CGR 3rd Class 4-4-0 1889

This article is about one of several different Cape Government Railways locomotive types to be designated "3rd Class". For other CGR 3rd Class locomotives, see Cape Government Railways 3rd Class locomotives.
CGR 3rd Class 4-4-0 1889
South African Class 03 4-4-0 1889

CGR 3rd Class 4-4-0 no. 114 of 1889
Type and origin
Power type Steam
Designer Cape Government Railways
(Michael Stephens)
Builder Dübs and Company
Serial number 2486-2497, 2536-2547
Build date 1888-1889
Total produced 24
Specifications
Configuration 4-4-0 (American)
Driver 1st coupled axle
Gauge 3 ft 6 in (1,067 mm) Cape gauge
Leading dia. 28 in (711 mm)
Coupled dia. 49 in (1,245 mm)
Tender wheels 37 in (940 mm)
Wheelbase 37 ft 9 12 in (11,519 mm)
  Engine 18 ft 4 12 in (5,601 mm)
  Leading 4 ft 8 in (1,422 mm)
  Coupled 7 ft (2,134 mm)
  Tender 10 ft (3,048 mm)
Length:
  Over couplers 45 ft 8 12 in (13,932 mm)
Height 12 ft (3,658 mm)
Axle load 10 LT 12 cwt (10,770 kg)
  Leading 9 LT 13 cwt (9,805 kg)
  Coupled 10 LT 12 cwt (10,770 kg)
  Tender axle 9 LT (9,144 kg)
Adhesive weight 21 LT 4 cwt (21,540 kg)
Loco weight 30 LT 17 cwt (31,350 kg)
Tender weight 27 LT (27,430 kg)
Total weight 57 LT 17 cwt (58,780 kg)
Tender type 3-axle
Fuel type Coal
Fuel capacity 3 LT (3.0 t)
Water cap 1,950 imp gal (8,860 l)
Firebox type Round-top
  Firegrate area 13 sq ft (1.2 m2)
Boiler:
  Pitch 6 ft 1 in (1,854 mm)
  Diameter 3 ft 8 12 in (1,130 mm)
  Tube plates 10 ft 4 12 in (3,162 mm)
Boiler pressure 150 psi (1,034 kPa)
Safety valve Ramsbottom
Heating surface 763.5 sq ft (70.93 m2)
  Tubes 689 sq ft (64.0 m2)
  Firebox 74.5 sq ft (6.92 m2)
Cylinders Two
Cylinder size 15 in (381 mm) bore
22 in (559 mm) stroke
Valve gear Stephenson
Couplers Bell link-and-pin
Performance figures
Tractive effort 11,365 lbf (50.55 kN) @ 75%
Career
Operators Cape Government Railways
South African Railways
Class CGR 3rd Class, SAR Class 03
Number in class 24
Numbers 93-116
Delivered 1889
First run 1889

The Cape Government Railways 3rd Class 4-4-0 of 1889 was a South African steam locomotive from the pre-Union era in the Cape of Good Hope.

In 1889, the Cape Government Railways placed twenty-four 3rd Class tender locomotives with a 4-4-0 American type wheel arrangement in service. They were intended for passenger service on the Cape Western System.[1]

Beyond Kimberley

In addition to increasing traffic on the Western System during 1887, the planned extension of the mainline, northward from Kimberley to Vryburg, would also require an increase in the locomotive fleet. Michael Stephens, who had succeeded Hawthorne Thornton in 1885 as the Locomotive Superintendent of the Western System of the Cape Government Railways (CGR), therefore drew up detailed designs for a new 3rd Class passenger locomotive for the Western System.[1][2]

Manufacturer

Michael Stephens

An order for twenty-four of these locomotives was placed with Dübs and Company in Glasgow. The locomotives, built in two batches of twelve, were delivered early in 1889 and were numbered in the range from 93 to 116.[1][2][3]

These were the first stock locomotives to be built in quantity to detailed designs prepared in the Cape of Good Hope, following the experimental 3rd Class 4-4-0 and 4th Class 4-6-0TT locomotives of 1884. With a boiler pressure of 150 pounds per square inch (1,034 kilopascals), they were also the first South African engines to use Ramsbottom safety valves instead of the older Salter spring balance valves. The overall design resulted in an attractive locomotive, which reflected credit on the designer and the Salt River drawing office.[1][2]

Service

Cape Government Railways

The locomotives were, at the time, modern and up to date with latest practices and were possibly the most efficient engines in the country. As was usual practice with passenger locomotives on the CGR, they were painted green and had polished brass domes. They were placed in service on the easier sections of the Western System and were used on all types of traffic. On the section between Beaufort West and Kimberley, they worked passenger trains successfully, in spite of the poor quality coal from the colliery at Viljoensdrif, thanks to their more liberally-proportioned boilers.[1][2]

During the Second Boer War from 1899 to 1902, at least one of these locomotives, no. 108, had armour plating fitted to protect the engine and crew from Boer small-arms fire. A photograph below shows no. 108 in armour plating, derailed at Kraaipan on 12 October 1899.

By 1904, six of the locomotives were transferred to the Midland System and renumbered in the range from 405 to 410. Here, they were employed on the line between Port Elizabeth and Uitenhage.[1][2]

South African Railways

When the Union of South Africa was established on 31 May 1910, the three Colonial government railways (CGR, Natal Government Railways and Central South African Railways) were united under a single administration to control and administer the railways, ports and harbours of the Union. Although the South African Railways and Harbours came into existence in 1910, the actual classification and renumbering of all the rolling stock of the three constituent railways required careful planning and was only implemented with effect from 1 January 1912.[4][5]

All twenty-four locomotives survived to be taken onto the SAR roster in 1912. Since they were considered obsolete by then, they were designated Class 03 and renumbered, by having the numeral "0" prefixed to their existing numbers. In SAR service, they continued to work on the Uitenhage line on the Midland System and on shunting and light duties on the Western System. Some of them survived until 1923.[2][3][5]

Works numbers

The works numbers, original numbers and renumberings of the Cape 3rd Class of 1889 are listed in the table.[1][5]

Illustration

The main picture shows no. 114 near Bulawayo in Southern Rhodesia, c. 1900, working on the line from the Cape of Good Hope through the Bechuanaland Protectorate.

References

  1. 1 2 3 4 5 6 7 Holland, D.F. (1971). Steam Locomotives of the South African Railways, Volume 1: 1859-1910 (1st ed.). Newton Abbott, Devon: David & Charles. pp. 37–39. ISBN 978-0-7153-5382-0.
  2. 1 2 3 4 5 6 Espitalier, T.J.; Day, W.A.J. (1943). The Locomotive in South Africa - A Brief History of Railway Development. Chapter II - The Cape Government Railways (Continued). South African Railways and Harbours Magazine, December 1943. pp. 883-886.
  3. 1 2 Paxton, Leith; Bourne, David (1985). Locomotives of the South African Railways (1st ed.). Cape Town: Struik. p. 17. ISBN 0869772112.
  4. The South African Railways - Historical Survey. Editor George Hart, Publisher Bill Hart, Sponsored by Dorbyl Ltd., Published c. 1978, p. 25.
  5. 1 2 3 Classification of S.A.R. Engines with Renumbering Lists, issued by the Chief Mechanical Engineer's Office, Pretoria, January 1912, p. 25. (Reprinted in April 1987 by SATS Museum, R.3125-6/9/11-1000)
Wikimedia Commons has media related to CGR 3rd Class 4-4-0 1889.
This article is issued from Wikipedia - version of the Wednesday, May 04, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.