No ball

In the sport of cricket a No ball is a penalty against the fielding team, usually as a result of an illegal delivery by the bowler. For most cricket games, especially amateur games, the definition of all forms of No ball is from the MCC Laws of Cricket,[1] although youth cricket often has stricter rules on beamers, and international cricket has stricter rules on beamers, but laxer rules on bouncers.

The delivery of a No ball gives a run like a wide ball and it might give a warning under some Regulations - even a suspension if it is extreme, and an additional ball must be bowled. In addition, the number of ways in which the batsman can be given out is reduced except for run out. In Twenty20 and recently one-day cricket matches, even in some amateur cricket, a batsman receives a 'free hit' on the ball after any kind of No ball (see below). This means the batsman can freely hit the ball with no danger of being out in certain ways. No balls are not uncommon, especially in short form cricket, and fast bowlers tend to bowl them more often than spin bowlers, due to their longer run-up.

Some No balls are considered dangerous and unfair. If deliberate, the bowler may be suspended from bowling immediately, and the incident reported. If accidental, repetition will have additional consequences for the bowler and team. For repetition, and also for throwing, the bowler may be suspended from bowling in the game, reported, and required to undertake remedial work on his bowling action.

Fast short pitched bowling may also be judged dangerous and unfair by its repetition, and it is the repetition that will at some point cause the Umpire to call No ball.

What constitutes a No ball

A No ball may be called for a variety of reasons.[1] Most commonly, it is the result of a bowler breaking one of the first two rules below (a front foot No ball or back foot No ball).

Dangerous deliveries (beamers) are another common reason.[2]

If the front foot of a bowler lands inside the crease and slides outside of the crease, then it is not a No ball. If the foot lands outside the crease, it is a No ball.

An umpire will rule a No ball under any of the following conditions:

Illegal action by the bowler

Illegal action by a fielder

Umpire making the call of No ball

By default, it is the bowler's end umpire who calls and signals No ball. When judgement of ball height is required (for beamers and short balls), his colleague (the striker's end umpire) will assist him with a signal.

Either umpire may call a bowler for throwing.

The striker's end umpire calls No ball for infringement by the wicket-keeper, and for position of the fielders, but the bowler's end umpire calls No ball for fielder encroachment on the wicket.[13]

Effects of a No ball

The umpire signals a No ball by holding one arm out horizontally and shouting "No Ball", which may give the batsman some warning that the ball is an illegal delivery. Depending on the reason for the call (and hence its timing), the speed of the delivery and the batsman's reactions, the batsman may then be able to play a more aggressive shot at the delivery safe in the knowledge that he cannot be dismissed so easily by a No ball: a batsman may not be given out bowled, leg before wicket, caught, stumped or hit wicket off a No ball. (In some types of short form cricket the batsman may not be out by these methods on the following ball either - such deliveries are known as free hits. These only came into play after a foot fault No ball earlier.But the new rules introduced by ICC in June 2015 allows a free hit for any kind of No ball and not only foot fault ones) He can still be dismissed for hitting the ball twice; and either batsman can be dismissed from a No ball by run out, handling the ball, or obstructing the field.

A No ball does not count as one of the six balls in an over.

When a No ball is bowled, runs are awarded to the batting team. Under the Laws of Cricket a one run penalty is awarded. In Test cricket and One Day International cricket the award is also one run; in some domestic competitions, particularly one-day cricket competitions, the award is two runs. All such penalty runs are scored as extras and are added to the batting team's total, but are not added to any batsman's total. For scoring, No balls are considered to be the fault of the bowler (even if the infringement was committed by a fielder), and since the early 1980s, are recorded as a negative statistic in a bowler's record.

If the batsman hits the ball he may take runs as normal. These are scored as runs by the batsman, as normal. Runs may also be scored without the batsman hitting the ball, but these are recorded as No ball extras rather than byes or leg byes.

If a ball qualifies as a No ball and a wide, the umpire will call it a No ball, rather than a wide.

As stated above, the effects of No balls may be cumulative, and may reach beyond the completion of the game. No balls called under Law 42 are judged dangerous and unfair, and in common with most transgressions of Law 42 further sanctions will follow. The bowler may be prevented from bowling for the rest of the innings, may face disciplinary action by bodies governing the game, and may be required to change the way he bowls. This is also the case for a bowler called under Law 24 for throwing.

No Balls for throwing, and Law 42 No balls also have consequences for the Umpire. It is not possible within the Laws of the game to call such No balls but allow a bowler to continue to bowl without intervening first to warn, then eventually to suspend the bowler, advise him and his captain, and to report the incident after the game. Law 42 gives the umpires specific duties to ensure the safe conduct of the game.

Unlike some breaches of Law 42, a No ball only attracts the No ball penalty (e.g. one run), there are no provisions in the Law or in common regulations for five penalty runs to be awarded to the batting team, and there are no incidents when five penalty runs are awarded that would require a No ball to be called, although scenarios exist in which five penalty runs might be awarded when the ball is in play and would count in the over, were it not a No ball for the reasons given here, for example: repeated damage to the wicket by the fielding team during a No ball, or the ball hits a helmet on the ground during a No ball.

Throughout cricket history, there have been occasions when the fielding team has needed to encourage the batting team to score freely and quickly, usually when enticing them not to settle for a draw, but sometimes to satisfy some competition rule. In some such cases, especially when the end of the match requires the completion of a specified number of overs, the fielding captain has encouraged his bowler to bowl deliberate No balls by overstepping. Sometimes it has proved to be an ill-judged idea that risked both bringing the game into disrepute and losing the match, e.g.[14]

History

The 1774 Laws of Cricket state "The bowler must deliver the Ball with one foot behind the Crease even with the wicket ... If he delivers the Ball with his hinder foot over the Bowling crease the Umpire shall call no Ball (sic), though she be struck or the player is Bowled out; which he shall do without being asked, and no Person shall have any right to ask him."

In the 1788 MCC code this became "The Bowler Shall deliver the Ball with one foot behind the Bowling Crease, and within the Return Crease...if the Bowler's foot is not behind the Bowling Crease, and within the return Crease, when he delivers the Ball, [the Umpires] must, unasked, call No Ball."

The early Laws do not define any consequence of a No Ball and do not state that a 'notch' should be scored, but it is implied that the No Ball does not count in the over.

After some change in 1828, the 1835 code legitimised roundarm bowling, and prevented overarm bowling by penalty of No ball (see also 1835 English cricket season). The previous Laws did not disbar either, but had been interpreted variously by umpires reflecting custom and practice, at some cost to the careers of the bowling innovators. Further changes were made in 1845, and in 1864 bowlers were finally free to bowl overarm.[15]

Until 1957, there was no limitation on fielders behind square on the leg side. The change is often attributed to the desire to thwart bodyline, but the Bodyline Controversy was in 1933. The conservative instincts of cricket, and the intervention of World War II, may have been factors in the delay, but as the bodyline article explains, there was more than one reason for the change.

Until 1963, a No ball was called when the bowler's back foot landed over the bowling crease (which is why the bowling crease was so called), exactly as in 1774. But it was felt that the tallest fast bowlers, able to bowl legally with their front foot well over the popping crease, were gaining too great an advantage. Bowlers also became skilled in dragging their back foot. The change in the Law led to an increase in No balls: in the 1962-63 series between Australia and England there were 5 No balls; in the series between the two teams three years later there were 25.

In 1980, the main codification of No Ball Law became Law 24, with No balls also called under Law 40 (the wicket-keeper), Law 41 (the fielder) and Law 42 (Unfair Play). The new code made encroachment onto the wicket by the wicket-keeper and fielders a No Ball. In old film footage, for example of Underwood's Test in 1968, close fielders can be seen in positions that would nowadays cause a No ball to be called . Previously the fielder could stand anywhere as long as he was still, did not distract the batsman, nor interfere with his right to play the ball. Umpires would conventionally intervene if a player's shadow fell on the pitch, which is still widely treated as a distraction, but not inherently a No ball.

Prior to 1980, if the wicket keeper took the ball in front of the stumps the umpire would turn down any appeal for a stumping, but would not have called No ball.

The 1947 code explicitly provided, in Law 26 Note 4, that it was not a No ball if the bowler broke the bowler's end wicket. No such explicit words appear in the 1980 code.

The year 2000 Code was a major change, and added the No ball sanction for waist-high fast beamers, balls bouncing over head height, and balls bouncing more than twice or coming to rest in front of the striker. It also removed the judgement of intent to intimidate on fast short pitched bowling. Prior to 2000, one No Ball run penalty was only scored if no runs were scored otherwise.

In June 2015 the ICC announced that from 5 July 2015 all no balls bowled in either One Day Internationals or Twenty20 Internationals would result in a free hit. Previously, a free hit was only awarded for a front-foot No ball.[16]

See also

References

This article is issued from Wikipedia - version of the Friday, April 22, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.