NZASM 13 Tonner 0-4-0T
13 Tonner, c. 1889 | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
The NZASM 13 Tonner 0-4-0T of 1889 was a South African steam locomotive from the pre-Union era in the Transvaal.
In 1889, the Nederlandsche-Zuid-Afrikaansche Spoorweg-Maatschappij acquired a single locomotive, very similar to its 14 Tonner locomotives and built by the same manufacturer, but with a smaller water and coal capacity. Since the railway classified its locomotives according to their weight, this well-and-side-tank locomotive would have been known as the 13 Tonner.[1]
The Randtram line
As a result of the rapid development of the goldfields on the Witwatersrand in the 1880s and the demand for coal by the growing industry, the Volksraad of the Zuid-Afrikaansche Republiek (ZAR), also known as the Transvaal Republic, granted a concession to the Nederlandsche-Zuid-Afrikaansche Spoorwegmaatschappij (Netherlands-South African Railway Company, NZASM) on 20 July 1888, to construct a 16 miles (26 kilometres) long railway line from Johannesburg to Boksburg. The line, which was opened on 17 March 1890, became known as the "Randtram" line, even though it was actually a railway in every aspect and not singularly dedicated to tram traffic. This was the first working railway line in the Transvaal.[1][2][3]
Manufacturer
In 1889, six small 0-4-0T tank locomotives were delivered to the NZASM by the German engineering firm and locomotive builder Maschinenfabrik Esslingen, owned by Emil Kessler. Five of these were the NZASM 14 Tonners. The sixth, the sole 13 Tonner, was also a well-and-side-tank locomotive with a 0-4-0T wheel arrangement and was similar to, but lighter than the 14 Tonner.[1]
Characteristics
The engine's cylinders were arranged outside the plate frames. The "D" type slide valves, mounted above the cylinders, were arranged at an incline and were actuated by Allan straight link motion. In this type of valve gear, the valve rod and the expansion link are respectively connected to opposing arms on the reversing shaft, so that partial rotation of the shaft moves the link and the die block in opposite directions.[1]
Apart from the side-tanks, the locomotive also had a well-tank between the frames under the boiler barrel. The dome was on the front section of the boiler and the regulator valve was arranged in the smokebox.[1]
Comparison
Compared to the 14 Tonner, the 13 Tonner differed in at least three respects, judging from photographs. The 13 Tonner had a much narrower coal bunker and a shorter chimney. The side-tanks were also much smaller, reaching only as far forward as aft of the boiler-mounted sandbox dome.[1][3]
On the 14 Tonner, the side-tanks on each side are in two parts and reach as far forward as aft of the steam dome. In addition, the 14 Tonner had two small panels in the side of the rear tank on its right side. The 13 Tonner had no such panels.[1][3]
Illustration
The main picture of the 13 Tonner and those following of the 14 Tonner, serve to illustrate the differences between the 13 Tonner and the slightly larger 14 Tonner locomotive.
-
14 Tonner, without cowcatchers, c. 1900
-
14 Tonner, Outeniqua Transport Museum, 15 April 2013
References
- 1 2 3 4 5 6 7 Espitalier, T.J.; Day, W.A.J. (1944). The Locomotive in South Africa - A Brief History of Railway Development. Chapter IV - The N.Z.A.S.M.. South African Railways and Harbours Magazine, October 1944. pp. 761-764.
- ↑ Holland, D.F. (1971). Steam Locomotives of the South African Railways, Volume 1: 1859-1910 (1st ed.). Newton Abbott, Devon: David & Charles. pp. 109–110. ISBN 978-0-7153-5382-0.
- 1 2 3 The South African Railways - Historical Survey. Editor George Hart, Publisher Bill Hart, Sponsored by Dorbyl Ltd., Published c. 1978, p. 19.
|