South African Class 17 4-8-0TT

South African Class 17 4-8-0TT

SAR Class 17 no. 1432, circa 1930
Type and origin
Power type Steam
Designer Natal Government Railways
(William Milne)
Builder Dübs and Company
South African Railways
Serial number See table
Model SAR Class 17
Build date 1926-1929
Total produced 21
Specifications
Configuration 4-8-0TT (Mastodon)
Driver 2nd coupled axle
Gauge 3 ft 6 in (1,067 mm) Cape gauge
Leading dia. 25 34 in (654 mm)
Coupled dia. 39 in (991 mm)
Tender wheels 34 in (864 mm)
Wheelbase 44 ft 11 12 in (13,703 mm)
  Engine 19 ft 9 in (6,020 mm)
  Leading 5 ft (1,524 mm)
  Coupled 11 ft (3,353 mm)
  Tender 16 ft 1 in (4,902 mm)
  Tender bogie 4 ft 7 in (1,397 mm)
Length:
  Over couplers 52 ft 2 12 in (15,913 mm)
Height 12 ft 2 12 in (3,721 mm)
Axle load 8 LT 10 cwt (8,636 kg)
  Leading 9 LT 6 cwt (9,449 kg)
  1st coupled 8 LT 2 cwt (8,230 kg)
  2nd coupled 8 LT 10 cwt (8,636 kg)
  3rd coupled 8 LT 3 cwt (8,281 kg)
  4th coupled 8 LT 3 cwt (8,281 kg)
  Tender bogie Bogie 1: 16 LT 15 cwt (17,020 kg)
Bogie 2: 17 LT 18 cwt (18,190 kg)
Adhesive weight 32 LT 18 cwt (33,430 kg)
Loco weight 42 LT 4 cwt (42,880 kg)
Tender weight 34 LT 13 cwt (35,210 kg) w/o
Total weight 76 LT 17 cwt (78,080 kg) w/o
Tender type 2-axle bogies or 3-axle
Fuel type Coal
Fuel capacity 5 LT 10 cwt (5.6 t)
Water cap 1,358 imp gal (6,170 l) engine
Tender cap 2,600 imp gal (12,000 l) tender
Firebox type Belpaire
  Firegrate area 24 sq ft (2.2 m2)
Boiler:
  Pitch 7 ft (2,134 mm)
  Diameter 3 ft 10 34 in (1,187 mm)
  Tube plates 10 ft 10 18 in (3,305 mm)
  Small tubes 187: 1 34 in (44 mm)
Boiler pressure 160 psi (1,103 kPa)
Safety valve Ramsbottom
Heating surface 992 sq ft (92.2 m2)
  Tubes 930 sq ft (86 m2)
  Firebox 62 sq ft (5.8 m2)
Cylinders Two
Cylinder size 17 in (432 mm) bore
21 in (533 mm) stroke
Valve gear Stephenson
Couplers Bell link-and-pin
Performance figures
Tractive effort 18,670 lbf (83.0 kN) @ 75%
Career
Operators South African Railways
Class Class 17
Number in class 21
Numbers 1415–1435
Delivered 1926-1929
First run 1926
Withdrawn 1961
The leading coupled axle had flangeless wheels

The South African Railways Class 17 4-8-0TT of 1926 is a steam locomotive from the pre-Union era in the Natal Colony.

Between 1926 and 1929, to address a shortage of suitable shunting locomotives, the South African Railways rebuilt twenty-one Class A 4-8-2T Mountain type tank steam locomotives to Class 17 4-8-0TT Mastodon type tank-and-tender locomotives.[1][2][3]

Manufacturers

The Natal Government Railways (NGR) Class D 4-8-2T Mountain type tank locomotive was designed by William Milne, the locomotive superintendent of the NGR from 1877 to 1896, and built by Dübs and Company. One hundred of these locomotives were delivered in ten batches by Dübs between 1888 and 1899, and in 1915 another two were built from spare parts by the South African Railways (SAR) in their Durban shops.[1][4]

Belpaire firebox

Beginning in 1905, these NGR Class D locomotives, originally known on the NGR as the "Dübs A", were gradually reboilered and fitted with Belpaire fireboxes with wider firegrates. The unmodified locomotives were then designated NGR Class D1, while the modified locomotives with Belpaire fireboxes were designated Class D2. In SAR service, the NGR Class D1 and D2 were both designated Class A in 1912, while the modified locomotives were referred to as Class A Belpaire.[1][4][5]

Rebuilding

NGR Class D1 no. 105, c. 1900

When a shortage of suitable shunting locomotives developed in the 1920s, as a result of increasing traffic throughout the country and particularly on the Witwaters­rand, the SAR modified twenty-one of the Class A Belpaire 4-8-2T Mountain type tank loco­mo­tives. The modifications were done between 1926 and 1929 and consisted of the removal of their trailing bissel bogies and coal bunkers, the shortening of their main frames and the addition of tenders to increase their coal and water capacity, thereby converting them to 4-8-0TT Mastodon type tank-and-tender locomotives.[1][6][7]

Tenders from various scrapped locomotive types were used. The tender depicted in the main picture is a three-axle tender, while the official SAR locomotive diagram depicts a tender with four axles on two bogies. The bogie tenders which were used, were similar to those originally used with the Class 7E.[1][2][3]

Service

These twenty-one rebuilt 4-8-2TT locomotives were reclassified to Class 17 and renumbered in the range from 1415 to 1435. They were employed as shunting engines around Durban and Port Elizabeth and were withdrawn from service by 1961, more than seventy years after the first one was built.[3][7]

In November 1953, two of these locomotives, numbers 1423 and 1431, were purchased by the Zambezi Saw Mills Company, for use on their Livingstone-Mulobezi logging railway in Northern Rhodesia. They were scrapped between 1961 and 1963.

Works numbers and renumbering

References

  1. 1 2 3 4 5 Espitalier, T.J.; Day, W.A.J. (1944). The Locomotive in South Africa - A Brief History of Railway Development. Chapter III - Natal Government Railways. (Continued). South African Railways and Harbours Magazine, June 1944. p. 423.
  2. 1 2 South African Railways and Harbours Locomotive Diagram Book, 2’0” & 3’6” Gauge Steam Locomotives, 15 August 1941, pp. 21 & 21A, as amended
  3. 1 2 3 Paxton, Leith; Bourne, David (1985). Locomotives of the South African Railways (1st ed.). Cape Town: Struik. pp. 10–11, 26–27, 68. ISBN 0869772112.
  4. 1 2 Holland, D.F. (1971). Steam Locomotives of the South African Railways, Volume 1: 1859-1910 (1st ed.). Newton Abbott, Devon: David & Charles. pp. 90–91. ISBN 978-0-7153-5382-0.
  5. The Railway Report for year ending 31 Dec. 1908, Natal Government Railways, p. 39, par 14.
  6. Whyte notation suffixes
  7. 1 2 Holland, D.F. (1972). Steam Locomotives of the South African Railways, Volume 2: 1910-1955 (1st ed.). Newton Abbott, Devon: David & Charles. p. 63. ISBN 978-0-7153-5427-8.
Wikimedia Commons has media related to South African Class 17 (4-8-0TT).
This article is issued from Wikipedia - version of the Friday, February 26, 2016. The text is available under the Creative Commons Attribution/Share Alike but additional terms may apply for the media files.