2-inch Medium Mortar

This article is about the World War I mortar. For the World War II mortar, see 2-inch mortar.
2-inch Medium Mortar

British troops loading a 2 inch trench mortar with attached periscope post, World War I. This appears to be a training exercise as no fuze is visible.
Type Medium mortar
Place of origin United Kingdom
Service history
In service 1915 - 1917
Used by British Empire
Wars World War I
Production history
Designer Royal Ordnance Factory
Manufacturer various contractors
Number built 1907[1]
Specifications
Weight 105 lb (48 kg)[2]
Barrel length bore: 3 ft (0.91 m)
total: 3 ft 5 in (1.04 m)[3]
Crew 5 per mortar
25 per battery of 4[4]
Shell HE 51 lb (23 kg)[5]
Smoke
Calibre 2 inch (50.8 mm)
mortar barrel, not bomb
Rate of fire 2-3 per minute[6]
Effective firing range 100 yd (90 m) min
570 yd (520 m) max
depending on charge
Filling Amatol or Ammonal
Filling weight 12.5 lb (5.6 kg)[7]

The 2 inch Medium Trench Mortar, also known as the 2-inch Howitzer, and nicknamed the "Toffee Apple" or "Plum Pudding" mortar, was a British smooth bore muzzle loading (SBML) medium trench mortar in use in World War I from mid-1915 to mid-1917. The designation "2 inch" refers to the mortar barrel, into which only the 22-inch bomb shaft but not the bomb itself was inserted; the spherical bomb itself was actually 9 inches (230 mm) in diameter and weighed 42 lb (19 kg), hence this weapon is more comparable to a standard mortar of approximately 5-6 inch bore.

Background and predecessors

As the Western Front in France and Belgium stagnated into trench warfare in late 1914, British forces found themselves with no means of replying to the German minenwerfers (trench mortars) which were lobbing both small and large (over 100 pound) high-explosive shells into their frontline trenches from short range. British commanders requested an accurate short-range weapon which was manually portable in the trenches, could be safely used to attack enemy trenches as close as 100 yards to the British trenches, was easily concealed and projected a reasonably large explosive charge capable of damaging protected enemy positions. The British Expeditionary Force had been expected to participate only in mobile warfare and was not equipped with any mortars.

Various alternative designs for light and medium mortars were evaluated, prompted by the need to place at least some weapon into action without diverting manufacturing capacity from guns and howitzers, which weapons were given priority. Hence the emphasis was on designs for both mortar and ammunition that could be manufactured by small unsophisticated workshops unsuited to other war work:

4 inch mortar

4-inch mortar bomb at the Imperial War Museum

3.7 inch mortar

Vickers 1.57 inch mortar

The 2-inch Medium Mortar

This was designed and manufactured by the Royal Ordnance Factories in early 1915 and introduced along with the 1.57 inch mortar in March 1915. It incorporated what was known of the German prewar Krupp mortar.[11] This was the first design to meet all the requirements, after modifications to simplify manufacture; it fired a good-sized spherical cast-iron bomb of 42 pounds (total projectile weight 51 pounds with stick and fuze), considered the largest practical size for use from trenches, at ranges from 100 to 600 yards using a simple 2-inch tube as the mortar body. The mortar and ammunition could be cheaply manufactured by small unsophisticated "trade" workshops; the bomb was safely detonated by a standard No. 80 "time and percussion" artillery fuze. Drawbacks were that the steel tail was usually projected backwards towards the firer when the bomb detonated, resulting in occasional casualties and the No. 80 fuze was also required by the 18-pounder field guns which were given priority, limiting mortar ammunition supply to the front until early 1916 when a special cheap trench mortar fuze was developed.[12]

The 2-inch mortar served in limited numbers in France in 1915 from March, with early mortars and ammunition made by the Royal Ordnance Factory, with the Vickers 1.57 inch model. Mass production began with an order in August 1915 for 800 mortars from several railway workshops and agricultural machinery makers, together with an order for 675,000 bombs from numerous small firms.[13] Manufacture of the Vickers model which was twice as expensive was ended and it was withdrawn by January 1917.

It fired a spherical cast-iron bomb "the size of a football"[14] painted dirty white filled with Amatol (identified by a painted green band) or Ammonal (identified by a painted pink band)[15] attached to the end of a pipe ("stick"), hence the nicknames "Toffee Apple" and "Plum Pudding". Weights of bombs as delivered without fuzes varied. Light bombs, from 39 lb 14 oz to below 40 lb 10 oz (18.09 to 18.43 kg), were marked with a stenciled "L". Heavy bombs, above 41 lb 10 oz to 42 lb 6 oz (18.43 to 19.22 kg) were marked with a stenciled "Hv".[15] Hence the total fuzed weight with stick of 51 lb is an average.

The 2-inch designation refers to the mortar barrel's bore and the projectile stick inserted into it, not the much larger bomb itself which remained outside the barrel. It was comparable in explosive power if not range to other 4-inch mortars.

The 2-inch mortar was itself superseded by the Newton 6 inch Mortar from mid-1917 onwards. Some Australian units retained them for projecting smoke screens.

Combat use

Typical mortar pit, Mesopotamia 1917, with firing lanyard laid out. The bomb is fuzed.

Deployment

The weapon was initially operated by joint infantry and artillery detachments, eventually it became the responsibility of the Royal Field Artillery.[16] A typical infantry division was equipped with 3 batteries designated X, Y, Z, each with 4 mortars.

Use in action

Its primary use was in cutting barbed wire defenses[17] and attacking enemy front line trenches, such as in the July 1916 attack on the Somme.[14] The spherical shape and relatively low velocity brought the benefit that the bomb did not penetrate the ground before exploding. The short range was a disadvantage as it could only be used if no man's land (between the British and enemy front line) was relatively narrow. It was used to fire some White Star (50%-50% chlorine and phosgene) gas bombs during the Battle of the Somme[18] until other specialised longer range projectors became available.

Cordite charges appropriate to the required range were dropped into the barrel before the bomb was loaded. Charges and ranges:[17]

The original design for igniting the powder propellant charge involved the insertion of a standard artillery "T friction tube" into a hole near the base of the barrel. The Royal Artillery had a higher priority in receiving the already insufficient number of tubes so ignition was changed to use a Lee–Enfield bolt mechanism and chamber screwed into a socket in the barrel near the base.[3][19] A special blank rifle cartridge was loaded and fired via a lanyard from a sheltered position if possible due to the risk of bombs falling short.[17] This ignited the propellant charge and launched the bomb.

In early use it was situated in frontline trenches but this tended to attract enemy fire onto the troops manning them. Standard procedure became to locate the mortars separately from frontline trenches, in unoccupied trenches or in saps running off the frontline. This had the benefit of drawing enemy fire away from troops manning the front line.[14]

Estimated rounds required for various targets, with instantaneous percussion fuze 107:[20]

Fuze No. 107

Silencer

Provision was made in mid-1916 for attachment of the "Temple Silencer" at the muzzle,[3] intended to reduce the flash and noise generated on firing, which at the short ranges the mortar operated at was quickly noticed by the enemy and invited artillery response. This required the use of bombs with a special piston attached to the tail which was retained in the barrel by the silencer on firing, and hence sealed the muzzle after the bomb tail left the barrel. This had the major disadvantage of causing the barrel to overheat during prolonged daylight firing, and the silencer was only used at night.[6]

Use as anti-tank mines

British Mk V tank disabled by anti-tank mine, Ronssoy October 3, 1918. Unexploded bombs are visible

In Spring 1918 many of these obsolescent bombs were buried on the Western Front under metal plates as anti-tank mines in expectation of attack by German tanks. This led to some later confusion as to whether unearthed bombs were unexploded mortar projectiles ("Duds") or undetonated mines.

These minefields were inadequately documented. This caused the British problems in the closing months of the war when they had to advance again over territory they had previously abandoned and also prevented full clearance of the minefields after the war. This led to some French farmers being blown up in the 1930s when they started using tractors e.g. around Gouzeaucourt.

See also

Weapons of comparable role, performance and era

Image gallery

Notes and references

  1. ↑ Ministry of Munitions 1922, page 130-131
  2. ↑ "Appendix D. Details of Trench Mortars". Mortar=105 lb; Bed=50 lb; Elevating Stand=50 lb; Tool Box=60 lb; Periscope box=70 lb; Temple silencer=47 lb; Rifle mechanism=5 lb; Total Weight for Transport = 497 lb (225 kg)
  3. 1 2 3 Handbook of the M.L. 2-Inch Trench Mortar. Mark I. 1917, page 1
  4. ↑ "No. 351/38. Medium Trench Mortar Battery (Consisting of four mortars)". War Establishments, General, 1916. September 18, 1916.
  5. ↑ "Appendix D. Details of Trench Mortars". 51 lb was the total projectile weight as fired, including filled bomb, fuze, and stick. The stick weighed about 8 lb (3 kg), the bomb about 42 lb (19 kg).
  6. 1 2 Ministry of Munitions 1922, page 65
  7. ↑ "Appendix E. Details of Ammunition"
  8. ↑ Ministry of Munitions 1922, page 35, 36
  9. ↑ Ministry of Munitions 1922, page 62
  10. ↑ Ministry of Munitions 1922, page 35, 62, 130
  11. ↑ Ministry of Munitions 1922, page 37
  12. ↑ Ministry of Munitions 1922, page 37 - 39
  13. ↑ Ministry of Munitions 1922, page 45, 48
  14. 1 2 3 Pratt 1965
  15. 1 2 Handbook of the M.L. 2-Inch Trench Mortar, Mark I. 1917, page 13
  16. ↑ Clarke 2004, page 16
  17. 1 2 3 4 Ruffell
  18. ↑ Jones 2007, page 27
  19. ↑ Ministry of Munitions 1922, page 55
  20. ↑ Artillery in Offensive Operations, January 1917

Bibliography

External links

Wikimedia Commons has media related to 2 inch Medium Mortar.
This article is issued from Wikipedia - version of the Tuesday, March 08, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.