South African Class MF 2-6-6-2

CSAR Mallet 2-6-6-2 Superheated
South African Class MF 2-6-6-2

SAR no. 1620, ex CSAR no. 1016, c. 1920
Type and origin
♠ Locomotive numbers 1619-1627
Locomotive numbers 1629-1633
Power type Steam
Designer American Locomotive Company
Builder American Locomotive Company
Serial number 49115-49123, 50039-50043
Model CSAR Mallet
Build date 1910-1911
Total produced 14
Specifications
Configuration 2-6-6-2 (Prairie Mallet)
Driver 3rd & 6th coupled axles
Gauge 3 ft 6 in (1,067 mm) Cape gauge
Leading dia. 28 12 in (724 mm)
Coupled dia. 46 in (1,168 mm)
Trailing dia. 28 12 in (724 mm)
Tender wheels ♠ 34 in (864 mm)
30 in (762 mm)
Wheelbase ♠ 65 ft 6 in (19,964 mm)
  Engine 40 ft 3 in (12,268 mm)
  Coupled 8 ft 4 in (2,540 mm) per unit
  Tender ♠ 17 ft 11 in (5,461 mm)
17 ft 10 in (5,436 mm)
  Tender bogie ♠ 4 ft 7 in (1,397 mm)
5 ft 10 in (1,778 mm)
Length:
  Over couplers ♠ 73 ft 7 14 in (22,435 mm)
Height 12 ft 10 38 in (3,921 mm)
Frame type Bar
Axle load 15 LT 3 cwt (15,390 kg)
  Leading 7 LT 12 cwt (7,722 kg)
  1st coupled 14 LT 14 cwt (14,940 kg)
  2nd coupled 14 LT 3 cwt (14,380 kg)
  3rd coupled 13 LT 19 cwt (14,170 kg)
  4th coupled 15 LT 3 cwt (15,390 kg)
  5th coupled 14 LT 15 cwt (14,990 kg)
  6th coupled 14 LT 15 cwt (14,990 kg)
  Trailing 7 LT 12 cwt (7,722 kg)
  Tender bogie ♠ 27 LT 12 cwt (28,040 kg) each
25 LT 10 cwt (25,910 kg) av.
  Tender axle ♠ 13 LT 16 cwt (14,020 kg)
12 LT 15 cwt (12,950 kg) av.
Adhesive weight 87 LT 9 cwt (88,850 kg)
Loco weight 102 LT 13 cwt (104,300 kg)
Tender weight ♠ 55 LT 4 cwt (56,090 kg)
51 LT (51,820 kg)
Total weight ♠ 157 LT 17 cwt (160,400 kg)
153 LT 13 cwt (156,100 kg)
Tender typeXS (2-axle bogie)
XM4 (2-axle bogie)
Fuel type Coal
Fuel capacity 10 LT (10.2 t)
Water cap ♠ 5,000 imp gal (22,700 l)
4,000 imp gal (18,200 l)
Firebox type Round-top
  Firegrate area 49.5 sq ft (4.60 m2)
Boiler:
  Pitch 7 ft 9 in (2,362 mm)
  Diameter 6 ft 18 in (1,832 mm)
  Tube plates 19 ft 10 18 in (6,048 mm)
  Small tubes 151: 2 14 in (57 mm)
  Large tubes 25: 5 38 in (137 mm)
Boiler pressure 200 psi (1,379 kPa)
Safety valve Ramsbottom
Heating surface 2,615.6 sq ft (243.00 m2)
  Tubes 2,459.6 sq ft (228.50 m2)
  Firebox 156 sq ft (14.5 m2)
Superheater:
  Type Schmidt
  Heating area 559 sq ft (51.9 m2)
Cylinders Four
High-pressure cylinder 18 in (457 mm) bore
26 in (660 mm) stroke
Low-pressure cylinder 28 12 in (724 mm) bore
26 in (660 mm) stroke
Valve gear Walschaerts
Couplers Bell link-and-pin
Performance figures
Tractive effort 45,900 lbf (204 kN) @ 50%
Career
Operators Central South African Railways
South African Railways
Class Class MF
Number in class 14
Numbers CSAR 1015-1023
SAR 1619-1627, 1629-1633
Delivered 1911
First run 1911
Withdrawn 1939

The South African Railways Class MF 2-6-6-2 of 1911 was a steam locomotive from the pre-Union era in the Transvaal.

In 1911, the Central South African Railways placed nine Mallet articulated compound steam locomotives with a 2-6-6-2 wheel arrangement in service. In 1912, when they were assimilated into the South African Railways, they were renumbered and designated Class MF. Five more of these locomotives were delivered in November 1911 and were numbered directly onto the South African Railways roster.[1][2][3][4]

Manufacturer

Nine Mallet articulated compound steam locomotives, which were delivered to the Central South African Railways (CSAR) in 1911, were built by the American Locomotive Company (ALCO) in 1910 and 1911. They were erected at the Durban workshops in March 1911 and were very similar to the experimental Class MD which had been delivered in 1910, except that the new locomotives were equipped with Schmidt superheaters. The engines had Walschaerts valve gear and Type XS tenders, with a coal capacity of 10 long tons (10.2 tonnes) and a water capacity of 5,000 imperial gallons (22,700 litres). They were numbered in the range from 1015 to 1023.[1][2][3][4][5]

Compound expansion

In a compound locomotive, steam is expanded in phases. After being expanded in a high pressure cylinder and having then lost pressure and given up part of its heat, it is exhausted into a larger volume low pressure cylinder for secondary expansion, after which it is exhausted through the smokebox. By comparison, in the more usual arrangement of simple expansion (simplex), steam is expanded just once in any one cylinder before being exhausted through the smokebox.[1][6]

In the compound Mallet locomotive, the rear set of coupled wheels are driven by the smaller high pressure cylinders, which are fed steam from the steam dome, via the superheater. Their spent steam is then fed to the larger low pressure cylinders, which drive the front set of coupled wheels.[1][3]

Characteristics

The most noticeable external difference from the experimental Class MD engine was the arrangement of the main steam pipes, necessitated by the superheater. Instead of being led vertically down from the dome directly to the high pressure cylinders, an internal pipe was taken from the regulator valve in the dome to the superheater in the smokebox, from where it was brought back to the high pressure cylinders by external steam pipes, arranged under the running boards.[2]

South African Railways

When the Union of South Africa was established on 31 May 1910, the three Colonial government railways (Cape Government Railways, Natal Government Railways and CSAR) were united under a single administration to control and administer the railways, ports and harbours of the Union. Although the South African Railways and Harbours came into existence in 1910, with Sir William Hoy appointed as its first General Manager, the actual classification and renumbering of all the rolling stock of the three constituent railways required careful planning and was only implemented with effect from 1 January 1912.[4][7]

In 1912, these locomotives were renumbered in the range from 1619 to 1627 and designated Class MF on the South African Railways (SAR). Five more of the type had been delivered from ALCO in November 1911, but these were numbered in the range from 1629 to 1633, directly onto the SAR roster, marking the introduction of the SAR renumbering scheme under the Union programme. These locomotives were delivered with smaller Type XM4 tenders, with the same coal capacity as the Type XS tenders of the first nine engines, but a smaller water capacity of 4,000 imperial gallons (18,200 litres).[1][3][4][8]

The new locomotives were erected in the workshops in Pretoria, rather than Durban. The erection of engines away from ports was an innovation which was probably the outcome of experience gained with the Class MD, which had been erected at Durban. While the locomotive was brought to the Transvaal, difficulty was experienced at Drummond and Laing's Nek, where the drain angles on the cab roof struck the sides of the tunnels.[8]

Service

The Class MF joined the experimental Class MD on the coal traffic line between Witbank and Germiston. They were acquired to improve the traffic flow on this line, with its ruling gradient of one in one hundred (1%), where the increase of traffic and the resultant congestion was causing considerable delays en route, which led to excessive hours of duty being imposed on crews. When the Mallets replaced the existing Class 11 locomotives on this line, train loads could be increased from 900 long tons (914 tonnes) to 1,600 long tons (1,626 tonnes).[1][3]

The Mallets proved to be capable of handling the heavy coal loads. In May 1914, Class MF no. 1620 was used in a test run from Witbank to Germiston, hauling fifty-five bogie wagons with an all-up weight of 1,626 long tons (1,652 tonnes). The 80 miles (129 kilometres) journey was accomplished in seven hours, which included several stops.[1][8]

Modification to simplex

In 1923, engine no. 1620 was converted to a simplex locomotive in the Salvokop shops in Pretoria. Five more, numbers 1621 to 1623, 1631 and 1632, were also converted to simplex locomotives in 1925. Three of these, numbers 1620, 1631 and 1632, were then transferred to East London, where more powerful locomotives were needed, since the mainline had a heavy gradient of one in forty (2½%) which started right at the end of the East London departing platform, making it an extremely difficult section. They appear to have not been up to the task in the Eastern Cape, however, since by 1926 they were observed there, staged out of service.[1][2][3][8]

They were all withdrawn from service and scrapped by 1939.[3]

Illustration

The pictures serve to illustrate the compound and simplex versions of the Class MF.

References

  1. 1 2 3 4 5 6 7 8 Holland, D.F. (1972). Steam Locomotives of the South African Railways, Volume 2: 1910-1955 (1st ed.). Newton Abbott, Devon: David & Charles. pp. 16–19, 140. ISBN 978-0-7153-5427-8.
  2. 1 2 3 4 Espitalier, T.J.; Day, W.A.J. (1945). The Locomotive in South Africa - A Brief History of Railway Development. Chapter VII - South African Railways. South African Railways and Harbours Magazine, April 1945. pp. 275-276.
  3. 1 2 3 4 5 6 7 Paxton, Leith; Bourne, David (1985). Locomotives of the South African Railways (1st ed.). Cape Town: Struik. pp. 86–87. ISBN 0869772112.
  4. 1 2 3 4 Classification of S.A.R. Engines with Renumbering Lists, issued by the Chief Mechanical Engineer’s Office, Pretoria, January 1912, pp. 9, 12, 16, 47 (Reprinted in April 1987 by SATS Museum, R.3125-6/9/11-1000)
  5. Holland, D.F. (1971). Steam Locomotives of the South African Railways, Volume 1: 1859-1910 (1st ed.). Newton Abbott, Devon: David & Charles. pp. 54, 56. ISBN 978-0-7153-5382-0.
  6. Compounding Steam Engines
  7. The South African Railways - Historical Survey. Editor George Hart, Publisher Bill Hart, Sponsored by Dorbyl Ltd., Published c. 1978, p. 25.
  8. 1 2 3 4 Espitalier, T.J.; Day, W.A.J. (1945). The Locomotive in South Africa - A Brief History of Railway Development. Chapter VII - South African Railways (Continued). South African Railways and Harbours Magazine, May 1945. p. 347.
Wikimedia Commons has media related to South African Class MF (2-6-6-2).
This article is issued from Wikipedia - version of the Saturday, April 02, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.