officer could terminate the flight.[14] Review of flight data from the more than 60 Redstone and Jupiter C launches since 1953 was used to analyze the most likely failure modes of this launch vehicle family. In the interest of simplicity, the abort sensing system had to be kept as simple as possible and only monitor parameters that were vital to booster operation. An automatic abort could be triggered by any of the following conditions, all of which could be indicative of a catastrophic launch vehicle malfunction:

Instant abort capability was important because certain failure modes such as loss of thrust upon liftoff (e.g. the third Redstone test flight in May 1954) could result in an immediate catastrophic situation. Other failure modes such as deviation from the proper flight path or a drop in engine chamber pressure during ascent did not necessarily present an immediate risk to the astronaut's safety and he could either initial a manual abort by pulling a lever in the capsule to activate the Launch Escape System or ground control could send a command to activate it.

The range safety system was modified slightly in that a three-second delay would take place between engine cutoff and missile destruct so as to give the escape tower enough time to pull the capsule away.[20]

Schematic view

The most visible difference between the Jupiter-C first stage and the Mercury-Redstone was in the section just below the Mercury capsule and above the propellant tanks. This section was known as the aft section, a term which was inherited from the military Redstone. (The actual rear end of the rocket was called the tail section.) The aft section held most of the Mercury-Redstone's electronics and instrumentation, including the guidance system, as well as the adapter for the Mercury capsule.[21] In the military Redstone and the Jupiter-C first stage, when the rocket had burned out, its lower portion, containing the rocket engine and propellant tanks, would separate from the aft section and be discarded, and the aft section, with its guidance system, would direct the top half of the rocket during its unpowered ballistic flight. However, in the Mercury-Redstone, the aft section was permanently attached to the lower portion of the rocket.[22] When the rocket had shut down, the Mercury capsule would separate from the aft section and would rely on its own guidance.

Other changes were made to improve the Mercury-Redstone's reliability. The standard Redstone's ST-80 inertial guidance system was replaced in the Mercury-Redstone with the simpler LEV-3 autopilot. The LEV-3, whose design dated back to the German V-2 missile, was not as sophisticated or as precise as the ST-80, but it was accurate enough for the Mercury mission and its simplicity made it more reliable.[23] A special instrument compartment was built in the "aft section" to hold the most important instrumentation and electronics, including the guidance system, the abort and destruct systems, the telemetry instrumentation, and the electrical power supplies. To reduce the chance of failure in this equipment, this compartment was cooled before launch and kept pressurized during flight.[24]

The fuel prevalves were deleted from the Mercury-Redstone in the interest of improved reliability, since if they closed during a launch, an abort condition could be triggered.

The space between the pressurized instrument compartment and the capsule was originally intended to hold a parachute recovery system for the rocket. When this system was abandoned, the compartment was used for ballast to improve stability in flight. Unlike the standard Redstone, the Mercury-Redstone's length and heavy payload caused it to become aerodynamically unstable later in the flight as it reached supersonic speeds, but the extra ballast delayed the onset of this effect past the most critical period of maximum aerodynamic forces, known as "max Q". After Mercury-Redstone 1A and Mercury-Redstone 2 exhibited some aerodynamic bending in the adapter section, subsequent flights were equipped with reinforcing bands. The Atlas booster used for orbital Mercury flights had also experienced this issue, but with more catastrophic results as Mercury-Atlas 1 was destroyed in-flight due to structural failure caused by excessive flexing at the point where the booster mated with the capsule adapter.[25]

In total, some 800 modifications were made to the Redstone design in the process of adapting it for the Mercury program.

Proposed parachute recovery system

The Mercury-Redstone designers originally planned for the rocket to be recovered by parachute after its separation from the Mercury capsule. This was the first significant effort to develop a recoverable launch vehicle and the first to reach the testing phase.[26]

The recovery system, at the top of the rocket, would have used two stages of parachutes. In the first stage, a single parachute, 17 feet (5.2 m) in diameter, would stabilize the rocket's fall and slow its descent. This parachute would then draw out a set of three main parachutes, each 67 feet (20 m) across. The rocket would come down in the Atlantic Ocean, to be recovered by ship.[27]

To determine the feasibility of this system, several tests were performed on full-sized Redstones, including water impact and flotation tests, and an exercise at sea in which a floating Redstone was picked up by a Navy recovery ship. All these tests showed recovery of the rocket to be workable.[28] Further development was halted, however, due to lack of funding, so the parachute system was not tested.[29]

Flights

Mercury-Redstone flights were designated with the prefix "MR-". Confusingly, the Mercury-Redstone boosters used for these flights were designated in the same way, usually with different numbers. (In photographs, this designation can sometimes be seen on the rocket's tail end.) Two rockets, MR-4 and MR-6, were never flown.[30]

Flight designation Rocket designation Launch date Comments
MR-1 MR-1 November 21, 1960 Empty capsule; launch abort; rocket shut down at liftoff due to electrical fault
MR-1A MR-3 December 19, 1960 Empty capsule
MR-2 MR-2 January 31, 1961 Carried chimpanzee Ham
MR-BD MR-5 March 24, 1961 Empty nonfunctional "boilerplate" capsule
MR-3 MR-7 May 5, 1961 Carried astronaut Alan Shepard
MR-4 MR-8 July 21, 1961 Carried astronaut Gus Grissom

Gallery

Mercury-Redstone prior to test-firing in the Redstone Test Stand at Marshall Space Flight Center, Alabama 
MSFC Mercury-Redstone Project Manager Joachim Kuettner (l) and center officials host MR-4 astronaut Gus Grissom (6th from l). 
MR-3 prelaunch activities April 21, 1961 at LC-5, Cape Canaveral, Florida 
MR-3 launch May 5, 1961 (Shepard) 
MR-4 booster erection at LC-5 
MR-4 launch July 21, 1961 (Grissom) 

Notes

  1. ↑ This New Ocean, p. 122.
  2. 1 2 The Mercury-Redstone Project, p. 2-2, 3-1.
  3. ↑ The Mercury-Redstone Project, p. 2-2, 3-1, 4-39 to 4-41.
  4. ↑ The Mercury-Redstone Project, p. 4-41, 9-5.
  5. ↑ The Mercury-Redstone Project, p. 2-2.
  6. ↑ The Mercury-Redstone Project, p. 3-2, 4-42.
  7. ↑ The Mercury-Redstone Project, p. 9-6.
  8. ↑ The Mercury-Redstone Project, p. 4-42.
  9. ↑ The Mercury-Redstone Project, p. 2-2, 3-2, 4-42.
  10. ↑ The Mercury-Redstone Project, p. 3-2, 9-3.
  11. ↑ The Mercury-Redstone Project, p. 5-10, 5-11, 9-4.
  12. ↑ The Mercury-Redstone Project, p. 5-2, 9-4.
  13. ↑ The Mercury-Redstone Project, p. 5-1, 5-2, 9-4.
  14. ↑ The Mercury-Redstone Project, p. 3-5, 5-10.
  15. ↑ The Mercury-Redstone Project, p. 5-3, 5-6, 5-17, 5-19.
  16. ↑ The Mercury-Redstone Project, p. 5-3, 5-6, 5-17, 5-23.
  17. ↑ The Mercury-Redstone Project, p. 5-3, 5-6.
  18. ↑ The Mercury-Redstone Project, p. 5-3, 5-6, 5-17.
  19. ↑ The Mercury-Redstone Project, p. 5-3, 5-6, 5-10.
  20. ↑ The Mercury-Redstone Project, p. 4-39, 4-43, 9-7.
  21. ↑ The Mercury-Redstone Project, p. 4-5, 4-6, 9-6.
  22. ↑ The Mercury-Redstone Project, p. 3-2, 4-40.
  23. ↑ The Mercury-Redstone Project, p. 3-2, 9-7.
  24. ↑ The Mercury-Redstone Project, p. 4-5, 4-41.
  25. ↑ The Mercury-Redstone Project, p. 3-2, 4-5, 4-21, 4-41.
  26. ↑ The Mercury-Redstone Project, p. 6-22, 6-23.
  27. ↑ The Mercury-Redstone Project, p. 6-29, 6-30.
  28. ↑ The Mercury-Redstone Project, p. 6-33 to 6-39.
  29. ↑ The Mercury-Redstone Project, p. 6-23.
  30. ↑ The Mercury-Redstone Project, p. 6-3, 8-1.

References

Wikimedia Commons has media related to Mercury-Redstone boosters.
This article is issued from Wikipedia - version of the Tuesday, April 19, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.